Effects of elevated temperature exposure on heating characteristics, spalling, and residual properties of high performance concrete
Tóm tắt
Từ khóa
Tài liệu tham khảo
Schneider, U., ‘Properties of Materials at High Temperatures— Concrete’, RILEM—Committee 44—PHT University of Kassel, Kassel, June 1985.
Phan, L. T., Carino, N. J., Duthinh, D. and Garboczi, E., ‘NIST International Workshop on Fire Performance of High Strength Concrete’, NIST, Gaithersburg, MD, February 13–14, 1997—Proceedings, NIST SP 919, Gaithersburg, Maryland, September 1997.
Castillo, C. and Durrani, A. J., ‘Effect of transient high temperature on high-strength concrete’,ACI Materials Journal 87 (1) (1990) 47–53.
Hert, K., ‘Danish investigations on silica fume concretes at elevated temperatures’, Proceedings of ACI 1991 Spring Convention, March 17–21.
Diederichs, U., Jumppanen, U. M. and Penttala, V. ‘Behavior of high strength concrete at high temperatures’, Helsinki University of Technology, Department of Structural Engineering, Report no. 92, 1989.
Hammer, T. A., ‘High-strength concrete phase 3: Compressive strength and E-modulus at elevated temperatures’, SP6 Fire Resistance, Report 6.1, SINTEF Structures and Concrete, February 1995.
Sullivan, P. J. E. and Shanshar, R., ‘Performance of concrete at elevated temperatures (as measured by the reduction in compressive strength)’,Fire Technology 28 (3) (Aug 1992) 240–250.
Abrams, M. S., ‘Compressive strength of concrete at temperatures to 1600F’, ACI SP 25, Temperature and Concrete, Detroit, Michigan, 1971.
Morita, T., Saito, H. and Kumagai, H., ‘Residual mechanical properties of high strength concrete members exposed to high temperature—Part 1. Test on material properties’, Summaries of Technical Papers of Annual Meeting, Architectural Institute of Japan, Niigata, August 1992.
Furumura, F., Abe, T. and Shinohara, Y., ‘Mechanical properties of high strength concrete at high temperatures’, Proceedings of the Fourth Weimar Workshop on High Performance Concrete: Material Properties and Design, Weimar, Germany, October 4th and 5th, 1995, 237–254.
Felicetti, R., Gambarova, P. G. Rosati, G. P., Corsi, F. and Giannuzzi, G., ‘Residual mechanical properties of HSC subjected to high-temperature cycles’, Proceedings, 4th International Symposium on Utilization of High-Strength/High-Performance Concrete, Paris, France, 1996, 579–588.
Noumowe, A. N., Clastres, P., Debicki, G. and Costaz, J.-L., ‘Thermal stresses and water vapor pressure of high performance concrete at high temperature’, Proceedings, 4th International Symposium on Utilization of High-Strength/High-Performance Concrete, Paris, France, 1996.
Phan, L. T., ‘Fire performance of High-Strength Concrete: A Report of the State-of-the-Art’, NISTIR 5934, National Institute of Standards and Technology, Gaithersburg, Maryland, December 1996.