Effects of activator content on properties, mineralogy, hydration and microstructure of alkali-activated materials synthesized from calcium silicate slag and ground granulated blast furnace slag
Tóm tắt
Từ khóa
Tài liệu tham khảo
Yao, 2014, A review of the alumina recovery from coal fly ash, with a focus in China, Fuel, 120, 74, 10.1016/j.fuel.2013.12.003
Ding, 2017, Research and industrialization progress of recovering alumina from fly ash: a concise review, Waste Manag., 60, 375, 10.1016/j.wasman.2016.06.009
Zhang, 2016, Hydration characteristics and environmental friendly performance of a cementitious material composed of calcium silicate slag, J. Hazard Mater., 306, 67, 10.1016/j.jhazmat.2015.11.055
Yan, 2020, The cementitious composites using calcium silicate slag as partial cement, J. Clean. Prod., 256, 10.1016/j.jclepro.2020.120514
Mehta, 2016, An overview of geopolymers derived from industrial by-products, Construct. Build. Mater., 127, 183, 10.1016/j.conbuildmat.2016.09.136
Wu, 2019, Geopolymer, green alkali activated cementitious material: synthesis, applications and challenges, Construct. Build. Mater., 224, 930, 10.1016/j.conbuildmat.2019.07.112
Ashraf, 2018, Microstructure of chemically activated gamma-dicalcium silicate paste, Construct. Build. Mater., 185, 617, 10.1016/j.conbuildmat.2018.07.030
Shi, 2015, Preparation of alkali-activated cementitious materials with calcium silicate slag (in Chinese), Bull. Chin. Ceram. Soc., 34, 2334
Shi, 2017, Effects of curing condition on properties, reaction products and microstructure of calcium silicate slag-based alkali-activated cementitious materials (in Chinese), J. Chin. Ceram. Soc., 45, 1080, 10.1111/jace.14683
Shi, 2006
Li, 2010, A review: the comparison between alkali-activated slag (Si+Ca) and metakaolin (Si+Al) cements, Cement Concr. Res., 40, 1341, 10.1016/j.cemconres.2010.03.020
Huang, 2020, Influence of NaOH content on the alkali conversion mechanism in MSWI bottom ash alkali-activated mortars, Construct. Build. Mater., 248, 10.1016/j.conbuildmat.2020.118582
Fang, 2020, Effect of alkali contents, moduli and curing time on engineering properties of alkali activated slag, Construct. Build. Mater., 249, 10.1016/j.conbuildmat.2020.118799
Rashad, 2016, Influence of the activator concentration of sodium silicate on the thermal properties of alkali-activated slag pastes, Construct. Build. Mater., 102, 811, 10.1016/j.conbuildmat.2015.11.023
Shi, 2018, Effect of alkali dosage and silicate modulus on carbonation of alkali-activated slag mortars, Cement Concr. Res., 113, 55, 10.1016/j.cemconres.2018.07.005
GB/T 12957-2005, 2005
GB/T 2847-2005, 2005
GB/T 1346-2011, 2011
GB/T 17671-1999, 1999
GB/T 2419-2005, 2005
Zhang, 2011, Comparison of methods for arresting hydration of cement, Cement Concr. Res., 41, 1024, 10.1016/j.cemconres.2011.06.003
Bondar, 2018, Alkali activated slag concretes designed for a desired slump, strength and chloride diffusivity, Construct. Build. Mater., 190, 191, 10.1016/j.conbuildmat.2018.09.124
Allahverdi, 2010, Influence of sodium oxide on properties of fresh and hardened paste of alkali-activated blast-furnace slag, Int. J. Civ. Eng., 8, 304
Bernal, 2011, Evolution of binder structure in sodium silicate-activated slag-metakaolin blends, Cement Concr. Compos., 33, 46, 10.1016/j.cemconcomp.2010.09.004
Bernal, 2012, Accelerated carbonation testing of alkali-activated binders significantly underestimates service life: the role of pore solution chemistry, Cement Concr. Res., 42, 1317, 10.1016/j.cemconres.2012.07.002
Fernandez Bertos, 2004, A review of accelerated carbonation technology in the treatment of cement-based materials and sequestration of CO2, J. Hazard Mater., 112, 193, 10.1016/j.jhazmat.2004.04.019
Jang, 2016, Review on recent advances in CO2 utilization and sequestration technologies in cement-based materials, Construct. Build. Mater., 127, 762, 10.1016/j.conbuildmat.2016.10.017
Ghosh, 1974, Absorption and reflection infra-red spectra of major cement minerals, clinkers and cements, J. Mater. Sci., 9, 1577, 10.1007/BF00540754
Kriskova, 2014, Influence of mechanical and chemical activation on the hydraulic properties of gamma dicalcium silicate, Cement Concr. Res., 55, 59, 10.1016/j.cemconres.2013.10.004
Sánchez-Herrero, 2016, Alkaline hydration of C2S and C3S, J. Am. Ceram. Soc., 99, 604, 10.1111/jace.13985
El Fami, 2020, Improvement of hydraulic and mechanical properties of dicalcium silicate by alkaline activation, Construct. Build. Mater., 247, 10.1016/j.conbuildmat.2020.118589
Villain, 2007, Measurement methods of carbonation profiles in concrete: thermogravimetry, chemical analysis and gammadensimetry, Cement Concr. Res., 37, 1182, 10.1016/j.cemconres.2007.04.015
Reddy, 2020, Study on the influences of silica and sodium in the alkali-activation of ground granulated blast furnace slag, Construct. Build. Mater., 257, 10.1016/j.conbuildmat.2020.119514
Tajuelo Rodriguez, 2017, Thermal stability of C-S-H phases and applicability of Richardson and Groves' and Richardson C-(A)-S-H(I) models to synthetic C-S-H, Cement Concr. Res., 93, 45, 10.1016/j.cemconres.2016.12.005
Garcia-Lodeiro, 2011, Compatibility studies between N-A-S-H and C-A-S-H gels. Study in the ternary diagram Na2O–CaO–Al2O3–SiO2–H2O, Cement Concr. Res., 41, 923, 10.1016/j.cemconres.2011.05.006
Lee, 2017, Influence of binder composition on the gel structure in alkali activated fly ash/slag pastes exposed to elevated temperatures, Ceram. Int., 43, 2471, 10.1016/j.ceramint.2016.11.042
García-Lodeiro, 2010, Effect of calcium additions on N-A-S-H cementitious gels, J. Am. Ceram. Soc., 93, 1934, 10.1111/j.1551-2916.2010.03668.x
Walkley, 2016, Phase evolution of C-(N)-A-S-H/N-A-S-H gel blends investigated via alkali-activation of synthetic calcium aluminosilicate precursors, Cement Concr. Res., 89, 120, 10.1016/j.cemconres.2016.08.010
Kuenzel, 2013, Production of nepheline/quartz ceramics from geopolymer mortars, J. Eur. Ceram. Soc., 33, 251, 10.1016/j.jeurceramsoc.2012.08.022
Cui, 2019, Effects of the n(H2O: Na2Oeq) ratio on the geopolymerization process and microstructures of fly ash-based geopolymers, J. Non-Cryst. Solids, 511, 19, 10.1016/j.jnoncrysol.2018.12.033
Hou, 2019, Effect of Na/Al on formation, structures and properties of metakaolin based Na-geopolymer, Construct. Build. Mater., 226, 250, 10.1016/j.conbuildmat.2019.07.171
Duan, 2016, Fresh properties, compressive strength and microstructure of fly ash geopolymer paste blended with iron ore tailing under thermal cycle, Construct. Build. Mater., 118, 76, 10.1016/j.conbuildmat.2016.05.059
Ye, 2017, Properties of an aged geopolymer synthesized from calcined ore-dressing tailing of bauxite and slag, Cement Concr. Res., 100, 23, 10.1016/j.cemconres.2017.05.017
Shi, 1996, Some factors affecting early hydration of alkali-slag cements, Cement Concr. Res., 26, 439, 10.1016/S0008-8846(96)85031-9
Brough, 2002, Sodium silicate-based, alkali-activated slag mortars: Part I. Strength, hydration and microstructure, Cement Concr. Res., 32, 865, 10.1016/S0008-8846(02)00717-2
Song, 2000, Hydration of alkali-activated ground granulated blast furnace slag, J. Mater. Sci., 35, 249, 10.1023/A:1004742027117
Huang, 2015, Numerical simulation of moisture transport in concrete based on a pore size distribution model, Cement Concr. Res., 37, 31, 10.1016/j.cemconres.2014.08.003
Liu, 2018, Numerical simulation of the effect of cement particle shapes on capillary pore structures in hardened cement pastes, Construct. Build. Mater., 173, 615, 10.1016/j.conbuildmat.2018.04.039