Effect of sensor quantity on measurement accuracy of log inner defects by using stress wave
Tóm tắt
Wood nondestructive testing (NDT) is one of the high efficient methods in utilizing wood. This paper explained the principle of log defect testing by using stress wave, and analyzed the effects of sensor quantity on defect testing results by using stress wave in terms of image fitting degree and error rate. The results showed that for logs with diameter ranging from 20 to 40 cm, at least 12 sensors were needed to meet the requirement which ensure a high testing accuracy of roughly 90% of fitness with 0.1 of error rate. And 10 sensors were recommended to judge the possible locations of defects and 6 sensors were sufficient to decide whether there were defects or not.
Tài liệu tham khảo
Butler, D.A., Brunner, C.C., Funck, J.W. 1989. A dual-threshold image sweep-and-mark algorithm for defect detection in veneer. Forest Products Journal, 39(5): 25–28.
Conners, R.W., McMillin, C.W., Lin, K., et al. 1983. Identifying and locating surface defects in wood: part of an automated lumber processing system. Pattern Analysis and Machine Intelligence, 5(6): 573–583.
Lin Wenshu, Yang Huimin, Wan Lihai. 2005. Comparative study on ultrasonic and stress wave for nondestructive test of wood defects. Forestry Science and Technology, 30(2): 39–41.
Sobey, P.J., Semple, E.C. 1989. Detection and sizing visual features in wood using tonal measures and a classification algorithm. Pattern Recognition, 22(4): 367–380.
Wang Lihai, Yang Xuechun. 2002. Current situation of research on the non-destructive testing technique for wood defects. Forestry Science and Technology, 27(3): 35–38.
Yang Xuechun, Wang Lihai. 2005a. Impacts of structure defaults on propagation parameters of stress wave in wood of korean Pine. Journal of Northeast Forestry University, 33(1): 30–31.
Yang Xuechun, Wang Lihai. 2005b. Study on the Propagation Theories of Stress Wave in Log. Scientia Silvae Sinicae, 41(5): 132–138.
Yang Xuechun, Wang Lihai. 2002. Research progress of testing timber characteristics by using stress wave technique. Forest Engineering, 18(6): 11–12.