Effect of multilayered coating of single-mode optical fibers on distributed temperature and strain measurement in mortar specimens

Kodur, 2020, Test methods for characterizing concrete properties at elevated temperature, Fire Mater., 44, 381, 10.1002/fam.2777 Lee, 2016, Thermal strain behavior and strength degradation of ultra-high-strength-concrete, Mater. Struct., 49, 3411, 10.1617/s11527-015-0728-x Gawin, 2004, Modelling of deformations of high strength concrete at elevated temperatures, Mater. Struct., 37, 218, 10.1007/BF02480631 Sabeur, 2015, Effect of heating–cooling cycles on transient creep strain of high performance, high strength and ordinary concrete under service and accidental conditions, Mater. Struct., 48, 1561, 10.1617/s11527-014-0254-2 Le, 2017, Deformation capturing of concrete structures at elevated temperatures, Procedia Eng., 210, 613, 10.1016/j.proeng.2017.11.121 Le, 2019, Application of digital image correlation system for reliable deformation measurement of concrete structures at high temperatures, Eng. Struct., 192, 181, 10.1016/j.engstruct.2019.05.009 Pan, 2020, Strain field measurements over 3000 °C using 3D-Digital image correlation, Opt Laser. Eng., 127, 10.1016/j.optlaseng.2019.105942 Novak, 2011, High-temperature materials testing with full-field strain measurement: experimental design and practice, Rev. Sci. Instrum., 82, 10.1063/1.3657835 Loser, 2010, A volumetric technique for measuring the coefficient of thermal expansion of hardening cement paste and mortar, Cement Concr. Res., 40, 1138, 10.1016/j.cemconres.2010.03.021 Tang, 2020, Simultaneous measurement of shrinkage and coefficient of thermal expansion of mortar based on EFPI sensors with nanometer resolution, Measurement: Journal of the International Measurement Confederation, 152, 10.1016/j.measurement.2019.107376 Bao, 2016, Concrete pavement monitoring with PPP-BOTDA distributed strain and crack sensors, Smart Struct. Syst., 18, 405, 10.12989/sss.2016.18.3.405 Bao, 2015, Strain distribution and crack detection in thin unbonded concrete pavement overlays with fully distributed fiber optic sensors, Opt. Eng., 55, 10.1117/1.OE.55.1.011008 Bao, 2017, Distributed fiber optic sensor-enhanced detection and prediction of shrinkage-induced delamination of ultra-high-performance concrete overlay, Smart Mater. Struct., 26, 10.1088/1361-665X/aa71f4 Bao, 2016, Temperature-dependent strain and temperature sensitivities of fused silica single mode fiber sensors with pulse pre-pump Brillouin optical time domain analysis, Meas. Sci. Technol., 27, 10.1088/0957-0233/27/6/065101 Bao, 2016, High-temperature measurement with Brillouin optical time domain analysis of an annealed fused-silica single-mode fiber, Opt Lett., 41, 3177, 10.1364/OL.41.003177 Bao, 2017, Temperature measurement and damage detection in concrete beams exposed to fire using PPP-BOTDA based fiber optic sensors, Smart Mater. Struct., 26, 10.1088/1361-665X/aa89a9 Bao, 2017, Experimental analysis of steel beams subjected to fire enhanced by brillouin scattering-based fiber optic sensor data, J. Struct. Eng., 143, 10.1061/(ASCE)ST.1943-541X.0001617 Bao, 2020, Measuring three-dimensional temperature distributions in steel–concrete composite slabs subjected to fire using distributed fiber optic sensors, Sensors, 20, 5518, 10.3390/s20195518 Tan, 2021, Strain transfer effect in distributed fiber optic sensors under an arbitrary field, Autom. ConStruct., 124, 10.1016/j.autcon.2021.103597 Yang, 2021, Strain transfer characteristics of multi-layer optical fiber sensors with temperature-dependent properties at low temperature, Sensors, 21, 495, 10.3390/s21020495 Wang, 2019, Strain transfer analysis of fiber Bragg grating sensor assembled composite structures subjected to thermal loading, Compos. B Eng., 162, 303, 10.1016/j.compositesb.2018.11.013 Zhu, 2022, Rayleigh scattering based, thermal-induced displacement measurement along a steel plate at high temperature, J. InfraStruct. Intell. Resill., 1 Blaine, 2022 Meng, 2017, Optimization and performance of cost-effective ultra-high performance concrete, Mater. Struct., 50, 29, 10.1617/s11527-016-0896-3 Lu, 2018, Impact of the fiber coating on the temperature response of distributed optical fiber sensors at cryogenic ranges, J. Lightwave Technol., 36, 961, 10.1109/JLT.2017.2757843 Gu, 2013, Effects of polymer coatings on temperature sensitivity of Brillouin frequency shift within double-coated fibers, IEEE Sensor. J., 13, 864, 10.1109/JSEN.2012.2230438 Cruz, 1980, Thermal expansion of Portland cement paste, mortar and concrete at high temperatures, Fire Mater., 4, 66, 10.1002/fam.810040203 Zhu, 2021, Distributed fiber optic measurements of strain and temperature in long-span composite floor beams with simple shear connections subject to compartment fires, Fire Saf. J., 121, 10.1016/j.firesaf.2021.103275