Effect of corn and soybean oil derived additives on polymer-modified HMA and WMA master curve construction and dynamic modulus performance

J. D'Angelo, E. Harm, J. Bartoszek, G. Baumgardner, M. Corrigan, J. Cowsert, T. Harman, M. Jamshidi, W. Jones, D. Newcomb, B. Prowell, R. Sines, B. Yeaton., Warm-mix asphalt: European practice, Publication FHWA-PL-08-007, FHWA, U.S. Dept. of Transportation, Washington, DC, 2008. D. Newcomb, An introduction to warm mix asphalt, National Asphalt Pavement Association (2007). M. Hassan Life-cycle assessment of warm-mix asphalt: An environmental and economic perspective, Transportation Research Board 88th Annual Meeting, Washington, DC, 2009 Kristjánsdóttir, 2007, Assessing potential for warm-mix asphalt technology adoption, Transp. Res. Rec., 2040, 91, 10.3141/2040-10 K. Jenkins, J. De Groot, M. van de Ven, A. Molenaar, Half-warm foamed bitumen treatment, a new process, 7th Conference on asphalt pavements for Southern Africa (CAPSA 99), 1999. Kristjánsdóttir, 2006 O. Larsen, Ø. Moen, C. Robertus, B. Koenders, WAM Foam asphalt production at lower operating temperatures as an environmental friendly alternative to HMA, 3rd Eurasphalt & Eurobitume Congress, Foundation Eurasphalt, Breukelen, Netherlands., 2004. R. Anderson, G. Baumgardner, R. May, G. Reinke, Engineering Properties, Emissions, and Field Performance of Warm Mix Asphalt Technologies. NCHRP 9-47, Interim Report, National Cooperation Highway Research Program, Washington, DC (2008). B. Koenders, D. Stoker, C. Robertus, O. Larsen, J. Johansen, WAM-foam, asphalt production at lower operating temperatures, Ninth International Conference on Asphalt Pavements, 2002. Middleton, 2009, Evaluation of warm-mix asphalt produced with the double barrel green process, Transp. Res. Rec., 2126, 19, 10.3141/2126-03 Z. Hossain, M. Zaman, E.A. O'Rear, D.-H. Chen, Effectiveness of Advera® in Warm Mix Asphalt, GeoHunan International Conference 2011, 2011. G.C. Hurley, B.D. Prowell, Evaluation of Aspha-Min zeolite for use in warm mix asphalt, NCAT report 05-04, 2005. J. Button, C. Estakhri, A. Wimsatt, A synthesis of warm mix asphalt. Rep. No, FHWA/TX-07/0-5597-1. Texas Transportation Institute, Texas A&M University System, 2007. Corrigan, 2006, Warm mix asphalt technologies and research, Federal Highway Admin. Off. Pavement Technol., 3, 26 G.C. Hurley, B.D. Prowell, Evaluation of Sasobit for use in warm mix asphalt, NCAT report 05-06, 2005. G.C. Hurley, B.D. Prowell, Evaluation of Evotherm for use in warm mix asphalt, NCAT Rep. 06-02, 2006. T.A. Werpy, J.E. Holladay, J.F. White, Top Value Added Chemicals From Biomass: I. Results of Screening for Potential Candidates from Sugars and Synthesis Gas, 2004, p. Medium: ED; Size: PDFN. Buss, 2016, Investigation of isosorbide distillation bottoms as a bio-based warm-mix additive, J. Mater. Civil Eng., 28, 04015153, 10.1061/(ASCE)MT.1943-5533.0001445 Podolsky, 2016, The rutting and stripping resistance of warm and hot mix asphalt using bio-additives, Constr. Build. Mater., 112, 128, 10.1016/j.conbuildmat.2016.02.166 S. Diefenderfer, A. Hearon, Laboratory evaluation of a warm asphalt technology for use in Virginia, (No. FHWA/VTRC 09-R11), 2008. Ghabchi, 2015, Laboratory evaluation of stiffness, low-temperature cracking, rutting, moisture damage, and fatigue performance of WMA mixes, Road Mater. Pavement Des., 16, 334, 10.1080/14680629.2014.1000943 Prowell, 2007, Field performance of warm-mix asphalt at national center for asphalt technology test track, Transp. Res. Rec., 1998, 96, 10.3141/1998-12 Prowell, 2011 Xiao, 2010, Evaluation of rutting resistance in warm-mix asphalts containing moist aggregate, Transp. Res. Rec., 2180, 75, 10.3141/2180-09 H. Zelelew, C. Paugh, M.R. Corrigan, Warm-Mix Asphalt Laboratory Permanent Deformation Performance in State of Pennsylvania: Case Study, Transportation Research Board 90th Annual Meeting, 2011. Podolsky, 2014, 209 A. Buss, Y. Kuang, R.C. Williams, J. Bausano, A. Cascione, S.A. Schram, Influence of Warm Mix Asphalt Additive and Dosage Rate on Construction and Performance of Bituminous Pavements, Transportation Research Board 93rd Annual Meeting, 2014. E.R. Brown, P.S. Kandhal, F.L. Roberts, Y.R. Kim, D.-Y. Lee, T.W. Kennedy, National Asphalt Pavement Association., NAPA Research and Education Foundation., National Center for Asphalt Technology (U.S.), Hot mix asphalt materials, mixture design, and construction, 3rd ed., NAPA Research and Education Foundation, Lanham, Md., 2009. Christensen, 1992, Interpretation of dynamic mechanical test data for paving grade asphalt cements (with discussion), J. Assoc. Asphalt Paving Technol., 61 Li, 2012, A practical dynamic modulus testing protocol, J. Test. Eval., 40, 100 Pellinen, 2002, Stress dependent master curve construction for dynamic (complex) modulus (with discussion), J. Assoc. Asphalt Paving Technol., 71, 281 Booij, 1982, Generalization of Kramers–Kronig transforms and some approximations of relations between viscoelastic quantities, Rheol. Acta, 21, 15, 10.1007/BF01520701 Yang, 2015, New predictive equations for dynamic modulus and phase angle using a nonlinear least-squares regression model, J. Mater. Civil Eng., 27, 10.1061/(ASCE)MT.1943-5533.0001070 You, 2012, Predictive models for dynamic modulus using weighted least square nonlinear multiple regression model, Can. J. Civil Eng., 39, 589, 10.1139/l2012-035 T.K. Pellinen, M.W. Witczak, R.F. Bonaquist, Asphalt Mix Master Curve Construction Using Sigmoidal Fitting Function with Non-Linear Least Squares Optimization, 15th Engineering Mechanics Division Conference, ASCE, 2003, pp. 83–101. Rahman, 2016, Dynamic modulus and phase angle of warm-mix versus hot-mix asphalt concrete, Constr. Build. Mater., 126, 434, 10.1016/j.conbuildmat.2016.09.068