Effect of a novel starch-based temperature rise inhibitor on cement hydration and microstructure development: The second peak study

Tan, 2006, Effect of high temperature curing on compressive strength of concrete, J. Build. Mater., 4 Mo, 2014, MgO expansive cement and concrete in China: past, present and future, Cem. Concr. Res., 57, 1, 10.1016/j.cemconres.2013.12.007 Zhang, 2010, Effects of saccharide set retarders on the hydration of ordinary Portland cement and pure tricalcium silicate, J. Am. Ceram. Soc., 93, 279, 10.1111/j.1551-2916.2009.03378.x Ramachandran, 1992, Conduction calorimetric investigation of the effect of retarders on the hydration of Portland cement, Thermochim. Acta, 195, 373, 10.1016/0040-6031(92)80081-7 Plank, 2015, Chemical admixtures - chemistry, applications and their impact on concrete microstructure and durability, Cem. Concr. Res., 78, 81, 10.1016/j.cemconres.2015.05.016 Yan, 2020, Effect of a novel starch-based temperature rise inhibitor on cement hydration and microstructure development, Cem. Concr. Res., 129, 105961, 10.1016/j.cemconres.2019.105961 Juilland, 2010, Dissolution theory applied to the induction period in alite hydration, Cem. Concr. Res., 40, 831, 10.1016/j.cemconres.2010.01.012 Ouzia, 2019, The needle model: a new model for the main hydration peak of alite, Cem. Concr. Res., 115, 339, 10.1016/j.cemconres.2018.08.005 Bazzoni, 2014 Skalny, 1977, Retardation of tricalcium aluminate hydration by sulfates, J. Am. Ceram. Soc., 60, 174, 10.1111/j.1151-2916.1977.tb15503.x Quennoz, 2013, Interactions between alite and C3A-gypsum hydrations in model cements, Cem. Concr. Res., 44, 46, 10.1016/j.cemconres.2012.10.018 Taylor, 1997 Jansen, 2012, The early hydration of Ordinary Portland Cement (OPC): an approach comparing measured heat flow with calculated heat flow from QXRD, Cem. Concr. Res., 42, 134, 10.1016/j.cemconres.2011.09.001 Scrivener, 2015, Advances in understanding hydration of Portland cement, Cem. Concr. Res., 78, 38, 10.1016/j.cemconres.2015.05.025 Berodier, 2015 Zunino, 2019, The influence of the filler effect on the sulfate requirement of blended cements, Cem. Concr. Res., 126, 105918, 10.1016/j.cemconres.2019.105918 Scrivener, 2019, Advances in understanding cement hydration mechanisms, Cem. Concr. Res., 124, 105823, 10.1016/j.cemconres.2019.105823 Vollpracht, 2016, The pore solution of blended cements: a review, Mater. Struct. Constr., 49, 3341, 10.1617/s11527-015-0724-1 Nicoleau, 2016, A new view on the kinetics of tricalcium silicate hydration, Cem. Concr. Res., 86, 1, 10.1016/j.cemconres.2016.04.009 Lothenbach, 2019, Application of thermodynamic modelling to hydrated cements, Cem. Concr. Res., 123, 105779, 10.1016/j.cemconres.2019.105779 Schöler, 2017, Cement and concrete research early hydration of SCM-blended Portland cements : a pore solution and isothermal calorimetry study, Cem. Concr. Res., 93, 71, 10.1016/j.cemconres.2016.11.013 Lothenbach, 2015, Calcium silicate hydrates: solid and liquid phase composition, Cem. Concr. Res., 78, 57, 10.1016/j.cemconres.2015.03.019 Möschner, 2009, Influence of citric acid on the hydration of Portland cement, Cem. Concr. Res., 39, 275, 10.1016/j.cemconres.2009.01.005 Kong, 2016, Effect of polymer latexes with cleaned serum on the phase development of hydrating cement pastes, Cem. Concr. Res., 84, 30, 10.1016/j.cemconres.2016.02.013 Zunino, 2020, Factors influencing the sulfate balance in pure phase C3S/C3A systems, Cem. Concr. Res., 133, 106085, 10.1016/j.cemconres.2020.106085 Dalas, 2015, Modification of the rate of formation and surface area of ettringite by polycarboxylate ether superplasticizers during early C3A-CaSO4 hydration, Cem. Concr. Res., 69, 105, 10.1016/j.cemconres.2014.12.007 Jansen, 2018, The early hydration of OPC investigated by in-situ XRD, heat flow calorimetry, pore water analysis and1H NMR: learning about adsorbed ions from a complete mass balance approach, Cem. Concr. Res., 109, 230, 10.1016/j.cemconres.2018.04.017 Bullard, 2011, Mechanisms of cement hydration, 41, 1208 Quennoz, 2012, Hydration of C3A–gypsum systems, Cem. Concr. Res., 42, 1032, 10.1016/j.cemconres.2012.04.005 Li, 2018, Laboratory synthesis of C3S on the kilogram scale, Cem. Concr. Res., 108, 201, 10.1016/j.cemconres.2018.03.019 O’Connor, 1988, Application of the Rietveld refinement procedure in assaying powdered mixtures, Powder Diffract., 3, 2, 10.1017/S0885715600013026 Kulik, 2004 Lothenbach, 2008, Thermodynamic modelling of the effect of temperature on the hydration and porosity of Portland cement, Cem. Concr. Res., 38, 1, 10.1016/j.cemconres.2007.08.017 Lothenbach, 2019, Cemdata18: a chemical thermodynamic database for hydrated Portland cements and alkali-activated materials, Cem. Concr. Res., 115, 472, 10.1016/j.cemconres.2018.04.018 Mota, 2015, The influence of sodium salts and gypsum on alite hydration, Cem. Concr. Res., 75, 53, 10.1016/j.cemconres.2015.04.015 Bergold, 2013, Quantitative analysis of C-S-H in hydrating alite pastes by in-situ XRD, Cem. Concr. Res., 53, 119, 10.1016/j.cemconres.2013.06.001 Lothenbach, 2007, Effect of temperature on the pore solution, microstructure and hydration products of Portland cement pastes, Cem. Concr. Res., 37, 483, 10.1016/j.cemconres.2006.11.016 Kong, 2018, Whether do nano-particles act as nucleation sites for C-S-H gel growth during cement hydration?, Cem. Concr. Compos., 87, 98, 10.1016/j.cemconcomp.2017.12.007 Juilland, 2012, Effect of mixing on the early hydration of alite and OPC systems, Cem. Concr. Res., 42, 1175, 10.1016/j.cemconres.2011.06.011