Định tuyến bền vững về môi trường của các đường dây điện nhằm kết nối các nhà máy năng lượng tái tạo với lưới điện cao thế của Ý

Rodolfo Araneo1, Salvatore Celozzi1, Chiara Vergine2
1DIAEE, Electrical Engineering Division, University of Rome “La Sapienza”, Rome, Italy
2National Transmission Network, Terna S.p.A., Rome, Italy

Tóm tắt

Việc định tuyến các đường dây truyền tải điện cao thế để kết nối các nhà máy năng lượng tái tạo phân tán là một vấn đề quan trọng từ góc độ môi trường. Một phương pháp chuẩn mà xem xét từ nhiều khía cạnh, các yếu tố ảnh hưởng và có khả năng điều phối giữa các ràng buộc có trọng số có thể là một công cụ hữu ích cho các cơ quan quản lý tham gia vào quy trình phê duyệt. Phương pháp này có thể là một hỗ trợ hiệu quả để tăng độ tin cậy, tiết kiệm chi phí cho người tiêu dùng và giảm thiểu các tác động không thể tránh khỏi của các đường dây đối với cộng đồng dân cư xung quanh. Trong bài báo này, chúng tôi điều tra tính thích hợp của một quy trình được sử dụng bởi Terna, nhà điều hành hệ thống truyền tải điện cao thế của Ý, để xác định các hành lang mà đường dây truyền tải điện mới sẽ được thiết lập với tác động môi trường thấp nhất. Phương pháp này dựa trên việc phân chia tất cả các ràng buộc liên quan do các vấn đề môi trường và quy định lãnh thổ thành bốn lớp chính. Một nghiên cứu trường hợp thực tế liên quan đến thiết kế và kết nối một trại gió đặt gần Collarmele, ở trung tâm nước Ý, cho thấy hiệu quả của phương pháp được đề xuất.

Từ khóa

#đường dây điện cao thế #năng lượng tái tạo #bền vững môi trường #Terna #nghiên cứu trường hợp

Tài liệu tham khảo

Abam, F., Nwankwojike, B.N., Ohunakin, O.S., Ojomu, S.A.: Energy resource structure and on-going sustainable development policy in Nigeria: a review. Int. J. Energy Environ. Eng. 5(2), 1–16 (2014) Adaramola, M., Oyewola, O.: Evaluating the performance of wind turbines in selected locations in Oyo state, Nigeria. Renew. Energy 36(12), 3297–3304 (2011) Araneo, R., Falconi, C.: Lateral bending of tapered piezo-semiconductive nanostructures for ultra-sensitive mechanical force to voltage conversion. Nanotechnology 24(26), 265707 (2013) Araneo, R., Grasselli, U., Celozzi, S.: Assessment of a practical model to estimate the cell temperature of a photovoltaic module. Int. J. Energy Environ. Eng. 5, 1–15 (2014) Araneo, R., Lammens, S., Grossi, M., Bertone, S.: EMC issues in high-power grid-connected photovoltaic plants. IEEE Trans. Electromagn. Compat. 51, 639–648 (2009) Araneo, R., Lovat, G., Burghignoli, P., Falconi, C.: Piezo-semiconductive quasi-1D nanodevices with or without anti-symmetry. Adv. Mater. 24(34), 4719–24 (2012) Araneo, R., Bini, F., Pea, M., Notargiacomo, A., Rinaldi, A., Lovat, G., Celozzi, S.: Current-voltage characteristics of ZnO nanowires under uniaxial loading. IEEE Trans. Nanotechnol. 13(4) (2014) Celozzi, S.: Active compensation and partial shields for the power-frequency magnetic field reduction. IEEE Int. Symp. Electromag. Compat. 1, 222–226 (2002) Celozzi, S., Garzia, F.: Magnetic field reduction by means of active shielding techniques. Sustain. World 8, 79–89 (2003) Celozzi, S., Garzia, F.: Active shielding for power-frequency magnetic field reduction using genetic algorithms optimisation. IEEE Proc. Sci. Meas. Technol. 151(1), 2–7 (2004) de Araujo Lima, L., Bezerra Filho, C.R.: Wind energy assessment and wind farm simulation in Triunfo–Pernambuco, Brazil. Renew. Energy 35(12), 2705–2713 (2010) Eddine, B., Salah, M.: Solid waste as renewable source of energy: current and future possibility in Algeria. Int. J. Energy Environ. Eng. 3(1), 17 (2012) Commission, European: Renewable Energy Directive 2009/28/EC. In: Proceedings of European Parliament and of the Council, Technical Report (2009) European Commission: Communication from the Commission to the European Parliament, the Council, the European Economic and social committee and the Committee of the regions: a roadmap for moving to a competitive low-carbon economy in 2050. Technical report, European commission SEC, 288 final (2011) European Commission: Communication from the Commission to the European Parliament, the Council, the European Economic and social committee and the committee of the regions: energy roadmap 2050, Technical report, European commission COM, 885 final (2011) European Commission: Communication from the Commission to the European Parliament, the Council, the European economic and social committee and the committee of the regions: impact assessment-energy roadmap 2050, Technical report, European commission SEC, 1565 final (2011) Ferreira, J.V., Viana, H., Esteves, B., Cruz Lopes, L.P., Domingos, I.: Life cycle assessment of residual forestry biomass chips at a power plant: a Portuguese case study. Int. J. Energy Environ. Eng. 5(2), 1–7 (2014) Fischer, T.B.: Theory and Practice of Strategic Environmental Assessment. Earthscan, London (2007) Flodberg, K., Blomsterberg, A., Dubois, M.C.: Low-energy office buildings using existing technology: simulations with low internal heat gains. Int. J. Energy Environ. Eng. 3(1), 1–9 (2012) Hurtado, A., Eguilior, S., Recreo, F.: Methodological development of a probabilistic model for C O 2 geological storage safety assessment. Int. J. Energy Environ. Eng. 5(2), 1–10 (2014) Jacobsen, H.K., Pade, L.L., Schrder, S.T., Kitzing, L.: Cooperation mechanisms to achieve EU renewable targets. Renew. Energy 63, 345–352 (2014) Lal, S., Raturi, A.: Techno-economic analysis of a hybrid mini-grid system for Fiji islands. Int. J. Energy Environ. Eng. 3(1), 1–10 (2012) Lean, H.H., Smyth, R.: Will policies to promote renewable electricity generation be effective? Evidence from panel stationarity and unit root tests for 115 countries. Renew. Sustain. Energy Rev. 22, 371–379 (2013) Lucchetti, E., Barbier, J., Araneo, R.: Assessment of the technical usable potential of the TUM Shaft Hydro Power plant on the Aurino River, Italy. Renew. Energy 60, 648–654 (2013) Melikoglu, M.: Vision 2023: feasibility analysis of Turkey’s renewable energy projection. Renew. Energy 50, 570–575 (2013) Menegaki, A.N.: Growth and renewable energy in Europe: benchmarking with data envelopment analysis. Renew. Energy 60, 363–369 (2013) Pang, X., Mörtberg, U., Brown, N.: Energy models from a strategic environmental assessment perspective in an EU context: what is missing concerning renewables? Renew. Sustain. Energy Rev. 33, 353–362 (2014) Quinonez-Varela, G., Cruden, A., Graham, C., Punton, B., Blair, L., Thomson, J.: A GIS/PSS planning tool for the initial grid connection assessment of renewable generation. Renew. Energy 32(5), 727–737 (2007) Rinaldi, A., Araneo, R., Celozzi, S., Pea, M., Notargiacomo, A.: The clash of mechanical and electrical size-effects in ZnO nanowires and a double power law design concept for piezoelectric and piezotronic devices. Adv. Mater. (2014). doi:10.1002/adma.201401026 Shafiullah, G., Amanullah, M., Ali, A.S., Jarvis, D., Wolfs, P.: Prospects of renewable energy: a feasibility study in the Australian context. Renew. Energy 39(1), 183–197 (2012) Sharma, P., Harinarayana, T.: Enhancement of energy generation from two layer solar panels. Int. J. Energy Environ. Eng. 3(12), 1–9 (2012) Sharma, P., Harinarayana, T.: Solar energy generation potential along national highways. Int. J. Energy Environ. Eng. 4(16), 1–13 (2013) Sims, S., Dent, P.: High-voltage overhead power lines and property values: a residential study in the UK. Urban Stud. 42(4), 665–694 (2005) Whitworth, C.C., Duller, A.W.G., Jones, D., Earp, G.: Aerial video inspection of overhead power lines. Power Eng. J. 15(1), 25–32 (2001) Zangl, H., Bretterklieber, T., Brasseur, G.: Energy harvesting for online condition monitoring of high-voltage overhead power lines. In: Proceedings of Instrumentation and Measurement Technology Conference, 2008, IMTC 2008. IEEE, pp. 1364–1369 (2008)