Dynamic characteristics of the blisk with synchronized switch damping based on negative capacitor

Castanier, 2006, Modeling and analysis of mistuned bladed disk vibration: current status and emerging directions, J. Propul. Power, 22, 384, 10.2514/1.16345 Castanier, 2002, Using intentional mistuning in the design of turbomachinery rotors, AIAA J., 40, 2077, 10.2514/2.1542 Griffin, 1990, A review of friction damping of turbine blade vibration, Int. J. Turbo Jet Eng., 7, 297 Petrov, 2004, State-of-the-art dynamic analysis for non-linear gas turbine structures, Proc. Inst. Mech. Eng., Part G: J. Aerosp. Eng., 218, 199, 10.1243/0954410041872906 Laxalde, 2007, Qualitative analysis of forced response of blisks with friction ring dampers, Eur. J. Mech. – A/Solids, 26, 676, 10.1016/j.euromechsol.2006.10.002 C.M. Firrone, S. Zucca, Modelling Friction Contacts in Structural Dynamics and Its Application to Turbine Bladed Disks, INTECH, 2011. Herzog, 2014, Comparison of two widely-used frequency-time domain contact models for the vibration simulation of shrouded turbine blades Jalili, 2009 Hagood, 1991, Damping of structural vibrations with piezoelectric materials and passive electrical networks, J. Sound Vib., 146, 243, 10.1016/0022-460X(91)90762-9 Tang, 1999, Vibration control of rotationally periodic structures using passive piezoelectric shunt networks and active compensation, J. Vib. Acoust., 121, 379, 10.1115/1.2893991 Tang, 2001, Active-passive hybrid piezoelectric networks for vibration control: comparisons and improvement, Smart Mater. Struct., 10, 794, 10.1088/0964-1726/10/4/325 Yu, 2007, Piezoelectric networks for vibration suppression of mistuned bladed disks, J. Vib. Acoust., 129, 559, 10.1115/1.2775511 Yu, 2009, Vibration suppression of mistuned coupled-blade-disk systems using piezoelectric circuitry network, J. Vib. Acoust., 131, 021008, 10.1115/1.2948410 Mokrani, 2015, Parallel piezoelectric shunt damping of rotationally periodic structures, Advances in Materials Science and Engineering, 2015, 10.1155/2015/162782 Zhou, 2014, Essentially nonlinear piezoelectric shunt circuits applied to mistuned bladed disks, J. Sound Vib., 333, 2520, 10.1016/j.jsv.2013.12.019 C. Richard, D. Guyomar, D. Audigier, G. Ching, Semi-passive damping using continuous switching of a piezoelectric device, in: 1999 Symposium on Smart Structures and Materials. International Society for Optics and Photonics, 1999, pp. 104–111. Richard, 2000, Enhanced semi-passive damping using continuous switching of a piezoelectric device on an inductor, 288 Ji, 2016, Semi-active vibration control based on unsymmetrical synchronized switch damping: analysis and experimental validation of control performance, J. Sound Vib., 370, 1, 10.1016/j.jsv.2016.01.033 Neubauer, 2011, Enhanced switching law for synchronized switch damping on inductor with bimodal excitation, J. Sound Vib., 330, 2707, 10.1016/j.jsv.2011.01.003 Neubauer, 2012, On the maximum damping performance of piezoelectric switching techniques, J. Intell. Mater. Syst. Struct. Makihara, 2007, A self-sensing method for switching vibration suppression with a piezoelectric actuator, Smart Mater. Struct., 16, 455, 10.1088/0964-1726/16/2/025 Lefeuvre, 2006, Semi-passive piezoelectric structural damping by synchronized switching on voltage sources, J. Intell. Mater. Syst. Struct., 17, 653, 10.1177/1045389X06055810 Mokrani, 2012, Synchronized switch damping on inductor and negative capacitance, J. Intell. Mater. Syst. Struct., 10.1177/1045389X11433493 Ji, 2011, Application of a negative capacitance circuit in synchronized switch damping techniques for vibration suppression, J. Vib. Acoust., 133, 041015, 10.1115/1.4003146 Han, 2013, Improved piezoelectric switch shunt damping technique using negative capacitance, J. Sound Vib., 56, 7, 10.1016/j.jsv.2012.08.001 Chérif, 2012, Simulation of multimodal vibration damping of a plate structure using a modal SSDI-max technique, J. Intell. Mater. Syst. Struct., 23, 675, 10.1177/1045389X12437891 Ji, 2010, Two-mode vibration control of a beam using nonlinear synchronized switching damping based on the maximization of converted energy, J. Sound Vib., 329, 2751, 10.1016/j.jsv.2010.01.012 Guyomar, 2006, Nonlinear semi-passive multimodal vibration damping: an efficient probabilistic approach, J. Sound Vib., 294, 249, 10.1016/j.jsv.2005.11.010 Lallart, 2008, Self-powered circuit for broadband, multimodal piezoelectric vibration control, Sens. Actuat. A: Phys., 143, 377, 10.1016/j.sna.2007.11.017 D’Assunção, 2015, Applied self-powered semi-passive control for a 2-degree-of-freedom aeroelastic typical section using shunted piezoelectric materials, J. Intell. Mater. Syst. Struct., 26, 373, 10.1177/1045389X14526797 Qureshi, 2015, Self-powered synchronized switch damping on negative capacitance for broadband vibration suppression of flexible structures, Int. J. Appl. Electromagnet. Mech, 49, 105, 10.3233/JAE-150017 Von Groll, 2001, The harmonic balance method with arc-length continuation in rotor/stator contact problems, J. Sound Vib., 241, 223, 10.1006/jsvi.2000.3298 Jaumouillé, 2010, An adaptive harmonic balance method for predicting the nonlinear dynamic responses of mechanical systems-application to bolted structures, J. Sound Vib., 329, 4048, 10.1016/j.jsv.2010.04.008 Joannin, 2016, Nonlinear modal analysis of mistuned periodic structures subjected to dry friction, J. Eng. Gas Turb. Power, 138, 072504, 10.1115/1.4031886 Cameron, 1989, An alternating frequency/time domain method for calculating the steady-state response of nonlinear dynamic systems, J. Appl. Mech., 56, 149, 10.1115/1.3176036 Laxalde, 2008, Non-linear modal analysis for bladed disks with friction contact interfaces, Asme Turbo Expo Power for Land Sea and Air, 457 Laxalde, 2009, Complex non-linear modal analysis for mechanical systems: application to turbomachinery bladings with friction interfaces, J. Sound Vib., 322, 1009, 10.1016/j.jsv.2008.11.044 Figaschewsky, 2014, Forced response prediction of an axial turbine rotor with regard to aerodynamically mistuned excitation