Disk Stress in the Wave Generator of a Large Wave Gear
Tóm tắt
Wave gears are characterized by minimal weight, size, and noise, low energy losses, and high kinematic efficiency. They are well suited to economic sectors whose development is currently a priority. Mass-produced wave gears are combined with wave generators of cam type, containing a flexible bearing, and are able to reduce relatively small torques. The strength and durability of the following components are calculated: flexible gears, flexible bearings, and the constituents of a wave transmission.
Tài liệu tham khảo
Kikuchi, M., Hasegawa, H., Kiyosawa, Y., et al., Stress analysis of cup type strain wave gearing: 2nd report: e-ffect by the contact with circular spline, Trans. Jpn. Soc. Mech. Eng. C, 2001, vol. 67, no. 656, pp. 900–905. https://doi.org/10.1299/kikaic.67.900
Hareesh, Y.S. and Varghese, J., Design and analysis of flex spline with involute teeth profile for harmonic drive mechanism, Int. J. Eng. Res. Technol., 2015, vol. 4, no. 12, pp. 613–618.
Ishikawa, S., The gear geometry of tooth engagement in harmonic drive, Proc. JSME Semi-Int. Symp., Tokyo, 1967, pp. 97–104.
Huimin, D., Zhengdu, Z., Weidong, Z., et al., Dynamic simulation of harmonic gear drives considering tooth profiles parameters optimization, J. Comput., 2012, vol. 7, no. 6, pp. 1429–1436.
Lewis, J., Fast forward for harmonic-drive gearing, Glob. Des. News, 2000, vol. 4, no. 2, pp. 46–47.
Shuvalov, S.A. and Parshin, Yu.M., Loads on a generator of the wave gearing, Izv. Vyssh. Uchebn. Zaved., Mashinostr., 1971, no. 12, pp. 19–23.
Taghirad, H.D. and Belanger, P.R., An experimental study on modeling and identification of harmonic drive systems, Proc. 35th IEEE Conf. on Decision and Control, Kobe, Japan, December 13, 1996, IEEE, 1996. https://doi.org/10.1109/CDC.1996.577625
Strelnikov, V.N. and Sukov, M.G., Stressed state of heavy-duty harmonic gear drive flexspline, Adv. Eng. Res., 2018, vol. 158, pp. 391–398.
Patel, D.M., Jivani, R.G., and Pandya, V.A., Harmonic drive design and application: a review, Global Res. Dev. J. Eng., 2015, vol. 1, no. 1, pp. 34–37.
Demidov, S.P., Teoriya uprugosti (Theory of Elasticity), Moscow: Vysshaya Shkola, 1979.
Ivanov, M.N., Volnovye zubchatye peredachi (Wave Gears), Moscow: Vysshaya Shkola, 1981.
Poletuchii, A.I., Teoriya i konstruirovanie vysokoeffektivnykh volnovykh zubchatykh mekhanizmov (Theory and Design of Highly Efficient Wave Gear Mechanisms), Khar’kov: Nats. Aerokosm. Univ. im. N.E. Zhu-kovskogo “Kharkovsk. Aviats. Inst.,” 2005.