Development of Composite Bronzes Reinforced by Steel Dendrites
Tóm tắt
A group of composite bronzes BrZhNKA 9-4-1-1, BrZhNA 12-7-1, etc., has been studied. Brittle intermetallic compounds of the Cu3Sn type are replaced by steel dendrites in them.. The mass transfer of Fe, Ni, Co, and Al between the matrix and dendrites in these bronzes is studied. The dispersity of dendrites depending on the production method of the mentioned alloys can be increased tenfold, for example, with the vacuum casting method. The mechanical properties of the samples of the BrZhNKA type (σu = 372 MPa, δ = 25%, and ψ = 42%) when compared with the BrO10 prototype are higher: hardness σu by 50%, plasticity δ and ψ by a factor of 4–5, and wear resistance by an order of magnitude; the coefficient of friction is 20–30% lower. The fact of the substantial influence of dispersity of the dendritic component on the wearing intensity of the bronze of the BrZhNA type is established. For example, the wearing intensity with the transversal section of dendrites of 1 and 10 μm is 0.002 and 0.025, respectively, which is an order of magnitude lower, while the coefficient of friction remains herewith invariable; i.e., it is independent of the dispersity of dendrites. A whole complex of mechanical, process, and service properties makes it possible to consider the half-industrial approval of this new class of composite bronzes of the BrZhNKA type reinforced by dendrites of N12K7Yu maraging steel for sliding friction units substantiated and promising.
Tài liệu tham khảo
Arzamasov, B.N., Konstruktsionnye materialy: Spravochnik (Constructional Materials: Handbook), Moscow: Mashinostroenie, 1990.
Potekhin, B., Hernández, A., Khristolyubov, A., and Ilushin, V., Formación de la estructura y propiedades de los bronces Fe–Ni–Al, in: Proc. VI Congr. Int. Mater. “CIM 2011”, Colombia, Bogotá D.C., 2011, pp. 67–75.
Potekhin, B.A., Khristolyubov, A.S., Zhilyakov, A.Yu., and Ilyushin, V.V., Features of the formation of the structure of composite bronzes reinforced with steel dendrites, Vopr. Materialoved., 2013, no. 4 (76), pp. 43–49.
Potekhin, B.A., Ilyushin, V.V., Khristolyubov, A.S., and Zhilyakov, A.Yu., Formation of structure and properties of composite bronzes reinforced by steel dendrites, Phys. Met. Metallogr., 2014, vol. 115, no. 4, pp. 413–419.
Saltykov, S.A., Stereometricheskaya metallografiya (Stereometric Metallography), Moscow: Metallurgiya, 1970.
Potekhin, B.A., Ilyushin, V.V., and Khristolyubov, A.S., Special properties of babbit B83 fabricated by turbulent casting, Lit’e Metall., 2010, no. 3 (57), pp. 78–81.
Lyakishev, N.P., Diagrammy sostoyaniya dvoinykh metallicheskikh sistem: Spravochnik (Phase Diagrams of Binary Metallic Systems: Handbook), Moscow: Mashinostroenie, 1997.
Avraamov, Yu.S. and Shlyapin, A.D., Splavy na osnove sistem s ogranichennoi rastvorimost’yu v zhidkom sostoyanii (Alloys Based on Systems with Limited Solubility in the Liquid State), Moscow: Interkontakt Nauka, 2002.
Köster, W. and Dannöehl, W., Das system kupfer–nickel–eisen, Z. Metallkd., 1935, no. 9, pp. 220–226.
Qin, G.W., Zhao, G., Jiang, M., Li, H.X., and Hao, S.M., The isothermal sections of the Cu–Ni–Fe ternary system at 600, 800, 1000, and 1050°C, Z. Metallkd., 2000, no. 5, pp. 379–382.
Gupta K.P., The Cu–Fe–Ni (copper–iron–nickel) system. Phase Diagr. Ternary Nickel Alloys, 1990, no. 1, pp. 290–315.
Chuang, Y.Y., Schmid, R., and Chang, Y.A., Calculation of the equilibrium phase diagrams and the spinodally decomposed structures of the Fe–Cu–Ni system, Acta Mater., 1985, no. 8, pp. 1369–1380.
Lopez, V.M., Sano, N., Sakurai, T., and Hirano, K., A study of phase decomposition in Cu–Ni–Fe alloys, Acta Metall. Mater., 1993, no. 1, pp. 265–271.
Ronka, K.J., Kodentsov, A.A., Van Loon, P.J.J., Kivilahti, J.K., and Van Loo, F.J.J., Thermodynamic and kinetic study of diffusion paths in the system Cu–Fe–Ni, Metall. Mater. Trans. A, 1996, vol. 27, no. 8, pp. 2229–2238.
Ugaste, U., Kodentsov, A.A., and Van Loo, F.J., Interdiffusion and Kirkendall-effect in the Fe–Ni–Cu system, Sol. St. Phenom., 2000, no. 72, pp. 117–122.
Divinski, S.V., Hisker, F., Herzig, Chr., Filipek, R., and Danielewski, M., Self- and interdiffusion in ternary Cu–Fe–Ni alloys. http://ceramrtr.ceramika.agh.edu.pl/ ~icmmagh/artykuly/228%20Filipek_p50.pdf (accessed: June 7, 2017).
Wang, C.P., Liu, X.J., Ohnuma, I., Kainuma, R., and Ishida, K., Thermodynamic database of the phase diagrams in Cu–Fe base ternary systems, J. Phase Equilib. Diffus., 2004, vol. 25, no. 4, pp. 320–328.
Potak, Ya.M., Vysokoprochnye stali (High-Strength Steel), Moscow: Metallurgiya, 1972.
Potak, Ya.M. and Sagalevich, E.A., Strukturnaya diagramma deformiruemykh nerzhaveyushchikh stalei (Structural Diagram of Deformable Stainless Steels), MITOM. 1971, no. 9, pp. 12–16.
Baricco, M., Bosco, E., Acconciaioco, G., Rizzi, P., and Coisson, M., Rapid solidification of Cu–Fe–Ni alloys, Mater. Sci. Eng. A, 2004, pp. 375–377, 1019–1023.
Potekhin, B.A., Khristolyubov, A.S., and Hernandez Fereira, A.A., New class of composite bronze, armed with steel dendrites for antifriction technique, in: Proc. XXIV Inter. Sci. Conf. “Trans & Motauto 16”, Varna, Bulgaria, 2016, pp. 36–69.
Shumyakov, V.I., Potekhin, B.A., Korobov, Yu.S., Khristolyubov, A.S., Ilyushin, V.V., Kochugov, S.P., Balin, A.N., and Vishnevskii, A.A., RF Patent 170923, 2017.