Detailed dynamic refrigerant migration characteristics in room air-conditioner with R290

Aute, 2016, A review of state of the art in modeling of air-to-refrigerant heat exchangers for HVAC&R Applications Barbosa, 2008, Prediction of refrigerant absorption and onset of natural convection in lubricant oil, Int. J. Refrig., 31, 1231, 10.1016/j.ijrefrig.2008.02.001 Belth, 1988, Transient mass flow rate of a residential air-to-air heat pump, Int. J. Refrig., 11, 298, 10.1016/0140-7007(88)90092-8 Björk, 2005, A simple technique for refrigerant mass measurement, Appl. Therm. Eng., 25, 1115, 10.1016/j.applthermaleng.2004.09.008 Borges, 2011, Transient simulation of household refrigerators: a semi-empirical quasi-steady approach, Appl. Energy, 88, 748, 10.1016/j.apenergy.2010.09.019 Cecchinato, 2012, An intrinsically mass conservative switched evaporator model adopting the moving-boundary method, Int. J. Refrig., 35, 349, 10.1016/j.ijrefrig.2011.10.007 Chen, 2004, Measurements and correlations of frictional single-phase and two-phase pressure drops of R-410A flow in small U-type return bends, Int. J. Heat Mass Transf., 47, 2241, 10.1016/j.ijheatmasstransfer.2003.11.016 Colbourne, 2003, Equipment design and installation features to disperse refrigerant releases in rooms - part I: experiments and analysis, Int. J. Refrig., 26, 667, 10.1016/S0140-7007(03)00027-6 Colbourne, 2003, Equipment design and installation features to disperse refrigerant releases in rooms - part II: determination of procedures, Int. J. Refrig., 26, 674, 10.1016/S0140-7007(03)00026-4 Colbourne, 2015, Comparative evaluation of risk of a split air conditioner and refrigerator using hydrocarbon refrigerants, Int. J. Refrig., 59, 295, 10.1016/j.ijrefrig.2015.06.026 Corberán, 2008, Review of standards for the use of hydrocarbon refrigerants in A/C, heat pump and refrigeration equipment, Int. J. Refrig., 31, 748, 10.1016/j.ijrefrig.2007.12.007 Cullimore, B.A., Ring, S.G., Johnson, D.A., 2009, SINDA/FLUINT User's Manual. C&R Technologies, Inc., 1–132 (Chapter 4). Ding, 2009, Practical methods for measuring refrigerant mass distribution inside refrigeration system, Int. J. Refrig., 32, 327, 10.1016/j.ijrefrig.2008.05.002 Friedel, 1979, Improved friction pressure drop correlation for horizontal and vertical two-phase pipe flow Fukuta, 2005, Mixing and separation characteristics of isobutane with refrigeration oil, Int. J. Refrig., 28, 997, 10.1016/j.ijrefrig.2005.04.001 Ghoubali, 2017, Refrigerant charge optimisation for propane heat pump water heaters, Int. J. Refrig., 76, 230, 10.1016/j.ijrefrig.2017.02.017 Hermes, 2008, A first-principles simulation model for the start-up and cycling transients of household refrigerators, Int. J. Refrig., 31, 1341, 10.1016/j.ijrefrig.2008.04.003 Huang, 2014, A model for air-to-refrigerant microchannel condensers with variable tube and fin geometries, Intl, J. Refrig., 40, 269, 10.1016/j.ijrefrig.2014.01.001 Jeong, 2006, A study on the thermal contact conductance in fin-tube heat exchangers with 7 mm tube, Int. J. Heat Mass Transf., 49, 1547, 10.1016/j.ijheatmasstransfer.2005.10.042 Jin, 2012 Jiang, 2006, ‘CoilDesigner: a general purpose simulation and design tool for air to refrigerant heat exchangers’, Int. J. Refrig., 29, 601, 10.1016/j.ijrefrig.2005.09.019 Kapadia, 2009, Transient characteristics of split air-conditioning systems using R-22 and R-410A as refrigerants, HVAC&R Res, 15, 617, 10.1080/10789669.2009.10390854 Lemmon, E.W., Huber, M.L., McLinden, M.O. 2013, NIST Standard Reference Database 23: Reference Fluid Standard Reference Data Program, Gaithersburg. Thermodynamic and Transport Properties-REFPROP, Version 9.1, National Institute of Standards and Technology. Leung, 1998, Measurements of absorption rates of HFC single and blended refrigerants in POE oils, HVAC&R Res, 2, 141, 10.1080/10789669.1998.10391396 Li., 2010, A dynamic model of a vapor compression cycle with shut-down and start-up operations, Int. J. Refrig., 33, 538, 10.1016/j.ijrefrig.2009.09.011 Li, 2014, Recent advances in dynamic modeling of HVAC equipment. Part 1: equipment modeling, Sci. Technol. Built Environ., 20, 136 Li, 2014, Indoor leakage test for safety of R-290 split type room air conditioner, Int. J. Refrig., 40, 380, 10.1016/j.ijrefrig.2013.11.023 Li, 2015, Measurement of refrigerant mass distribution within a R290 split air conditioner, Int. J. Refrig., 57, 163, 10.1016/j.ijrefrig.2015.05.012 Li, 2013, Simplified steady-state modelling for variable speed compressor, Appl. Therm. Eng., 50, 318, 10.1016/j.applthermaleng.2012.08.041 Li, 2017 Lin, 2017, Experimental investigation of startup characteristics of R290 rotary compressor under low ambient temperature heating condition, Int. J. Refrig., 77, 128, 10.1016/j.ijrefrig.2017.02.029 Mulroy, 1985, Refrigerant migration in a split unitary conditioner, ASHRAE Trans, 91, 193 Navarro, 2005, Test results of performance and oil circulation rate of commercial reciprocating compressors of different capacities working with propane (R290) as refrigerant, Int. J. Refrig., 28, 881, 10.1016/j.ijrefrig.2005.01.010 Ndiaye, 2010, Transient modeling of refrigerant-to-airfin-and-tube heat exchangers, HVAC&R Res., 16, 355, 10.1080/10789669.2010.10390909 Nunes, 2015, Modeling, simulation and optimization of a vapor compression refrigeration system dynamic and steady state response, Appl. Energy, 158, 540, 10.1016/j.apenergy.2015.08.098 Peuker, 2009, Transient refrigerant migration and oil distribution of an R134a automotive AC System, Int. J. Passeng. Cars- Mech. Syst., 2, 714, 10.4271/2009-01-0534 Poggi, 2008, Refrigerant charge in refrigerating systems and strategies of charge reduction, Int. J. Refrig., 31, 353, 10.1016/j.ijrefrig.2007.05.014 Rasmussen, 2006 Richardson, 2006 Rubas, 1995, Factors contributing to refrigerator cycling losses, Int. J. Refrig., 18, 168, 10.1016/0140-7007(94)00000-N Ruz, 2017, A hybrid modeling approach for steady-state optimal operation of vapor compression refrigeration cycles, Appl. Therm. Eng., 120, 74, 10.1016/j.applthermaleng.2017.03.103 Shah, 1979, A general correlation for heat transfer during film condensation inside pipes, Int. J. Heat Mass Transf., 22, 547, 10.1016/0017-9310(79)90058-9 Shah, 2006, Evaluation of general correlations for heat transfer during boiling of saturated liquids in tubes and annuli, HVAC&R Res, 12, 1047, 10.1080/10789669.2006.10391450 Singh, 2009, A heat exchanger model for air-to-refrigerant fin-and-tube heat exchanger with arbitrary fin sheet, Int. J. Refrig., 32, 1724, 10.1016/j.ijrefrig.2009.05.011 Singh, 2011, Simulation of air-to-refrigerant fin-and-tube heat exchanger with CFD based air propagation, Intl. J. Refrig., 34, 1883, 10.1016/j.ijrefrig.2011.07.007 Tanaka, 1982, Experimental study on the dynamic characteristics of a heat pump, ASHRAE Trans, 88, 323 Tang, 2017, The experimental investigation of refrigerant distribution and leaking characteristics of R290 in split type household air conditioner, Int. J. Refrig., 115, 72 Uhlmann, 2012, Theoretical and experimental investigation of startup and shutdown behavior of residential heat pumps, Int. J. Refrig., 35, 2138, 10.1016/j.ijrefrig.2012.08.008 Wang, 1999, Heat transfer and friction correlation for compact louvered fin-and-tube heat exchangers, Int. J. Heat Mass Transf., 42, 1945, 10.1016/S0017-9310(98)00302-0 Wahlstrom, 2000, Development of models for prediction of solubility for HFC working fluids in pentaerythritol ester compressor oils, Int J Refrig., 23, 597, 10.1016/S0140-7007(00)00004-9 Xu, 2016, Investigation of domestic air conditioner with a novel low charge microchannel condenser suitable for hydrocarbon refrigerant, Meas. J. Int. Meas. Confed., 90, 338, 10.1016/j.measurement.2016.04.034 Yokozeki, 2002, Time-dependent behavior of gas absorption in lubricant oil, Int. J. Refrig., 25, 695, 10.1016/S0140-7007(01)00066-4 Zsembinszki, 2017, A novel numerical methodology for modelling simple vapour compression refrigeration system, Appl. Therm. Eng., 115, 188, 10.1016/j.applthermaleng.2016.12.059