Design characteristics of corrugated trapezoidal plate heat exchangers using nanofluids

Chol, 1995, Enhancing thermal conductivity of fluids with nanoparticles, ASME-Publications-Fed, 231, 99 Lee, 1999, Measuring thermal conductivity of fluids containing oxide nanoparticles, J. Heat Transfer, 121, 280, 10.1115/1.2825978 Eastman, 2001, Anomalously increased effective thermal conductivities of ethylene glycol-based nanofluids containing copper nanoparticles, Appl. Phys. Lett., 78, 718, 10.1063/1.1341218 Xuan, 2000, Heat transfer enhancement of nanofluids, Int. J. Heat Fluid Flow, 21, 58, 10.1016/S0142-727X(99)00067-3 Das, 2003, Temperature dependence of thermal conductivity enhancement for nanofluids, J. Heat Transfer, 125, 567, 10.1115/1.1571080 Liu, 2006, Enhancement of thermal conductivity with Cu for nanofluids using chemical reduction method, Int. J. Heat Mass Transfer, 49, 3028, 10.1016/j.ijheatmasstransfer.2006.02.012 Wang, 2007, Heat transfer characteristics of nanofluids: a review, Int. J. Therm. Sci., 46, 1, 10.1016/j.ijthermalsci.2006.06.010 Godson, 2010, Enhancement of heat transfer using nanofluids – an overview, Renew. Sustain. Energy Rev., 14, 629, 10.1016/j.rser.2009.10.004 Jang, 2004, Role of Brownian motion in the enhanced thermal conductivity of nanofluids, Appl. Phys. Lett., 84, 4316, 10.1063/1.1756684 Koo, 2004, A new thermal conductivity model for nanofluids, J. Nanopart. Res., 6, 577, 10.1007/s11051-004-3170-5 Li, 2007, Mixing effect on the enhancement of the effective thermal conductivity of nanoparticle suspensions (nanofluids), Int. J. Heat Mass Transfer, 50, 4668, 10.1016/j.ijheatmasstransfer.2007.03.015 Seyf, 2012, Analysis of Brownian motion and particle size effects on the thermal behavior and cooling performance of microchannel heat sinks, Int. J. Therm. Sci., 58, 36, 10.1016/j.ijthermalsci.2012.02.022 Corcione, 2010, Heat transfer features of buoyancy-driven nanofluids inside rectangular enclosures differentially heated at the sidewalls, Int. J. Therm. Sci., 49, 1536, 10.1016/j.ijthermalsci.2010.05.005 Vajjha, 2009, Experimental determination of thermal conductivity of three nanofluids and development of new correlations, Int. J. Heat Mass Transfer, 52, 4675, 10.1016/j.ijheatmasstransfer.2009.06.027 Vajjha, 2010, Development of new correlations for convective heat transfer and friction factor in turbulent regime for nanofluids, Int. J. Heat Mass Transfer, 53, 4607, 10.1016/j.ijheatmasstransfer.2010.06.032 Islamoglu, 2003, The effect of channel height on the enhanced heat transfer characteristics in a corrugated heat exchanger channel, Appl. Therm. Eng., 23, 979, 10.1016/S1359-4311(03)00029-2 Mohammed, 2013, The effects of geometrical parameters of a corrugated channel with in out-of-phase arrangement, Int. Commun. Heat Mass Transfer, 40, 47, 10.1016/j.icheatmasstransfer.2012.10.022 Naphon, 2007, Laminar convective heat transfer and pressure drop in the corrugated channels, Int. Commun. Heat Mass Transfer, 34, 62, 10.1016/j.icheatmasstransfer.2006.09.003 Naphon, 2007, Heat transfer characteristics and pressure drop in channel with V corrugated upper and lower plates, Energy Convers. Manage., 48, 1516, 10.1016/j.enconman.2006.11.020 Naphon, 2008, Effect of corrugated plates in an in-phase arrangement on the heat transfer and flow developments, Int. J. Heat Mass Transfer, 51, 3963, 10.1016/j.ijheatmasstransfer.2007.11.050 Naphon, 2009, Effect of wavy plate geometry configurations on the temperature and flow distributions, Int. Commun. Heat Mass Transfer, 36, 942, 10.1016/j.icheatmasstransfer.2009.05.007 Naphon, 2008, Numerical analysis on the fluid flow and heat transfer in the channel with V-shaped wavy lower plate, Int. Commun. Heat Mass Transfer, 35, 839, 10.1016/j.icheatmasstransfer.2008.03.010 Tanda, 2004, Heat transfer in rectangular channels with transverse and V-shaped broken ribs, Int. J. Heat Mass Transfer, 47, 229, 10.1016/S0017-9310(03)00414-9 Kwon, 2008, Flow and heat/mass transfer in a wavy duct with various corrugation angles in two dimensional flow regimes, Heat Mass Transfer, 45, 157, 10.1007/s00231-008-0422-4 Pham, 2008, Turbulent heat and mass transfer in sinusoidal wavy channels, Int. J. Heat Fluid Flow, 29, 1240, 10.1016/j.ijheatfluidflow.2008.04.002 Jaurker, 2006, Heat transfer and friction characteristics of rectangular solar air heater duct using rib-grooved artificial roughness, Sol. Energy, 80, 895, 10.1016/j.solener.2005.08.006 Jiao, 2007, Evaporation heat transfer characteristics of a grooved heat pipe with micro-trapezoidal grooves, Int. J. Heat Mass Transfer, 50, 2905, 10.1016/j.ijheatmasstransfer.2007.01.009 Gupta, 2008, Thermohydraulic performance of a periodic trapezoidal channel with a triangular cross-section, Int. J. Heat Mass Transfer, 51, 2925, 10.1016/j.ijheatmasstransfer.2007.09.017 Sadasivam, 1999, Fully developed forced convection through trapezoidal and hexagonal ducts, Int. J. Heat Mass Transfer, 42, 4321, 10.1016/S0017-9310(99)00091-5 Qu, 2000, Heat transfer for water flow in trapezoidal silicon microchannels, Int. J. Heat Mass Transfer, 43, 3925, 10.1016/S0017-9310(00)00045-4 Zhou, 2012, Experimental investigations of thermal and flow characteristics of curved trapezoidal winglet type vortex generators, Appl. Therm. Eng., 37, 241, 10.1016/j.applthermaleng.2011.11.024 Pantzali, 2009, Investigating the efficacy of nanofluids as coolants in plate heat exchangers (PHE), Chem. Eng. Sci., 64, 3290, 10.1016/j.ces.2009.04.004 Heidary, 2010, Effect of nano-particles on forced convection in sinusoidal-wall channel, Int. Commun. Heat Mass Transfer, 37, 1520, 10.1016/j.icheatmasstransfer.2010.08.018 Heidary, 2012, Heat transfer enhancement in a channel with block (s) effect and utilizing nano-fluid, Int. J. Therm. Sci., 57, 163, 10.1016/j.ijthermalsci.2012.02.001 Pandey, 2012, Experimental analysis of heat transfer and friction factor of nanofluid as a coolant in a corrugated plate heat exchanger, Exp. Therm. Fluid Sci., 38, 248, 10.1016/j.expthermflusci.2011.12.013 Javadi, 2013, The effects of nanofluid on thermophysical properties and heat transfer characteristics of a plate heat exchanger, Int. Commun. Heat Mass Transfer, 44, 58, 10.1016/j.icheatmasstransfer.2013.03.017 Ahmed, 2012, Numerical investigations on the heat transfer enhancement in a wavy channel using nanofluid, Int. J. Heat Mass Transfer, 55, 5891, 10.1016/j.ijheatmasstransfer.2012.05.086 Ahmed, 2011, Numerical investigations of flow and heat transfer enhancement in a corrugated channel using nanofluid, Int. Commun. Heat Mass Transfer, 38, 1368, 10.1016/j.icheatmasstransfer.2011.08.013 Ahmed, 2013, Effects of geometrical parameters on the flow and heat transfer characteristics in trapezoidal-corrugated channel using nanofluid, Int. Commun. Heat Mass Transfer, 42, 69, 10.1016/j.icheatmasstransfer.2012.12.012 Ahmed, 2014, Effect of corrugation profile on the thermal–hydraulic performance of corrugated channels using CuO–water nanofluid, Case Stud. Therm. Eng., 4, 65, 10.1016/j.csite.2014.07.001 Tiwari, 2014, Numerical investigation of heat transfer and fluid flow in plate heat exchanger using nanofluids, Int. J. Therm. Sci., 85, 93, 10.1016/j.ijthermalsci.2014.06.015 Khoshvaght-Aliabadi, 2014, Wavy channel and different nanofluids effects on performance of plate-fin heat exchangers, J. Thermophys. Heat Transfer, 1 Versteeg, 1995 Fluent 6 user's Guide, Lebanon, NH, Fluent Insc., 2000. Launder, 1974, The numerical computation of turbulent flows, Comput. 7 Meth. Appl. Mech. Eng., 3, 269, 10.1016/0045-7825(74)90029-2 Hesselgreaves, 2001