Current developments and challenges in building automation

Stefan Soucek1, Gerhard Zucker2
1LOYTEC electronics GmbH, Blumengasse 35, 1170, Wien, Österreich
2Energy Department, Austrian Institute of Technology, Giefinggasse 2, 1210, Wien, Österreich

Tóm tắt

Từ khóa


Tài liệu tham khảo

Advanced building systems (2003): A technical guide for architects and engineers. Basel: Birkhäuser.

ANSI/ASHRAE Standard 55 (2010): thermal environmental conditions for human occupancy.

ANSI/CEA-852-B (2010): Tunneling device area network protocols over Internet protocol channels, Aug. 2010.

ANSI/EIA/CEA-709.1-A (1999): Control network protocol specification.

BACnet (2010): A data communication protocol for building automation and control networks, ANSI/ASHRAE Std. 135.

Burgstaller, W., Soucek, S., Palensky, P. (2005): Current challenges in abstracting datapoints. In Proc. of 6th IFAC international conference on fieldbus systems and their applications (pp. 40–47).

Dietrich, D., Bruckner, D., Zucker, G., Palensky, P. (2010): Communication and computation in buildings: a short introduction and overview. IEEE Trans. Ind. Electron., 57, 3577–3584.

Directive 2010/31/EU of the European Parliament and of the Council of 19 May 2010 on the energy performance of buildings (recast). Off. J. Eur. Union, 31, 2010.

EN 50090:2011: Home and Building Electronic Systems (HBES).

EN 13321-2:2005: Open data communication in building automation, controls and building management—home and building electronic systems—Part 2: KNXnet/IP communication.

EN 1434-3:1997: Heat meters—data exchange and interfaces.

Granzer, W., Praus, F., Kastner, W. (2010): Security in building automation systems. IEEE Trans. Ind. Electron., 57(11), 3622–3630.

IEC 60929:2003: AC-supplied electronic ballasts for tubular fluorescent lamps.

ISO 16484-2:2004: Building automation and control systems (BACS)—Part 2: Hardware.

ISO 16484-5:2010: Building automation and control systems—Part 5: Data communication protocol.

ISO 50001:2011: Energy management systems—requirements with guidance for use.

ISO/IEC 14543:2012: Information technology—home electronic system (HES) architecture.

ISO/IEC 14908:2012: Information technology—control network protocol.

Kastner, W., Neugschwandtner, G., Soucek, S., Newmann, H. M. (2005): Communication systems for building automation and control. Proc. IEEE, 93(6), 1178–1203.

Newman, H. M. (1994): Direct digital control of building systems: theory and practice. New York: Wiley.

OPC Foundation (2005): OPC XMLDA 1.00 Specification. www.opcfoundation.org .

Open building information exchange (2012): www.obix.org .

Palensky, P., Dietrich, D. (2011): Demand side management: demand response, intelligent energy systems, and smart loads. IEEE Trans. Ind. Inform., 7, 381–388.

Rubio, B., Fuertes, J. M., Kahoraho, E., Perez Arzoz N. (1999): Performance evaluation of four field buses. In Proceedings of 7th IEEE international conference on emerging technologies and factory automation.

The SMI Group (2012): www.smi-group.com .

Thuillard, M., Ryser, P., Pfister G. (2001): Life safety and security systems. In O. Gassmann, H. Meixner (Eds.), Sensors in intelligent buildings. Sensors applications. Weinheim: Wiley-VCH.

Wong, J. K. W., Li, H., Wang, S. W. (2005): Intelligent building research: A review. Autom. Constr., 14(1), 143–159.

Zucker, G., Hettfleisch, C. (2010): Using simulation for optimized building operation. In Proceedings of the e-nova 2010, Pinkafeld, Austria.