Comparative Experiments on a Self-priming Pump Delivering Water Medium During Rapid and Slow Starting Periods
Iranian Journal of Science and Technology, Transactions of Mechanical Engineering - Tập 45 - Trang 1007-1019 - 2020
Tóm tắt
This paper presents an experiment on the transient hydraulic performance of a self-priming pump for transporting clear water under fast and slow start-up states. In the experiment, five typical working conditions are set, and the evolution of preset rotating speed increases linearly. The similarities and differences between fast and slow start-up states are analyzed in detail. Results show an overall flow volume curve that presents three segment evolution characteristics in the start-up process. The inlet static pressure exhibits three drops and two rises in the fast start-up state and two drops and two rises in the slow start-up state. The dimensionless discharge coefficient is closely related to steady flow condition. The dimensionless head coefficient has little correlation with steady flow condition. The dimensionless power coefficient is almost independent of steady flow condition. The pump similarity law is especially unsuitable for the first half of the start-up process when the steady flow volume is small as well as for the latter half of the process when the steady flow volume is large. In the start-up process, the parameters can be arranged from serious to slight under the influence as follows: flow volume, rotating speed, and head of delivery.
Tài liệu tham khảo
Bai L, Zhou L, Jiang X et al (2019) Vibration in a multistage centrifugal pump under varied conditions. Shock Vib 2057031:1–9
Chalghoum I, Elaoud S, Akrout M et al (2016) Transient behavior of a centrifugal pump during starting period. Appl Acoust 109:82–89
Dazin A, Caignaert G, Bois G (2007) Transient behavior of turbomachineries: applications to radial flow pump startups. J Fluids Eng 129(11):1436–1444
Duplaa S, Coutier-Delgosha O, Dazin A et al (2010) Experimental study of a cavitating centrifugal pump during fast startups. J Fluids Eng 132(2):021301.1-12
Duplaa S, Coutier-Delgosha O, Dazin A et al (2013) X-ray measurements in cavitating centrifugal pump during fast start-ups. J Fluids Eng 135(4):041204.1-9
Elaoud S, Hadj-Taieb E (2011) Influence of pump starting times on transient flows in pipes. Nucl Eng Des 241:3624–3631
Farhadi K (2011) Transient behaviour of a parallel pump in nuclear research reactors. Prog Nucl Energy 53:195–199
Farhadi K, Bousbia-Salah A, D’Auria F (2007) A model for the analysis of pump start-up transients in Tehran Research Reactor. Prog Nucl Energy 49(7):499–510
Gao H, Gao F, Zhao X et al (2013) Analysis of reactor coolant pump transient performance in primary coolant system during start-up period. Ann Nucl Energy 54:202–208
Grover R, Koranne S (1981) Analysis of pump start-up transient. Nucl Eng Des 67:137–141
Guo X, Chen H, Zhu B (2012) Numerical simulation for centrifugal pump during starting period. J Shanghai Univ (Nat Sci) 18(3):288–292
Li W, Zhang Y (2016) Centrifugal oil pump theory and application. Jiangsu University Press, Zhenjiang, pp 32–33
Li Z, Wu D, Wang L et al (2010) Numerical simulation of the transient flow in a centrifugal pump during starting period. J Fluids Eng 132(8):081102.1-8
Li H, Dehuai X, Qin T et al (2013) Numerical simulation on gas-liquid two-phase flow of self-priming pump during starting period. Trans Chin Soc Agric Eng 29(3):77–83
Li W, Ji L, Shi W et al (2016) Experimental study on orbit of shaft centerline of mixed-flow pump during starting period. J Mech Eng 52(22):168–177
Li X, Gao P, Zhu Z et al (2018) Effect of the blade loading distribution on hydrodynamic performance of a centrifugal pump with cylindrical blades. J Mech Sci Technol 32(3):1161–1170
Liu Y, Tan L (2018) Tip clearance on pressure fluctuation intensity and vortex characteristic of a mixed flow pump as turbine at pump mode. Renew Energy 129:606–615
Liu Q, Ye J, Zhang G et al (2019) Study on the metrological performance of a swirlmeter affected by flow regulation with a sleeve valve. Flow Meas Instrum 67:83–94
Shao J, Dong J, Chen T et al (2009) Numerical simulation of fire pump’s transient performance during the starting period. J Hydroelectr Eng 28(4):181–186
Tsukamoto H, Ohashi H (1982) Transient characteristics of a centrifugal pump during startup period. J Fluids Eng 104(1):6–13
Yang S (2015) Investigation on the transient characteristics of the pump system using MOC-CFD coupled method. Zhejiang University, Hangzhou
Zhang Y, Zhu Z, Dou H et al (2015) A generalized Euler equation to predict theoretical head of turbomachinery. Int J Fluid Mech Res 42(1):26–38
Zhang F, Fleder A, Böhle M et al (2016a) Effect of blade profile for suction side on the performance of a side channel pump. Proc Inst Mech Eng Part A J Power Energy 230(6):586–597
Zhang Y, Zhu Z, Li W (2016b) Experiments on transient performance of a low specific speed centrifugal pump with open impeller. J Power Energy 230(7):648–659
Zhang Y, Zhu Z, Dou H et al (2017) Numerical investigation of transient flow in a prototype centrifugal pump during startup period. Int J Turbo Jet Eng 34(2):167–176