Combustion, performance and emissions characteristics of a spark-ignition engine fueled with isopropanol-n-butanol-ethanol and gasoline blends
Tóm tắt
Từ khóa
Tài liệu tham khảo
Yacoub, 1998, The performance and emission characteristics of C1–C5 alcohol-gasoline blends with matched oxygen content in a single-cylinder spark ignition engine, Proc Inst Mech Eng A – J Pow, 212, 363, 10.1243/0957650981536934
Kumar, 2013, Advances in diesel–alcohol blends and their effects on the performance and emissions of diesel engines, Renew Sustain Energy Rev, 22, 46, 10.1016/j.rser.2013.01.017
Liu, 2016, Development of a skeletal mechanism for biodiesel blend surrogates with varying fatty acid methyl esters proportion, Appl Energy, 162, 278, 10.1016/j.apenergy.2015.10.090
Gu, 2012, Emission characteristics of a spark-ignition engine fuelled with gasoline-n-butanol blends in combination with EGR, Fuel, 93, 611, 10.1016/j.fuel.2011.11.040
Farkade, 2012, Experimental investigation of methanol, ethanol and butanol blends with gasoline on SI engine, Int J Emerg Technol Adv Eng, 2, 205
Hsieh, 2002, Engine performance and pollutant emission of an SI engine using ethanol–gasoline blended fuels, Atmos Environ, 36, 403, 10.1016/S1352-2310(01)00508-8
Jin, 2011, Progress in the production and application of n-butanol as a biofuel, Renew Sustain Energy Rev, 15, 4080, 10.1016/j.rser.2011.06.001
Doğan, 2011, The influence of n-butanol/diesel fuel blends utilization on a small diesel engine performance and emissions, Fuel, 90, 2467, 10.1016/j.fuel.2011.02.033
Wu, 2008, Assessment of potential life-cycle energy and greenhouse gas emission effects from using corn-based butanol as a transportation fuel, Biotechnol Prog, 24, 1204, 10.1002/btpr.71
Zheng, 2015, Effect of two-stage injection on combustion and emissions under high EGR rate on a diesel engine by fueling blends of diesel/gasoline, diesel/n-butanol, diesel/gasoline/n-butanol and pure diesel, Energy Convers Manage, 90, 1, 10.1016/j.enconman.2014.11.011
Zheng, 2015, Experimental study on diesel conventional and low temperature combustion by fueling four isomers of butanol, Fuel, 141, 109, 10.1016/j.fuel.2014.10.053
Liu, 2014, Time-resolved spray, flame, soot quantitative measurement fueling n-butanol and soybean biodiesel in a constant volume chamber under various ambient temperatures, Fuel, 133, 317, 10.1016/j.fuel.2014.05.038
Liu, 2012, Soot emissions of various oxygenated biofuels in conventional diesel combustion and low-temperature combustion conditions, Energ Fuel, 26, 1900, 10.1021/ef201720d
Liu, 2013, Effects of n-butanol, 2-butanol, and methyl octynoate addition to diesel fuel on combustion and emissions over a wide range of exhaust gas recirculation (EGR) rates, Appl Energy, 112, 246, 10.1016/j.apenergy.2013.06.023
Liu, 2014, Experimental and simulation investigation of the combustion characteristics and emissions using n-butanol/biodiesel dual-fuel injection on a diesel engine, Energy, 74, 741, 10.1016/j.energy.2014.07.041
Green, 2011, Fermentative production of butanol—the industrial perspective, Curr Opin Biotechnol, 22, 337, 10.1016/j.copbio.2011.02.004
Chang, 2013, Green energy: water-containing acetone–butanol–ethanol diesel blends fueled in diesel engines, Appl Energy, 109, 182, 10.1016/j.apenergy.2013.03.086
Wu, 2015, Impacts of Acetone–Butanol–Ethanol (ABE) ratio on spray and combustion characteristics of ABE–diesel blends, Appl Energy, 149, 367, 10.1016/j.apenergy.2014.11.053
Zhou N, Wu H, Lee CF, Wang Q, Huo M, Wang P. Different percentage of Acetone-Butanol-Ethanol (ABE) and diesel blends at low temperature condition in a constant volume chamber. SAE Technical Paper 2014: 2014-01-1257.
Nithyanandan, 2016, Improved SI engine efficiency using Acetone–Butanol–Ethanol (ABE), Fuel, 174, 333, 10.1016/j.fuel.2016.01.001
Li, 2016, Effect of water-containing acetone–butanol–ethanol gasoline blends on combustion, performance, and emissions characteristics of a spark-ignition engine, Energ Convers Manage, 117, 21, 10.1016/j.enconman.2016.02.083
de Vrije, 2013, “In situ” removal of isopropanol, butanol and ethanol from fermentation broth by gas stripping, Bioresource Technol, 137, 153, 10.1016/j.biortech.2013.03.098
Collas, 2012, Simultaneous production of isopropanol, butanol, ethanol and 2, 3-butanediol by Clostridium acetobutylicum ATCC 824 engineered strains, AMB Express, 2, 45, 10.1186/2191-0855-2-45
Jang, 2013, Metabolic engineering of Clostridium acetobutylicum for the enhanced production of isopropanol-butanol-ethanol fuel mixture, Biotechnol Prog, 29, 1083, 10.1002/btpr.1733
Dusséaux, 2013, Metabolic engineering of Clostridium acetobutylicum ATCC 824 for the high-yield production of a biofuel composed of an isopropanol/butanol/ethanol mixture, Metab Eng, 18, 1, 10.1016/j.ymben.2013.03.003
Lee, 2012, Metabolic engineering of Clostridium acetobutylicum ATCC 824 for isopropanol-butanol-ethanol fermentation, Appl Environ Microbiol, 78, 1416, 10.1128/AEM.06382-11
Rassadin, 2006, Problems in production of high-octane, unleaded automotive gasolines, Chem Technol Fuels Oil, 42, 235, 10.1007/s10553-006-0064-5
Graham, 2008, Emissions from light duty gasoline vehicles operating on low blend ethanol gasoline and E85, Atmos Environ, 42, 4498, 10.1016/j.atmosenv.2008.01.061
Veloo, 2010, A comparative experimental and computational study of methanol, ethanol, and n-butanol flames, Combust Flame, 157, 1989, 10.1016/j.combustflame.2010.04.001
Chong, 2011, Measurements of laminar flame speeds of acetone/methane/air mixtures, Combust Flame, 158, 490, 10.1016/j.combustflame.2010.09.019
Van Geem, 2012, An experimental and kinetic modeling study of pyrolysis and combustion of acetone–butanol–ethanol (ABE) mixtures, Combust Sci Technol, 184, 942, 10.1080/00102202.2012.663987
Wallner, 2013, Analytical assessment of C2–C8 alcohols as spark-ignition engine fuels
Veloo, 2011, Studies of n-propanol, iso-propanol, and propane flames, Combust Flame, 158, 501, 10.1016/j.combustflame.2010.10.001
Sileghem, 2013, Laminar burning velocity of gasoline and the gasoline surrogate components iso-octane, n-heptane and toluene, Fuel, 112, 355, 10.1016/j.fuel.2013.05.049
Nithyanandan K, Zhang J, Li Y, Wu H, Lee CF. Investigating the impact of acetone on the performance and emissions of acetone-butanol-ethanol (ABE) and gasoline blends in an SI engine. SAE Technical Papers 2015:2015-01-0909.
Szwaja, 2010, Combustion of n-butanol in a spark-ignition IC engine, Fuel, 89, 1573, 10.1016/j.fuel.2009.08.043
Tian, 2010, Laminar burning velocities of 2, 5-dimethylfuran compared with ethanol and gasoline, Energy Fuel, 24, 3898, 10.1021/ef100452c
Ghadikolaei, 2014, Effect of cylinder air pressure and fuel injection pressure on combustion characteristics of direct injection (di) diesel engine fueled with diesel and gasoline, Int J Appl Innovat Eng Manage, 3, 234
Feng, 2015, Combustion and emissions study on motorcycle engine fueled with butanol-gasoline blend, Renew Energy, 81, 113, 10.1016/j.renene.2015.03.025
Siwale, 2014, Performance, combustion and emission characteristics of n-butanol additive in methanol–gasoline blend fired in a naturally-aspirated spark ignition engine, Fuel Process Technol, 118, 318, 10.1016/j.fuproc.2013.10.007
Nakata K, Utsumi S, Ota A, Kawatake K, Kawai T, Tsunooka T. The effect of ethanol fuel on a spark ignition engine. SAE Technical Paper 2006:2006-01-3380.
Zhang J, Nithyanandan K, Li Y, Lee CF, Huang Z. Comparative study of high-alcohol-content gasoline blends in an SI engine. SAE Technical Paper 2015:2015-01-0891.
Can, 2004, Effects of ethanol addition on performance and emissions of a turbocharged indirect injection diesel engine running at different injection pressures, Energy Convers Manage, 45, 2429, 10.1016/j.enconman.2003.11.024
Koç, 2009, The effects of ethanol–unleaded gasoline blends on engine performance and exhaust emissions in a spark-ignition engine, Renew Energy, 34, 2101, 10.1016/j.renene.2009.01.018
Cheng WK, Hamrin D, Heywood JB, Hochgreb S, Min K, Norris M. An overview of hydrocarbon emissions mechanisms in spark-ignition engines. SAE Technical Paper 1993:932708.
Masum, 2013, Effect of ethanol–gasoline blend on NOx emission in SI engine, Renew Sustain Energy Rev, 24, 209, 10.1016/j.rser.2013.03.046
Aleiferis, 2013, Characterisation of flame development with ethanol, butanol, iso-octane, gasoline and methane in a direct-injection spark-ignition engine, Fuel, 109, 256, 10.1016/j.fuel.2012.12.088
Deng, 2013, The heat release analysis of bio-butanol/gasoline blends on a high speed SI (spark ignition) engine, Energy, 60, 230, 10.1016/j.energy.2013.07.055
Kar, 2008, Measurement of vapor pressures and enthalpies of vaporization of gasoline and ethanol blends and their effects on mixture preparation in an SI engine, SAE Int J Fuel Lubricants, 1, 132, 10.4271/2008-01-0317
Gauthier, 2004, Shock tube determination of ignition delay times in full-blend and surrogate fuel mixtures, Combust Flame, 139, 300, 10.1016/j.combustflame.2004.08.015
Heywood, 1988
Dunn-Rankin, 2011
Heywood, 1976, Pollutant formation and control in spark-ignition engines, Prog Energy Combust, 1, 135, 10.1016/0360-1285(76)90012-5