CFRP drilling: Fundamental study of local feed force and consequences on hole exit damage.

Persson, 1997, Effects of hole machining defects on strength and fatigue life of composite laminates, Compos. Part A: Appl. Sci. Manuf., 28, 141, 10.1016/S1359-835X(96)00106-6

Wang, 1995, Orthogonal cutting mechanisms of graphite/epoxy composite. Part I: unidirectional laminate, Int. J. Mach. Tools Manuf., 35, 1623, 10.1016/0890-6955(95)00014-O

Arola, 1996, Chip formation in orthogonal trimming of graphite/epoxy composite, Compos. Part A: Appl. Sci. Manuf., 27, 121, 10.1016/1359-835X(95)00013-R

Krishnaraj, 2012, Optimization of machining parameters at high speed drilling of carbon fiber reinforced plastic (CFRP) laminates, Compos. Part B: Eng., 43, 1791, 10.1016/j.compositesb.2012.01.007

Piquet, 2000, Experimental analysis of drilling damage in thin carbon/epoxy plate using special drills, Compos. Part A: Appl. Sci. Manuf., 31, 1107, 10.1016/S1359-835X(00)00069-5

Davim, 2004, Experimental study of drilling glass fiber reinforced plastics (GFRP) manufactured by hand lay-up, Compos. Sci. Technol., 64, 289, 10.1016/S0266-3538(03)00253-7

Zitoune, 2007, Numerical prediction of the thrust force responsible of delamination during the drilling of the long-fibre composite structures, Compos. Part A: Appl. Sci. Manuf., 38, 858, 10.1016/j.compositesa.2006.07.009

Tsao, 2008, Investigation into the effects of drilling parameters on delamination by various step-core drills, J. Mater. Process. Technol., 206, 405, 10.1016/j.jmatprotec.2007.12.057

Ramulu, 2001, A study on the drilling of composite and titanium stacks, Compos. Struct., 54, 67, 10.1016/S0263-8223(01)00071-X

Mondelin, 2010, Characterisation of friction properties between a laminated carbon fibres reinforced polymer and a monocrystalline diamond under dry or lubricated conditions, Tribol. Int., 43, 1665, 10.1016/j.triboint.2010.03.015

McKenzie, 1960, Fundamental aspects of the wood cutting process, For. Prod. J., Issue 10, 447

Ghidossi, 2003

Claudin, 2008, Correlation between drill geometry and mechanical forces in MQL conditions, Mach. Sci. Technol., 12, 133, 10.1080/10910340801918275