CFD modelling of subcooled boiling—Concept, validation and application to fuel assembly design

Anglart, 1997, CFD prediction of flow and phase distribution in fuel assemblies with spacers, Nucl. Eng. Des., 177, 215, 10.1016/S0029-5493(97)00195-7

Antal, 1991, Analysis of phase distribution in fully developed laminar bubbly two-phase flow, Int. J. Multiphase Flow, 7, 635, 10.1016/0301-9322(91)90029-3

Bartel, 2001, Interfacial area measurements in subccoled flow boiling, Nucl. Eng. Des., 210, 135, 10.1016/S0029-5493(01)00415-0

Bartolomej, 1967, Experimental study of true void fraction when boiling subcooled water in vertical tubes, vol. 14

Bartolomej, 1982, An experimental investigation of true volumetric vapour content with subcooled boiling in tubes, vol. 29

Burns, 2004, The favre averaged drag model for turbulence dispersion in Eulerian multi-phase flows

Cole, 1960, A photographic study of pool boiling in the region of the critical heat flux, AIChE J., 6, 533, 10.1002/aic.690060405

Egorov, Y., Menter, F., 2004. Experimental Implementation of the RPI Wall Boiling Model in CFX-5.6. Technical Report ANSYS/TR-04-10. ANSYS Germany GmbH.

Ishii, 1979, Drag coefficient and relative velocity in bubbly, droplet or particulate flows, AIChE J., 25, 843, 10.1002/aic.690250513

Kader, 1981, Temperature and concentration profiles in fully turbulent boundary layers, Int. J. Heat Mass Transfer, 24, 1541, 10.1016/0017-9310(81)90220-9

Končar, 2004, Modelling of local two-phase flow parameters in upward subcooled flow boiling at low pressure, Int. J. Heat Mass Transfer, 47, 1499, 10.1016/j.ijheatmasstransfer.2003.09.021

Končar, 2005

Končar, 2005, Two-phase wall function for modeling of turbulent boundary layer in subcooled boiling flow

Kurul, 1991, On the modeling of multidimensional effects in boiling channels

Lemmert, 1977, Influence of flow velocity on surface boiling heat transfer coefficient, 237

Lucas, 2004, Models for the forces acting on bubbles in comparison with experimental data for vertical pipe flow

Lucas, 2005, Development of co-current air-water flow in a vertical pipe, Int. J. Multiphase Flow, 31, 1304, 10.1016/j.ijmultiphaseflow.2005.07.004

Menter, F.R., 2003. Personal communication.

Menter, 1994, Two-equation eddy-viscosity turbulence models for engineering applications, AIAA J., 32, 8, 10.2514/3.12149

Mikic, 1969, A new correlation of pool-boiling data including the fact of heating surface characteristics, ASME J. Heat Trans., 91, 245, 10.1115/1.3580136

Pierre, 1966, Vapor volume profiles in developing two-phase flow, Int. J. Heat Mass Transfer, 10, 237, 10.1016/0017-9310(67)90101-9

Prasser, 2005, Evolution of the structure of a gas-liquid two-phase flow in a large vertical pipe

Ranz, 1952, Evaporation from drops, Chem. Eng. Progr., 48, 141

Roy, 2002, Turbulent subcooled boiling flow—experiments and simulations, J. Heat Trans., 124, 73, 10.1115/1.1418698

Sato, 1981, Momentum and heat transfer in two-phase bubble flow, Int. J. Multiphase Flow, 7, 167, 10.1016/0301-9322(81)90003-3

Tolubinsky, V.I., Kostanchuk, D.M., 1970. Vapour bubbles groth rate and heat transfer intensity at subcooled water boiling; Heat Transfer 1970, Preprints of papers presented at the 4th International Heat Transfer Conference, vol. 5, Paris (Paper No. B-2.8).

Tomiyama, 1995, Effects of Eötvös number and dimensionless liquid volumetric flux on lateral motion of a bubble in a laminar duct flow, Adv. Multiphase Flow, 3

Tomiyama, 1998, Struggle with computational bubble dynamics

Ünal, 1976, Maximum bubble diameter, maximum bubble growth time and bubble growth rate, Int. J. Heat Mass Trans., 19, 643, 10.1016/0017-9310(76)90047-8

Wintterle, T. 2004. Development of a numerical boundary condition for the simulation of nucleate boiling at heated walls. Diploma Thesis University. Stuttgart (IKE-8-D-014).