Anti-coking performance of Cr/CeO2 coating prepared by high velocity oxygen fuel spraying

Reyniers, 1995, Influence of metal surface and sulfur addition on coke deposition in the thermal cracking of hydrocarbons, Ind. Eng. Chem. Res., 34, 773, 10.1021/ie00042a009 Leftin, 1987, Coking rates in a laboratory pyrolysis furnace: liquid petroleum feedstocks, Ind. Eng. Chem. Res., 26, 1003, 10.1021/ie00065a026 Yin, 2021, Influencing factors and evaluation system for CarbonCalcium pellet performance in a pyrolysis furnace, Energy, 214, 10.1016/j.energy.2020.118991 Chan, 1998, Suppression of coke formation in the steam cracking of alkanes: Ethane and propane, Ind. Eng. Chem. Res., 37, 901, 10.1021/ie9704511 Kumar, 1999, Triethyl phosphite additive-based fouling inhibition studies, Ind. Eng. Chem. Res., 38, 1364, 10.1021/ie980349j Li, 2010, Stability of MnCr2O4 spinel and Cr2O3 in high temperature carbonaceous environments with varied oxygen partial pressures, Corros. Sci., 52, 2481, 10.1016/j.corsci.2010.02.040 Li, 2011, High temperature carburization behaviour of Mn-Cr-O spinel oxides with varied concentrations of manganese, Corros. Sci., 53, 2097, 10.1016/j.corsci.2011.02.021 Schietekat, 2014, Swirl flow tube reactor technology: an experimental and computational fluid dynamics study, Chem. Eng. J., 238, 56, 10.1016/j.cej.2013.08.086 Van Cauwenberge, 2015 Bao, 2017, Insight into a high temperature selective oxidation of HP40 alloy under a H2-H2O environment, RSC Adv., 7, 8589, 10.1039/C6RA25933B Zhu, 2020, Atomic layer deposition of TiO2 thin films on the inner walls of steel tubes increases anti-coking properties, Acs Omega, 5, 32102, 10.1021/acsomega.0c05195 Zhang, 2016, Characterization of MOCVD TiO2 coating and its anti-coking application in cyclohexane pyrolysis, Surf. Coat. Technol., 296, 108, 10.1016/j.surfcoat.2016.04.011 Zhou, 2011, Anti-coking property of the SiO2/S coating during light naphtha steam cracking in a pilot plant setup, J. Anal. Appl. Pyrolysis, 90, 7, 10.1016/j.jaap.2010.09.011 Zhou, 2007, Study of anti-coking property of SiO2/S composite coatings deposited by atmospheric pressure chemical vapor deposition, Mater. Lett., 61, 5087, 10.1016/j.matlet.2007.04.048 Wang, 2013, Simulation of SiO2/S coating deposition in a pilot plant set-up for coking inhibition, Chem. Eng. Res. Des., 91, 120, 10.1016/j.cherd.2012.07.006 Yang, 2012, Preparation and anticoking performance of MOCVD alumina coatings for thermal cracking of hydrocarbon fuels under supercritical conditions, Ind. Eng. Chem. Res., 51, 1256, 10.1021/ie201978c Gong, 2020, Anti-coking application of TiO2-Al2O3 composite coating prepared by MOCVD, Trans. Inst. Met. Finish., 98, 37, 10.1080/00202967.2020.1692535 Tang, 2014, Influence of TiN coating on products distribution for hydrocarbon fuel cracking under high temperature and pressure, J. Anal. Appl. Pyrolysis, 107, 197, 10.1016/j.jaap.2014.03.003 Wigmans, 1983, Influence of pretreatment conditions on the activity and stability of sodium and potassium catalysts in carbon-steam reactions, Carbon, 21, 295, 10.1016/0008-6223(83)90094-5 Freriks, 1981, Potassium-catalysed gasification of carbon with steam: a temperature-programmed desorption and Fourier Transform infrared study, Fuel, 60, 463, 10.1016/0016-2361(81)90104-6 Golebiowski, 2004, Influence of potassium on the properties of steam reforming catalysts, React. Kinet. Catal. Lett., 82, 179, 10.1023/B:REAC.0000028820.04318.af Goswami, 2014, Failure of pyrolysis coils coated with anit-coking film in an ethylene cracking plant, Eng. Fail. Anal., 39, 181, 10.1016/j.engfailanal.2014.01.019 Mahamulkar, 2019, α-Alumina supported doped ceria catalysts for steam gasification and oxidation of radical coke, Chem. Eng. Res. Des., 151, 1, 10.1016/j.cherd.2019.08.010 Wang, 2021, Investigation into the anticoking performances of Sol-Gel-derived SiO2 and SiO2-CeO2 coatings during thermal pyrolysis of light naphtha, Energy Fuel, 35, 2562, 10.1021/acs.energyfuels.0c03229 Mahmoudi, 2018, Inhibition effect of CeO2 promoted SiO2 coating on coke growth during steam cracking of ethane, Chem. Eng. Res. Des., 136, 271, 10.1016/j.cherd.2018.05.040 Wenxiao, 2020, Study on the friction performance of cerium oxide on supersonic flame-sprayed WC-10Co-4Cr coating, Coatings, 11 Lin, 2021, The study of mechanical properties and corrosion behavior of the Fe-based amorphous alloy coatings using high velocity oxygen fuel spraying, J. Alloys Compd., 867, 10.1016/j.jallcom.2021.159132 Zhou, 2017, Annealing behavior of aluminum coating prepared by arc spraying on P355NL1 steel, Surf. Coat. Technol., 330, 53, 10.1016/j.surfcoat.2017.09.073 Katanoda, 2009, Mathematical modeling and experimental validation of the warm spray (two-stage HVOF) process, J. Therm. Spray Technol., 18, 401, 10.1007/s11666-009-9299-0 Xu, 2011, Microstructure and properties of Ni60 self-fluxing alloy coatings fabricated by spark plasma sintering, 639 Chen, 1992, Mechanism of alkali and alkaline-earth catalyzed gasification of graphite by Co2 and H2o studied by electron-microscopy, J. Catal., 138, 12, 10.1016/0021-9517(92)90003-Z Moulijn, 1995, Towards a unified theory of reactions of carbon with oxygen-containing molecules, Carbon, 33, 1155, 10.1016/0008-6223(95)00070-T Chen, 1997, Unified mechanism of alkali and alkaline earth catalyzed gasification reactions of carbon by CO2 and H2O, Energy Fuel, 11, 421, 10.1021/ef960099o Yin, 2017, Catalytic reactions of coke with dioxygen and steam over alkaline-earth-metal-doped cerium-zirconium mixed oxides, Appl. Catal. A Gen., 535, 17, 10.1016/j.apcata.2017.02.002 Sahoo, 2014, Photoluminescent carbon soot particles derived from controlled combustion of camphor for superhydrophobic applications, RSC Adv., 4, 11331, 10.1039/c3ra46193a