Analysis and design considerations of a load and line independent zero voltage switching full bridge DC/DC converter topology
Tóm tắt
The analysis and design of a zero voltage switching (ZVS) full bridge DC/DC power converter topology is presented in this paper. The converter topology presented here employs an asymmetrical auxiliary circuit consisting of a few passive components. With this auxiliary circuit, the full bridge converter can achieve ZVS independent of line and load conditions. The operating principle of the circuit is demonstrated, and the steady state analysis is performed. Based on the analysis, a criterion for optimal design is given. Experiment and simulation on a 350-400 V to 55 V, 500 W prototype converter operated at 100 kHz verify the design and show an overall efficiency of greater than 97% at full load.
Từ khóa
#Zero voltage switching #Bridge circuits #DC-DC power converters #Circuit topology #Independent component analysis #Switching converters #Steady-state #Performance analysis #Circuit simulation #Virtual prototypingTài liệu tham khảo
10.1109/28.216544
10.1109/63.97767
10.1109/PESC.1992.254692
10.1109/PESC.1992.254696
walters, 1988, a high density modulator power processor for distributed military power systems, Proc IEEE APEC 88 Rec, 403
fisher, 1988, a 500 khz, 250 w dc/dc converter with multiple outputs controlled by phase-shifted pwm and magnetic amplifiers, Proc High Freq Power Conv Conf, 100
10.1109/IECON.1995.483324
10.1109/APEC.1989.36994
10.1109/IAS.1990.152341
10.1109/IAS.1994.377564
10.1109/APEC.1991.146157
10.1109/APEC.1990.66420
10.1109/PESC.1998.701873