An experimental investigation of the performance boundaries of a solar water heating system

European Solar Thermal Energy Industry Federation (ESTIF), Solar Thermal Markets in Europe (Trends and Market Statistics 2006). <http://www.estif.org/fileadmin/downloads/Solar_Thermal_Markets_in_Europe_2006.pdf>, June 2007. Carboni, 2008, Solar thermal systems: advantages in domestic integration, Renewable Energy, V33, 1364, 10.1016/j.renene.2007.07.004 Ardente, 2005, Life cycle assessment of a solar thermal collector, Renewable Energy, V30, 1031, 10.1016/j.renene.2004.09.009 Michaelides, 1992, An investigation into the performance and cost effectiveness of thermosyphon solar water heaters, Renewable Energy, 2, 219, 10.1016/0960-1481(92)90035-2 C.M. Kemp, US Patent No. 451384, 1891. A.C. Arthur, A novel solar-savings fraction prediction methodology for integral passive solar water heaters, PhD Thesis, Cranfield Institute of Technology, UK, 1990. R.C. Lindsay, W.C. Thomas, Experimental investigation of test procedures for thermal performance of integral collector/storage solar water system, in: Proceedings of the ASME Solar Energy Conference, Knoxville, Tennessee, USA, 1985, pp. 349–58. Lavan, 1977, Experimental study of thermally stratified hot water storage tanks, Solar Energy, 19, 519, 10.1016/0038-092X(77)90108-6 Reiss, 1978, Breadbox designs, Alternative Sources of Energy, 46, 16 Eames, 1998, The effect of tank geometry on thermally stratified sensible heat storage subject to low Reynolds number flows, International Journal of Heat and Mass Transfer, 41, 2131, 10.1016/S0017-9310(97)00349-9 J.S. Tiller, V. Wochatz, Performance of integrated passive solar water heaters (Breadbox-type) under varying design conditions in the South-eastern US, in: Proceedings of the Seventh National Passive Solar Conference, Knoxville, Tennessee, USA, 1982, pp. 975–80. Grassie, 1977, The use of planar reflectors for increasing the energy yield of flat-plate collectors, Solar Energy, 19, 663, 10.1016/0038-092X(77)90027-5 Grimmer, 1978, Augmented solar energy collection using various planar reflective surfaces: theoretical calculations and experimental results, Solar Energy, 21, 497, 10.1016/0038-092X(78)90074-9 Larson, 1980, Concentration ratios for flat-plate solar collectors with adjustable mirrors, Journal of Energy, 4, 170, 10.2514/3.62470 Tabor, 1958, Stationary mirror systems for solar collectors, Solar Energy, 2, 27, 10.1016/0038-092X(58)90051-3 Taha, 1980, Effect of of-south orientation on optimum conditions for maximum solar energy absorbed by a flat-plate collector augmented by plane reflector, Solar Energy, 25, 373, 10.1016/0038-092X(80)90349-7 Smyth, 1999, A comparative performance rating for an integrated solar collector/storage vessel with inner sleeves to increase heat retention, Solar Energy, 291, 10.1016/S0038-092X(99)00027-4 Ghaddar, 1994, Stratified storage tank influence on performance of solar water heating system tested in Beirut, Renewable Energy, 4, 911, 10.1016/0960-1481(94)90225-9 Li, 2002, Performance study of a partitioned thermally stratified storage tank in a solar powered absorption air conditioning system, Applied Thermal Engineering, 22, 1207, 10.1016/S1359-4311(02)00048-0 Zachár, 2003, Numerical analyses of the impact of plates for thermal stratification inside a storage tank with upper and lower inlet flows, Solar Energy, 74, 287, 10.1016/S0038-092X(03)00188-9 Hegazy, 2002, Performance of an improved design for storage-type domestic electrical water-heaters, Applied Energy, 71, 287, 10.1016/S0306-2619(02)00006-5 Ulrike, 2005, Thermal stratification in small solar domestic storage tanks caused by draw-offs, Solar Energy, 78, 291, 10.1016/j.solener.2004.09.011 Knudsen, 2002, Consumers influence on the thermal performance of small SDHW systems – theoretical investigations, Solar Energy, 73, 33, 10.1016/S0038-092X(02)00018-X Duffie, 1991 Purohit, 2009, Instrumentation error analysis of a paraboloid concentrator type solar cooker, Energy for Sustainable Development, 13, 255, 10.1016/j.esd.2009.10.003