An Experimental and Numerical Investigation of the Vibrational Response of a Flanged Cylinder Structure
Tóm tắt
The paper presents a combined experimental and numerical investigation of the vibrational response of a flanged cylinder structure due to a time-harmonic point excitation. The principle focus of this study was to (1) determine the relative sensitivity of the vibrational response of the cylinder due to variations in the experimental configuration (such as using different vibrational sources, excitation points or complicating structural configurations), and (2) ascertain the level of detail required in the numerical models to accurately replicate the experimental results. Overall, good agreement was achieved between the measured and modelled mode shapes/frequencies up to approximately 1500 Hz, while the experimental results were shown to be largely insensitive to the excitation point or type of mechanical shaker employed. Comparative identification of the measured and modelled cylinder mode shapes allowed for other measured frequency response peaks which did not exhibit discernible modal patterns to be identified from the FEM analysis as either bending modes or internal plate modes for the structure. Finally, it was observed that the contact condition used to model the bolted plates in the structure had a significant effect on the predicted plate modal frequencies, while small amounts of mass loading in the experimental configuration were predicted to cause significant frequency shifts for certain modes.
Tài liệu tham khảo
Leissa, A.: Vibration of shells. The Acoustical Society of America, New York (1993)
Caresta, M., Kessissoglou, N., Tso, Y.: Low frequency structural and acoustic responses of a submarine hull. Acoust. Aust. 36(2), 47–52 (2008)
Kessissoglou, N.: A review of active control applied to plates and cylinders. Acoust. Aust. 34(2), 85–92 (2006)
Dylejko, P.G., Kessissoglou, N.J., Tso, Y., Norwood, C.J.: Optimisation of a resonance changer to minimise the vibration transmission in marine vessels. J. Sound Vib. 300, 101–116 (2007)
Merz, S., Oberst, S., Dylejko, P.G., Kessissoglou, N.J., Tso, Y.K., Marburg, S.: Development of coupled fe/be models to investigate the structural and acoustic responses of a submerged vessel. J. Comput. Acoust. 15(1), 23–47 (2007)
Merz, S., Kessissoglou, N.J., Kinns, R.: Influence of resonance changer parameters on the radiated sound power of a submarine. Acoust. Aust. 37(1), 12–17 (2009)
Wei, Y., Wang, Y., Ding, K., Fu, J.: Submarine underwater structure-borne noise and flow noise due to propeller excitation. Acoust. Aust. 40(2), 122–127 (2012)
Chen, L.H., Schweikert, D.G.: Sound radiation from an arbitrary body. J. Acoust. Soc. Am. 35(10), 1626–1632 (1963)
Harari, A., Sandman, B.E., Zaldonis, J.A.: Analytical and experimental determination of the vibration and pressure radiation from a submerged, stiffened cylindrical shell with two endplates. J. Acoust. Soc. Am. 95(6), 3360–3368 (1994)
Homm, A., Ehrlich, J., Peine, H., Wiesner, H.: Experimental and numerical investigation of a complex submerged structure: part I: modal analysis. Acta Acust. United Acust. 89, 61–70 (2003a)
Homm, A., Ehrlich, J., Peine, H., Wiesner, H.: Experimental and numerical investigation of a complex submerged structure: part II: sound radiation. Acta Acust. United Acust. 89, 71–77 (2003b)
Kwak, M.K., Yang, D.: Active vibration control of a ring-stiffened cylindrical shell in contact with unbounded external fluid and subjected to harmonic disturbance by piezoelectric sensor and actuator. J. Sound Vib. 332, 4775–4797 (2013)
Kim, H.S., Suhn, J.W., Jeon, J., Choi, S.: Reduction of the radiating sound of a submerged finite cylindrical shell structure by active vibration control. Sensors 13, 2132–2147 (2013)
Norwood, C.: The free vibration behaviour of ring stiffened cylinders—a critical review of the unclassified literature. Technical report, DSTO Aeronautical and Maritime Research Laboratory, Melbourne (1995)
Sinha, G., Mukhopadhyay, M.: Static and dynamic analysis of stiffened shells—a review. Proc. Indian Natl. Sci. Acad. 61(3), 195–219 (1995)
Qatu, M.S.: Recent research advances in the dynamic behaviour of shells: 1989–2000. part 1: laminated composite shells. Appl. Mech. Rev. 55(4), 325–350 (2002a)
Qatu, M.S., Sullivan, R.W., Wang, W.: Recent research advances in the dynamic behaviour of composite shells: 2002–2009. Compos. Struct. 93(1), 14–31 (2010)
Qatu, M.S.: Recent research advances in the dynamic behaviour of shells: 1989–2000. Part 2: homogeneous shells. Appl. Mech. Rev. 55(5), 415–434 (2002b)
Liu, W., Pan, J., Matthews, D.: Measurement of sound-radiation from a torpedo-shaped structure subject to an axial excitation. In: Proceedings of the 20th International Congress on Acoustics, ICA 2010, Sydney, Australia (2010)
Pan, J., Matthews, D., Xiao, H., Munyard, A., Wang, Y., Jin, M., Liu, W., Sun, H.: Analysis of underwater vibration of a torpedo-shaped structure subjected to an axial excitation. In: Proceedings of Acoustics 2011, Gold Coast, Australia (2011)
Leader, J., Pan, J., Dylejko, P., Matthews, D.: Experimental investigation into sound and vibration of a torpedo-shaped structure under axial force excitation. In: Proceedings of Meetings on Acoustics, ICA 2013, vol. 19, Montreal, Canada (2013)
Schwingshackl, C.W., Massei, L., Zang, C., Ewins, D.J.: A constant scanning LDV technique for cylindrical structures: simulation and measurement. Mech. Syst. Signal Process. 24, 394–405 (2010)
PACSYS FEA/BEM solutions: http://www.vibroacoustics.co.uk/ (2016). Accessed 12 May 2016
Matthews, D., Sun, H., Saltmarsh, K., Wilkes, D., Munyard, A., Pan, J.: A detailed experimental modal analysis of a clamped circular plate. In: Inter.noise 2014: Proceedings of the 43rd International Congress on Noise and Control Engineering, Melbourne, Australia (2014)
Giuliani, P., Di Maio, D., Schwingshackl, C.W., Martarelli, M., Ewins, D.J.: Six degrees of freedom measurement with continuous scanning laser Doppler vibrometer. Mech. Syst. Signal Process. 38, 367–387 (2013)
Schwingshackl, C.W., Di Maio, D., Sever, I., Green, J.S.: Modeling and validation of the nonlinear dynamic behaviour of bolted flange joints. J. Eng. Gas Turbines Power 135, 122504-1–122504-8 (2013)