A zero-net-mass-flux actuator for unmanned underwater vehicles

Ocean Engineering - Tập 160 - Trang 471-477 - 2018
Bradley Ayers1, Hamid Johari1
1Mechanical Engineering Department, California State University Northridge, Northridge, CA 91330, United States

Tài liệu tham khảo

Amitay, 2002, Controlled transients of flow reattachment over stalled airfoils, Int. J. Heat. Fluid Fl, 23, 690, 10.1016/S0142-727X(02)00165-0 Ayers, 2015 Buren, 2014, Vortex formation of a finite-span synthetic jet: high Reynolds number, Phys. Fluids, 26 Cater, 2002, The evolution of round zero-net-mass-flux jets, J. Fluid Mech., 472, 167, 10.1017/S0022112002002264 Chang, 1995, Dynamics of vortex rings in crossflow, Phys. Fluids, 7, 1583, 10.1063/1.868545 Chaudhari, 2010, Head transfer characteristics of synthetic jet impingement cooling, Int. J. Heat. Mass Tran, 53, 1057, 10.1016/j.ijheatmasstransfer.2009.11.005 DeMauro, 2013, Interaction of synthetic jet with flow over a low aspect ratio cylinder, Phys. Fluids, 25, 10.1063/1.4811710 Eroglu, 2001, Structure, penetration and mixing of pulsed jets in crossflow, AIAA J., 39, 417, 10.2514/2.1351 Gharib, 1998, A universal time scale for vortex ring formation, J. Fluid Mech., 360, 121, 10.1017/S0022112097008410 Glezer, 2002, Synthetic jets, Annu. Rev. Fluid Mech., 34, 503, 10.1146/annurev.fluid.34.090501.094913 Glezer, 2011, Some aspects of aerodynamic flow control using synthetic-jet actuation, Philos. Trans. Roy. Soc. A, 369, 1476, 10.1098/rsta.2010.0374 Gopalan, 2004, The structure of a jet in cross flow at low velocity ratios, Phys. Fluids, 16, 2067, 10.1063/1.1697397 James, 1996, A round turbulent jet produced by an oscillating diaphragm, Phys. Fluids, 8, 2484, 10.1063/1.869040 Johari, 2006, Scaling of fully pulsed jets in crossflow, AIAA J., 44, 2719, 10.2514/1.18929 Kercher, 2003, Microjet cooling devices for thermal management of electronics, IEEE T. Compon. Pack. Trans., 26, 359, 10.1109/TCAPT.2003.815116 Kreig, 2008, Incorporation of novel underwater thrusters into vehicle control systems Kreig, 2005, Optimal thrust characteristics of a synthetic jet actuator for application in low speed maneuvering of underwater vehicles M'Closkey, 2002, The actively controlled jet in crossflow, J. Fluid Mech., 452, 325, 10.1017/S0022112001006589 Mahalingam, 2004, Thermal management using synthetic jet actuators, IEEE Trans. Compon. Pack. Trans., 27, 439, 10.1109/TCAPT.2004.831757 Maldonado, 2009, Active control of flow separation and structural vibrations of wind turbine blades, Wind Energ, 13, 221 Mejia, 2011, Effects of trailing-edge synthetic jet actuation on an airfoil, AIAA J., 49, 1763, 10.2514/1.J050969 Mohseni, 2006, Pulsatile vortex generators for low-speed maneuvering of small underwater vehicles, Ocean. Eng., 33, 2209, 10.1016/j.oceaneng.2005.10.022 Polsenburg-Thomas, 2005, An experimental study of voice-coil driven synthetic jet propulsion for underwater vehicles Sau, 2008, Dynamics and mixing of vortex rings in crossflow, J. Fluid Mech., 604, 389, 10.1017/S0022112008001328 Smith, 1998, The formation and evolution of synthetic jets, Phys. Fluids, 10, 2281, 10.1063/1.869828 Tamburello, 2008, Active control of a free jet using a synthetic jet, Int. J. Heat. Fluid Fl, 29, 967, 10.1016/j.ijheatfluidflow.2008.02.017 Vasile, 2015, Interaction of a finite-span synthetic jet near the tip of a sweptback wing, Phys. Fluids, 27, 10.1063/1.4921844 Woo, 2013, Controlled transitory stall on a pitching airfoil using pulsed actuation, Exp. Fluids, 54, 1507, 10.1007/s00348-013-1507-5