A procedure for extracting primary and secondary creep parameters from nanoindentation data

Dean, 2010, Use of quasi-static nanoindentation data to obtain stress-strain characteristics for metallic materials, Acta Mater., 58, 3613, 10.1016/j.actamat.2010.02.031 Dean, 2010, Use of nanoindentation to measure residual stresses in surface layers, Acta Mater., 59, 2749, 10.1016/j.actamat.2011.01.014 Chudoba, 2001, Investigation of creep behaviour under load during indentation experiments and its influence on hardness and modulus results, Surf. Coat. Technol., 148, 191, 10.1016/S0257-8972(01)01340-8 Seltzer, 2008, Depth sensing indentation of linear viscoelastic-plastic solids: A simple method to determine creep compliance, Eng. Fract. Mech., 75, 4852, 10.1016/j.engfracmech.2008.06.012 Stone, 2010, Analysis of indentation creep, J. Mat. Res., 25, 611, 10.1557/JMR.2010.0092 Galli, 2009, Creep properties from indentation tests by analytical and numerical techniques, Int. J. Mat. Res., 100, 954, 10.3139/146.110131 Cao, 2007, Determination of the creep exponent of a power-law creep solid using indentation tests, Mech. Time-Depend. Mater., 11, 159, 10.1007/s11043-007-9033-6 Goodall, 2006, A critical appraisal of the extraction of creep parameters from nanoindentation data obtained at room temperature, Acta Mater., 54, 5489, 10.1016/j.actamat.2006.07.020 Chen, 2010, Indentation of power law creep solids by self-similar indenters, Mat. Sci. Eng. A, 527, 5613, 10.1016/j.msea.2010.05.069 Takagi, 2008, Analysis on pseudo-steady indentation creep, Acta Mech. Solida Sin., 21, 283, 10.1007/s10338-008-0832-3 Stone, D., Elmustafa, A., 2008. Analysis of indentation creep. In: Proc. MRS (Fundamentals of Nanoindentation and Nanotribology IV), vol. 1049, pp. 163–68. Mulhearn, 1960, Creep and hardness of metals: a physical study, J. Inst. Met., 89, 7 Fujiwara, 2001, Indentation creep of beta-Sn and Sn–Pb eutectic alloy, Mater. Sci. Eng. A, A319–321, 929, 10.1016/S0921-5093(01)01079-6 Liu, 2007, Tensile and indentation creep behaviour of Mg-5%Sn and Mg-5%Sn-2%Di alloys, Mater. Sci. Eng. A, 464, 124, 10.1016/j.msea.2007.02.061 Liu, 2007, Experimental and numerical study of the method to determine the creep parameters from the indentation creep testing, Mater. Sci. Eng. A, 456, 103, 10.1016/j.msea.2006.11.098