A phenomenological combustion model for direct-injection, compression-ignition engines

Whitehouse, 1974, The effect of changes in design and operating conditions on heat release in direct-injection diesel engines, SAE paper, 10.4271/740085 Shroff, 1974, Simulation and optimization of thermodynamic process of diesel engine, SAE paper, 10.4271/740194 Adler, 1969, The evaporation and mixing of a liquid fuel spray in a diesel air swirl, 184, 171 Shahed, 1973, A preliminary model for the formation of nitric oxide in direct-injection diesel engines and its application in parametric studies, SAE paper, 10.4271/730083 Chiu, 1976, A transient spray mixing model for diesel combustion, SAE paper, 10.4271/760128 Kuo, 1983, A numerical study of the transient evaporating spray mixing process in the diesel environment, SAE paper, 10.4271/831735 Khan, 1973, Factors affecting smoke and gaseous emissions from direct-injection engines and a method of calculation, SAE paper, 10.4271/730169 Greeves, 1979, Response of diesel combustion systems to increase fuel injection rates, SAE paper, 10.4271/790037 Dent, 1981, Phenomenological combustion model for a quiescent chamber diesel engine, SAE paper, 10.4271/811235 Abramovich, 1963 Kyriakides, 1986, Phenomenological diesel combustion model including smoke and NO emission, SAE paper, 10.4271/860330 Hiroyasu, 1983, Development and use of a spray combustion modelling to predict diesel engine efficiency and pollutant emissions, Bull. JSME, 26, 569, 10.1299/jsme1958.26.569 Hiroyasu, 1974, Fuel droplet size distribution in diesel combustion chambers, SAE paper, 10.4271/740715 Hiroyasu, 1980, Soot formation and oxidation in diesel engines, SAE paper, 10.4271/800252 Hiroyasu, 1982, The break-up of high speed jet in a high pressure gaseous atmosphere, ICLASS-82, 69 Kono, 1985, Prediction of in-cylinder flow and spray formation effects on combustion of direct injection diesel engine, SAE paper, 10.4271/850108 Bracco, 1976, Modeling of two-phase, two-dimensional, unsteady combustion for internal combustion engines, 167 Kuo, 1983, Computations of drop sizes in pulsating sprays and of liquid-core length in vaporizing sprays, SAE paper O'Rourke, 1980, Modelling of drop interactions in thick sprays and a comparison with experiments, 101 Gosman, 1982, Computer analysis of fuel-air mixing and combustion in an axisymmetric D.I. diesel, SAE paper, 10.4271/820036 Gosman, 1980, Computer analysis of fuel-air mixing in direct-injection engines, SAE paper, 10.4271/800091 Watkins, 1986, Calculation of three dimensional spray motion in engines, SAE paper, 10.4271/860468 Nguyen, 1987, The effects of engine speed and injection characteristics on the flow field and fuel/air mixing in motored two-stroke diesel engines, AIAA-87-0227 Boysan, 1982, Three-dimensional model of spray combustion in gas turbine combustors, J. Energy, 6, 368, 10.2514/3.62618 Reitz, 1979, On the dependence of spray angle and other spray parameters on nozzle design and operating conditions, SAE paper, 10.4271/790494 Levich, 1962 Hiroyasu, 1980, Supplementary comments: fuel spray characterization in diesel engines, 369 Dent, 1971, A basis for the comparison of various experimental methods for studying spray penetration, SAE paper, 10.4271/710571 Takeuchi, 1982, Experimental studies on the behavior of a small droplet impinging upon a hot surface, ICLASS-82, 397 Lakshminarayan, 1983, Interferometric studies of vapourising and combusting sprays, SAE paper, 10.4271/830244 Rajaratnam, 1976 Ricou, 1961, Measurement of entrainment by axial-symmetric turbulent jets, J. Fluid Mech., 11, 21, 10.1017/S0022112061000834 Kuniyoshi, 1983, Investigation on the initial part and the spray formation delay of diesel spray, SAE paper Faeth, 1983, Evaporation and combustion of sprays, Prog. Energy Combust. Sci., 9, 1, 10.1016/0360-1285(83)90005-9 Glassman, 1977 Alkidas, 1981, The influence of size-distribution parameters on the evaporation of polydisperse dilute sprays, Int. J. Heat Mass Transfer, 24, 1913, 10.1016/0017-9310(81)90114-9 Ranz, 1952, Evaporation from drops, Chemical Engineering Progress, 48, 141 Ranz, 1952, Evaporation from drops, Chemical Engineering Progress, 48, 173 Hiraki, 1980, Performance and NOx model of a direct injection stratified charge engine, SAE paper, 10.4271/800050 Liwengood, 1957, Auto-ignition in combustion engines and compression machines, 347 Sato, 1982, An investigation of diesel sprays, ICLASS-82, 229 Wolfer, 1938, Der Zünderzug im Dieselmotor, 15 Woschni, 1967, A universally applicable equation for the instantaneous heat transfer coefficient in the internal combustion engine, SAE paper, 10.4271/670931 Tinaut, 1986, A contribution to the study of the combustion process in direct-injection, compression-ignition engines Payri, 1983, Data acquisition system for the determination of indicator diagrams