Investigation of flow through a computationally generated packed column using CFD and Additive Layer Manufacturing

Adler, 1992 Atmakidis, 2009, CFD-based analysis of the wall effect on the pressure drop in packed beds with moderate tube/particle diameter ratios in the laminar OW regime, Chem Eng J, 155, 404, 10.1016/j.cej.2009.07.057 Augier, 2010, Numerical simulations of transfer and transport properties inside packed beds of spherical particles, Chem Eng Sci, 65, 1055, 10.1016/j.ces.2009.09.059 Baker, 2011, Image based meshing of packed beds of cylinders at low aspect ratios using 3d MRI coupled with computational fluid dynamics, Comput Chem Eng, 35, 1969, 10.1016/j.compchemeng.2011.03.017 Baker, 2010, Computational analysis of transitional airflow through packed columns of spheres using the finite volume technique, Comput Chem Eng, 34, 878, 10.1016/j.compchemeng.2009.10.013 Brownell, 1950, Pressure drop through porous media. Part IV: new data and revised correlation, Chem Eng Prog, 46, 415 Burke, 1928, Gas flow through packed columns, Ind Eng Chem, 20, 1196, 10.1021/ie50227a025 Carman, 1937, Fluid flow through a granular bed, Trans Inst Chem Eng London, 15, 150 Choi, 2008, A semi-empirical correlation for pressure drop in packed beds of spherical particles, Transp Porous Med, 75, 133 Dalman, 1986, Fluid flow and heat transfer past two spheres in a cylindrical tube, Comput Fluids, 14, 267, 10.1016/0045-7930(86)90025-3 Dixon, 2013, Systematic mesh development for 3d CFD simulation of fixed beds: contact points study, Comput Chem Eng, 48, 135, 10.1016/j.compchemeng.2012.08.011 Dixon, 2011, Systematic mesh development for 3d CFD simulation of fixed beds: Single sphere study, Comput Chem Eng, 35, 1171, 10.1016/j.compchemeng.2010.12.006 Dullien, 1979 Eisfeld, 1999 Eisfeld, 2001, The influence of confining walls on the pressure drop in packed beds, Chem Eng Sci, 56, 4321, 10.1016/S0009-2509(00)00533-9 Eppinger, 2011, DEM-CFD simulations of fixed bed reactors with small tube to particle diameter ratios, Chem Eng J, 166, 324, 10.1016/j.cej.2010.10.053 Ergun, 1949, Fluid flow through randomly packed columns and fluidised beds, Ind Eng Chem, 41, 1179, 10.1021/ie50474a011 Fand, 1972, Druckverlust in kugelschttungen, Brennstoff-Warme-Kraft, 24, 233 Gupte, 1970 Leva, 1947, Pressure drop through packed tubes, part III, prediction of voids in packed tubes, Chem Eng Prog, 43, 713 Leva, 1951 Mantle, 2001, Single and two-phase flow in fixed bed reactors: MR flow visualisation and lattice-boltmann simulations, Chem Eng Sci, 56, 523, 10.1016/S0009-2509(00)00256-6 Nakajo, 2011, Experimental verification of turbulence modeling for the flow through a porous media by using PTV Ookawara, 2007, High-fidelity DEM-CFD modeling of packed bed reactors for process intensification. Perry, 1997 Reichelt, 1972, Zur berechnung des druckverlustes einphasig durchstromter kugel- und zylinderschuttengen, Chem Ing Tech, 44, 1068, 10.1002/cite.330441806 Robbins, 2012, CFD modeling of single-phase flow in a packed bed with MRI validation, AIChE J, 58, 3904, 10.1002/aic.13767 Sahimi, 1994 Sullivan, 2005, Simulation of packed bed reactors using lattice boltmann methods, Chem Eng Sci, 60, 3405, 10.1016/j.ces.2005.01.038 Tóbis, 2000, Influence of bed geometry on its frictional resistance under turbulent flow conditions, Chem Eng Sci, 55, 5359, 10.1016/S0009-2509(00)00155-X Tobis, 2002, Modeling of the pressure drop in the packing of complex geometry, Ind Eng Chem Res, 41, 2552, 10.1021/ie010541c Tsotas, 2002, Fluid flow in packed beds, Chem Eng Sci, 20, 237 Yevseyev, 1991, Experimental investigation of a turbulent filtrational flow, Int J Multiphase Flow, 17, 103, 10.1016/0301-9322(91)90073-C