Preparation of cleaner one-part geopolymer by investigating different types of commercial sodium metasilicate in China

Abdalqader, 2016, Development of greener alkali-activated cement: utilisation of sodium carbonate for activating slag and fly ash mixtures, J. Clean. Prod., 113, 66, 10.1016/j.jclepro.2015.12.010 Adesanya, 2018, One-part geopolymer cement from slag and pretreated paper sludge, J. Clean. Prod., 185, 168, 10.1016/j.jclepro.2018.03.007 Cheah, 2017, The use of high calcium wood ash in the preparation of Ground Granulated Blast Furnace Slag and Pulverized Fly Ash geopolymers: a complete microstructural and mechanical characterization, J. Clean. Prod., 156, 114, 10.1016/j.jclepro.2017.04.026 Chiaia, 2014, Eco-mechanical index for structural concrete, Construct. Build. Mater., 67, 386, 10.1016/j.conbuildmat.2013.12.090 Davidovits, 2011 de Azevedo, 2018, Recycling paper industry effluent sludge for use in mortars: a sustainability perspective, J. Clean. Prod., 192, 335, 10.1016/j.jclepro.2018.05.011 Deir, 2014, Influence of starting material on the early age hydration kinetics, microstructure and composition of binding gel in alkali activated binder systems, Cement Concr. Compos., 48, 108, 10.1016/j.cemconcomp.2013.11.010 Feng, 2012, Thermal activation of albite for the synthesis of one-part mix geopolymers, J. Am. Ceram. Soc., 95, 565, 10.1111/j.1551-2916.2011.04925.x Flatt, 2012, Concrete: an eco material that needs to be improved, J. Eur. Ceram. Soc., 32, 2787, 10.1016/j.jeurceramsoc.2011.11.012 Gao, 2017, Evolution and projection of CO2 emissions for China’s cement industry from 1980 to 2020, Renew. Sustain. Energy Rev., 74, 522, 10.1016/j.rser.2017.02.006 Garcia-Lodeiro, 2013, Variation in hybrid cements over time. Alkaline activation of fly ash–portland cement blends, Cement Concr. Res., 52, 112, 10.1016/j.cemconres.2013.03.022 Gartner, 2015, A review of alternative approaches to the reduction of CO2 emissions associated with the manufacture of the binder phase in concrete, Cement Concr. Res., 78, 126, 10.1016/j.cemconres.2015.04.012 Hajimohammadi, 2011, Time-resolved and spatially-resolved infrared spectroscopic observation of seeded nucleation controlling geopolymer gel formation, J. Colloid Interface Sci., 357, 384, 10.1016/j.jcis.2011.02.045 Hemalatha, 2017, A review on fly ash characteristics-Towards promoting high volume utilization in developing sustainable concrete, J. Clean. Prod., 147, 546, 10.1016/j.jclepro.2017.01.114 Hu, 2018, Mechanical and microstructural characterization of geopolymers derived from red mud and fly ashes, J. Clean. Prod., 186, 799, 10.1016/j.jclepro.2018.03.086 Huseien, 2017, Geopolymer mortars as sustainable repair material: a comprehensive review, Renew. Sustain. Energy Rev., 80, 54, 10.1016/j.rser.2017.05.076 Ismail, 2013, Microstructural changes in alkali activated fly ash/slag geopolymers with sulfate exposure, Mater. Struct., 46, 361, 10.1617/s11527-012-9906-2 Kajaste, 2016, Cement industry greenhouse gas emissions–management options and abatement cost, J. Clean. Prod., 112, 4041, 10.1016/j.jclepro.2015.07.055 Kim, 2013, Use of CaO as an activator for producing a price-competitive non-cement structural binder using ground granulated blast furnace slag, Cement Concr. Res., 54, 208, 10.1016/j.cemconres.2013.09.011 Lecomte, 2006, (Micro)-structural comparison between geopolymers, alkali-activated slag cement and Portland cement, J. Eur. Ceram. Soc., 26, 3789, 10.1016/j.jeurceramsoc.2005.12.021 Li, 2014, Microstructure and performance of fly ash micro-beads in cementitious material system, Construct. Build. Mater., 52, 422, 10.1016/j.conbuildmat.2013.11.040 Long, 2015, Designing more sustainable and greener self-compacting concrete, Construct. Build. Mater., 84, 301, 10.1016/j.conbuildmat.2015.02.072 Luukkonen, 2018, One-part alkali-activated materials: a review, Cement Concr. Res., 103, 21, 10.1016/j.cemconres.2017.10.001 Ma, 2016, Properties of magnesium phosphate cement containing redispersible polymer powder, Construct. Build. Mater., 113, 255, 10.1016/j.conbuildmat.2016.03.053 Ma, 2018, A calculation model for compressive strength of cleaner earth-based construction with a high-efficiency stabilizer and fly ash, J. Clean. Prod., 183, 292, 10.1016/j.jclepro.2018.02.153 Martins, 2018, Assessment of the durability of grout submitted to accelerated carbonation test, Construct. Build. Mater., 159, 261, 10.1016/j.conbuildmat.2017.10.111 Matalkah, 2017, Mechanochemical synthesis of one-part alkali aluminosilicate hydraulic cement, Mater. Struct., 50, 97, 10.1617/s11527-016-0968-4 Mithun, 2016, Performance of alkali activated slag concrete mixes incorporating copper slag as fine aggregate, J. Clean. Prod., 112, 837, 10.1016/j.jclepro.2015.06.026 Myers, 2014, A thermodynamic model for C-(N-) ASH gel: CNASH_ss. Derivation and validation, Cement Concr. Res., 66, 27, 10.1016/j.cemconres.2014.07.005 Nath, 2015, Use of OPC to improve setting and early strength properties of low calcium fly ash geopolymer concrete cured at room temperature, Cement Concr. Compos., 55, 205, 10.1016/j.cemconcomp.2014.08.008 Nematollahi, 2017, High ductile behavior of a polyethylene fiber-reinforced one-part geopolymer composite: a micromechanics-based investigation, Arch. Civ. Mech. Eng., 17, 555, 10.1016/j.acme.2016.12.005 Nematollahi, 2015, Synthesis of heat and ambient cured one-part geopolymer mixes with different grades of sodium silicate, Ceram. Int., 41, 5696, 10.1016/j.ceramint.2014.12.154 Peng, 2015, Synthesis, characterization and mechanisms of one-part geopolymeric cement by calcining low-quality kaolin with alkali, Mater. Struct., 48, 699, 10.1617/s11527-014-0350-3 Phoo-ngernkham, 2014, The effect of adding nano-SiO2 and nano-Al2O3 on properties of high calcium fly ash geopolymer cured at ambient temperature, Mater. Des., 55, 58, 10.1016/j.matdes.2013.09.049 Rashad, 2013, Hydration and properties of sodium sulfate activated slag, Cement Concr. Compos., 37, 20, 10.1016/j.cemconcomp.2012.12.010 Shekhovtsova, 2018, Estimation of fly ash reactivity for use in alkali-activated cements-A step towards sustainable building material and waste utilization, J. Clean. Prod., 178, 22, 10.1016/j.jclepro.2017.12.270 Shen, 2014, Factory-level measurements on CO2 emission factors of cement production in China, Renew. Sustain. Energy Rev., 34, 337, 10.1016/j.rser.2014.03.025 Shi, 2006 Singh, 2015, Geopolymer concrete: a review of some recent developments, Construct. Build. Mater., 85, 78, 10.1016/j.conbuildmat.2015.03.036 Somna, 2011, NaOH-activated ground fly ash geopolymer cured at ambient temperature, Fuel, 90, 2118, 10.1016/j.fuel.2011.01.018 Suwan, 2017, Effect of manufacturing process on the mechanisms and mechanical properties of fly ash-based geopolymer in ambient curing temperature, Mater. Manuf. Process., 32, 461, 10.1080/10426914.2016.1198013 Temuujin, 2009, Influence of calcium compounds on the mechanical properties of fly ash geopolymer pastes, J. Hazard Mater., 167, 82, 10.1016/j.jhazmat.2008.12.121 Topçu, 2014, Durability and microstructure characteristics of alkali activated coal bottom ash geopolymer cement, J. Clean. Prod., 81, 211, 10.1016/j.jclepro.2014.06.037 Turner, 2013, Carbon dioxide equivalent (CO2-e) emissions: a comparison between geopolymer and OPC cement concrete, Construct. Build. Mater., 43, 125, 10.1016/j.conbuildmat.2013.01.023 Viejo, 2016, Numerical modelling of porous cement-based materials by superabsorbent polymers, Cement Concr. Res., 90, 184, 10.1016/j.cemconres.2016.07.018 Walkley, 2016, Phase evolution of C-(N)-ASH/NASH gel blends investigated via alkali-activation of synthetic calcium aluminosilicate precursors, Cement Concr. Res., 89, 120, 10.1016/j.cemconres.2016.08.010 Xia, 2013, Utilization of circulating fluidized bed fly ash in preparing non-autoclaved aerated concrete production, Construct. Build. Mater., 47, 1461, 10.1016/j.conbuildmat.2013.06.033 Yang, 2010, Properties of alkali-activated mortar and concrete using lightweight aggregates, Mater. Struct., 43, 403, 10.1617/s11527-009-9499-6 Zhuang, 2016, Fly ash-based geopolymer: clean production, properties and applications, J. Clean. Prod., 125, 253, 10.1016/j.jclepro.2016.03.019