Boiling of saturated FC-72 on square pin fin arrays

Siman-Tov, 1970, Analysis and design of extended surfaces in boiling liquids, Chem. Engrg. Progr. Symp. Ser., 66, 174 Klein, 1971, Heat transfer from multiple spines to boiling liquids, AIChE J., 17, 1050, 10.1002/aic.690170507 Y. Hirono, R. Shimada, S. Kumagai, K. Kaino, T. Takeyama, Optimization of fin array in boiling heat transfer, Technical Report, Tohoku University, Vol. 50, No. 1, 1985, pp. 21–39 Bergles, 1995, Pool boiling from multiple square shaped spines in highly-wetting fluid, 149 Mudawar, 1989, High flux electronic cooling by means of pool boiling—Part II: Optimization of enhanced surface geometry, 111, 35 Yeh, 1997, Analysis of thermally optimised fin array in boiling liquids, Internat. J. Heat Mass Transfer, 40, 1035, 10.1016/0017-9310(96)00173-1 Guglielmini, 1999, Pool boiling heat transfer from square-shaped spines uniformly and non-uniformly spaced, 145 Guglielmini, 2001, Pool boiling from extended surfaces in saturated FC-72: Effect of geometry and orientation Bonilla, 1941, Heat transmission to binary liquid mixtures, Trans. Amer. Inst. Chem. Engrs., 37, 685 Cichelli, 1945, Heat transfer to liquid boiling under pressure, Amer. Inst. Chem. Engrs., 41, 755 Lienhard, 1965, Generalized displacement of the nucleate boiling, Internat. J. Heat Mass Transfer, 9, 355, 10.1016/0017-9310(66)90081-0 Danilova, 1970, Correlation of boiling heat data for freons, Heat Transfer Sov. Res., 2, 73 You, 1990, Experiments on boiling incipience with a highly-wetting dielectric fluid; Effects of pressure subcooling and dissolved gas content, 337 Guglielmini, 1994, Pool boiling heat tranfser of dielectric fluids for immersion electronic cooling: Effects of pressure, 243 Sokol, 1990, Pool boiling heat transfer from plain and finned tubes to propane and propylane, 75 Webb, 1992, Nucleate pool boiling data for five refrigerants on plain, integral-fin and enhanced tube geometries, Internat. J. Heat Mass Transfer, 35, 1893, 10.1016/0017-9310(92)90192-U Gorenflo, 1991, Pool boiling heat transfer from single tubes to new refrigerants, 423 Bar-Cohen, 1988, Wall superheat excursions in the boiling incipience of dielectric fluids, Heat Transfer Engng., 9, 19, 10.1080/01457638808939668 Rainey, 2000, Pool boiling heat transfer from plain and microporous, square pin-finned surfaces in saturated FC-72, ASME J. Heat Transfer, 122, 509, 10.1115/1.1288708 Bondurant, 1971, Performance of transverse fin for boiling heat transfer, Chem. Engrg. Prog. Symp. Series, 113, 30 Park, 1986, Boiling heat transfer characteristics of simulated microelectronic chips with detachable heat sinks, 2099 Heindel, 1992, Liquid immersion cooling of a longitudinal array of discrete heat sources in protruding substrates: II—Forced convection boiling, ASME J. Electron. Packaging, 114, 63, 10.1115/1.2905443 Carvalho, 1994, The pool nucleate boiling flow patterns of vertically oriented, small heaters boiling on one side, 25 Rohsenow, 1952, A method for correlating heat transfer data for surface boiling of liquids, Trans. ASME, 74, 969 Cooper, 1984, Heat flow rates in saturated nucleate pool boiling—A wide-ranging examination using reduced properties, 16, 157 Abuaf, 1985, Pool boiling performance of finned surfaces in R-113, Internat. J. Heat & Fluid Flow, 6, 23, 10.1016/0142-727X(85)90028-1 Guglielmini, 1996, Experiments on pool boiling of a dielectric fluid on extended surfaces, Internat. Comm. Heat Mass Transfer, 23, 451, 10.1016/0735-1933(96)00030-9 D. Gorenflo, Pool boiling, in: VDI Heat Atlas, Chapter Ha, 1993 Gorenflo, 2001, State of the art in pool boiling heat transfer of new refrigerants, Internat. J. Refrigeration, 24, 6, 10.1016/S0140-7007(00)00046-3 Nishikawa, 1982, Effect of the surface roughness on the nucleate boiling heat transfer over the wide range of pressure, 61