Modeling and design guidelines for direct steam generation solar receivers

Applied Energy - Tập 216 - Trang 761-776 - 2018
Meng Lin1, Jan Reinhold2, Nathalie Monnerie2, Sophia Haussener1
1Laboratory of Renewable Energy Science and Engineering, EPFL, Station 9, 1015, Lausanne, Switzerland
2German Aerospace Center (DLR), Linder Hoehe, 51147 Koeln, Germany

Tài liệu tham khảo

Zhang, 2013, Concentrated solar power plants: review and design methodology, Renew Sustain Energy Rev, 22, 466, 10.1016/j.rser.2013.01.032 Lovegrove, 2011, A new 500 m2 paraboloidal dish solar concentrator, Sol Energy, 85, 620, 10.1016/j.solener.2010.01.009 Zarza, 2004, Direct steam generation in parabolic troughs: final results and conclusions of the DISS project, Energy, 29, 635, 10.1016/S0360-5442(03)00172-5 Buck, 2002, Solar-hybrid gas turbine-based power tower systems (REFOS), J Sol Energy Eng, 124, 2, 10.1115/1.1445444 Bader, 2015, An air-based corrugated cavity-receiver for solar parabolic trough concentrators, Appl Energy, 138, 337, 10.1016/j.apenergy.2014.10.050 Kodama, 2007, Thermochemical cycles for high-temperature solar hydrogen production, Chem Rev, 107, 4048, 10.1021/cr050188a Chueh, 2010, High-flux solar-driven thermochemical dissociation of CO2 and H2O using nonstoichiometric ceria, Science, 330, 1797, 10.1126/science.1197834 Bader, 2013, Thermodynamic analysis of isothermal redox cycling of ceria for solar fuel production, Energy Fuels, 27, 5533, 10.1021/ef400132d Lin, 2015, Solar fuel processing efficiency for ceria redox cycling using alternative oxygen partial pressure reduction methods, Energy, 88, 667, 10.1016/j.energy.2015.06.006 Davenport, 2016, Maximizing fuel production rates in isothermal solar thermochemical fuel production, Appl Energy, 183, 1098, 10.1016/j.apenergy.2016.09.012 Sanz-Bermejo, 2014, Optimal integration of a solid-oxide electrolyser cell into a direct steam generation solar tower plant for zero-emission hydrogen production, Appl Energy, 131, 238, 10.1016/j.apenergy.2014.06.028 Bala Chandran, 2015, Model of an integrated solar thermochemical reactor/reticulated ceramic foam heat exchanger for gas-phase heat recovery, Int J Heat Mass Transf, 81, 404, 10.1016/j.ijheatmasstransfer.2014.10.053 Haussener, 2009, Modeling of a multitube high-temperature solar thermochemical reactor for hydrogen production, J Sol Energy Eng, 131, 24503, 10.1115/1.3097280 Melchior, 2008, A cavity-receiver containing a tubular absorber for high-temperature thermochemical processing using concentrated solar energy, Int J Therm Sci, 47, 1496, 10.1016/j.ijthermalsci.2007.12.003 Melchior, 2008, Radiative transfer within a cylindrical cavity with diffusely/specularly reflecting inner walls containing an array of tubular absorbers, J Sol Energy Eng, 130, 21013, 10.1115/1.2888755 Martinek, 2012, Computational modeling and on-sun model validation for a multiple tube solar reactor with specularly reflective cavity walls. Part 1: Heat transfer model, Chem Eng Sci, 81, 298, 10.1016/j.ces.2012.06.064 Prakash, 2009, Investigations on heat losses from a solar cavity receiver, Sol Energy, 83, 157, 10.1016/j.solener.2008.07.011 Roldán, 2013, Thermal analysis of solar receiver pipes with superheated steam, Appl Energy, 103, 73, 10.1016/j.apenergy.2012.10.021 Edge, 2011, An integrated computational fluid dynamics–process model of natural circulation steam generation in a coal-fired power plant, Comput Chem Eng, 35, 2618, 10.1016/j.compchemeng.2011.04.003 Sunil, 2017, Mathematical modeling, simulation and validation of a boiler drum: Some investigations, Energy, 126, 312, 10.1016/j.energy.2017.02.140 Jo, 2009, Numerical simulation of subcooled flow boiling heat transfer in helical tubes, J Press Vessel Technol, 131, 11305, 10.1115/1.3028022 Tentner, 2014, Computational fluid dynamics modeling of two-phase boiling flow and critical heat flux Li, 2008, A lumped parameter dynamic model of the helical coiled once-through steam generator with movable boundaries, Nucl Eng Des, 238, 1657, 10.1016/j.nucengdes.2008.01.009 Oliet, 2010, Modelling of fin-and-tube evaporators considering non-uniform in-tube heat transfer, Int J Therm Sci, 49, 692, 10.1016/j.ijthermalsci.2009.11.009 Sinpiboon, 2002, Numerical investigation of refrigerant flow through non-adiabatic capillary tubes, Appl Therm Eng, 22, 2015, 10.1016/S1359-4311(02)00129-1 Dhir, 2006, Mechanistic prediction of nucleate boiling heat transfer-achievable or a hopeless task?, J Heat Transfer, 128, 1, 10.1115/1.2136366 Son, 1999, Dynamics and heat transfer associated with a single bubble during nucleate boiling on a horizontal surface, J Heat Transfer, 121, 623, 10.1115/1.2826025 Das S, Punekar H. On development of a semi-mechanistic wall boiling model, ASME 2013 Int. Mech. Eng. Congr. Expo. V08BT09A075-V08BT09A075; 2013. 10.1115/IMECE2013-66179. Abishek, 2017, Computational analysis of two-phase flow and heat transfer in parallel and counter flow double-pipe evaporators, Int J Heat Mass Transf, 104, 615, 10.1016/j.ijheatmasstransfer.2016.08.089 Krepper, 2007, CFD modelling of subcooled boiling—concept, validation and application to fuel assembly design, Nucl Eng Des, 237, 716, 10.1016/j.nucengdes.2006.10.023 Li, 2011, Prediction of boiling and critical heat flux using an eulerian multiphase boiling model, Fluids Therm Syst Adv Process Ind Parts A B, vol. 6, 463 Celata, 2001, Critical heat flux prediction for saturated flow boiling of water in vertical tubes, Int J Heat Mass Transf, 44, 4323, 10.1016/S0017-9310(01)00072-2 Lifante C, Frank T, Burns A. Wall boiling modeling extension towards critical heat flux; n.d. Kurul N, Podowski MZ. On the modeling of multidimensional effects in boiling channels. In: 27th Natl heat transf conf; 1991. p. 21–6. Thome JR. Engineering data book III, Wolver. Tube Inc. 2010; 2004. Liu, 1991, A general correlation for saturated and subcooled flow boiling in tubes and annuli, based on a nucleate pool boiling equation, Int J Heat Mass Transf, 34, 2759, 10.1016/0017-9310(91)90234-6 Cheng, 2008, Two-phase flow patterns and flow-pattern maps: fundamentals and applications, Appl Mech Rev, 61, 50802, 10.1115/1.2955990 Roth, 2014, Theory and implementation of nuclear safety system codes – Part II: System code closure relations, validation, and limitations, Prog Nucl Energy, 76, 55, 10.1016/j.pnucene.2014.05.003 Escanes, 1995, Numerical simulation of capillary-tube expansion devices, Int J Refrig, 18, 113, 10.1016/0140-7007(95)93894-P García-Valladares, 2002, Numerical simulation of capillary tube expansion devices behaviour with pure and mixed refrigerants considering metastable region. Part I: Mathematical formulation and numerical model, Appl Therm Eng, 22, 173, 10.1016/S1359-4311(01)00074-6 Colorado, 2011, Numerical simulation and experimental validation of a helical double-pipe vertical condenser, Appl Energy, 88, 2136, 10.1016/j.apenergy.2010.12.026 Kattan, 1998, Flow boiling in horizontal tubes: Part 1—Development of a diabatic two-phase flow pattern map, J Heat Transfer, 120, 140, 10.1115/1.2830037 Martinek, 2014, Granular flow and heat transfer study in a near-blackbody enclosed particle receiver Martinek, 2012, Computational modeling of a multiple tube solar reactor with specularly reflective cavity walls. Part 2: Steam gasification of carbon, Chem Eng Sci, 81, 285, 10.1016/j.ces.2012.06.065 Haussener, 2012, Multi-scale modelling of a solar reactor for the high-temperature step of a sulphur-iodine-based water splitting cycle, 287 Reddy, 2015, Combined heat loss analysis of solar parabolic dish – modified cavity receiver for superheated steam generation, Sol Energy, 10.1016/j.solener.2015.04.028 Zhu, 2015, Experimental investigation on the energy and exergy performance of a coiled tube solar receiver, Appl Energy, 156, 519, 10.1016/j.apenergy.2015.07.013 Zapata JI, Asselineau C-A, Pye J, Kaufer M, Hughes G. An integrated optical and thermal model of cavity receivers for paraboloidal dish concentrators; n.d. Wang, 2013, Numerical study of heat transfer enhancement in the receiver tube of direct steam generation with parabolic trough by inserting metal foams, Appl Energy, 102, 449, 10.1016/j.apenergy.2012.07.026 Faghri, 2006 Steinfeld, 1993, Optimum aperture size and operating temperature of a solar cavity-receiver, Sol Energy, 50, 19, 10.1016/0038-092X(93)90004-8 Paitoonsurikarn, 2002, Numerical investigation of natural convection loss in cavity-type solar receivers in solar dish applications, Sol. 2002-Austrailian New Zeal, Sol Energy Soc, 133, 6 Lienhard, 2013 Leibfried, 1995, Convective Heat loss from upward and downward-facing cavity solar receivers: measurements and calculations, J Sol Energy Eng, 117, 75, 10.1115/1.2870873 Hischier, 2009, Heat transfer analysis of a novel pressurized air receiver for concentrated solar power via combined cycles, J Therm Sci Eng Appl, 1, 41002, 10.1115/1.4001259 Friedel L. Improved friction pressure drop correlations for horizontal and vertical two-phase pipe flow. In: Eur two-phase flow gr meet Pap E; 1979. p. 1979. Bell, 2014, Pure and pseudo-pure fluid thermophysical property evaluation and the open-source thermophysical property library CoolProp, Ind Eng Chem Res, 53, 2498, 10.1021/ie4033999 Steiner D. Heat Transfer to Boiling Saturated Liquids (VDI-Wärmeatlas), VDI Heat Atlas. VDI-Gessellschaft Verfahrenstechnik Und Chemieinge Nieurwes. (GCV), Düsseldorf, Ger. (JW Fullarton, Transl; 1993. Rouhani, 1970, Calculation of void volume fraction in the subcooled and quality boiling regions, Int J Heat Mass Transf, 13, 383, 10.1016/0017-9310(70)90114-6 Woldesemayat, 2007, Comparison of void fraction correlations for different flow patterns in horizontal and upward inclined pipes, Int J Multiph Flow, 33, 347, 10.1016/j.ijmultiphaseflow.2006.09.004 Thome, 2003, Two-phase flow pattern map for evaporation in horizontal tubes: latest version, Heat Transf Eng, 24, 3, 10.1080/714044410 Taitel, 1976, A model for predicting flow regime transitions in horizontal and near horizontal gas-liquid flow, AIChE J, 22, 47, 10.1002/aic.690220105 Elsafi, 2015, On thermo-hydraulic modeling of direct steam generation, Sol Energy, 120, 636, 10.1016/j.solener.2015.08.008 Cooper, 1984, Heat flow rates in saturated nucleate pool boiling – a wide- ranging examination using reduced properties, Adv Heat Transf, 16, 157, 10.1016/S0065-2717(08)70205-3 Groeneveld, 1973 Biberg, 1999, Explicit approximation for the wetted angle in two-phase stratified pipe flow, Can J Chem Eng, 77, 1221, 10.1002/cjce.5450770619 Dittus, 1985, Heat transfer in automobile radiators of the tubular type, Int Commun Heat Mass Transf, 12, 3, 10.1016/0735-1933(85)90003-X Thome, 1998, Flow boiling in horizontal tubes: Part 3—Development of a new heat transfer model based on flow pattern, J Heat Transfer, 120, 156, 10.1115/1.2830039 VDI-Gesellschaft, VDI Heat Atlas; 2015. 10.1017/CBO9781107415324.004. Gungor, 1986, A general correlation for flow boiling in tubes and annuli, Int J Heat Mass Transf, 29, 351, 10.1016/0017-9310(86)90205-X Kakaç, 1987 Gupta, 2011, Ali, Laminar flow in helical coils: a parametric study, Ind Eng Chem Res, 1150, 10.1021/ie101752z Fluent A. Ansys fluent. Acad Res Release, vol. 17(2); 2016. Lobón, 2014, Modeling direct steam generation in solar collectors with multiphase CFD, Appl Energy, 113, 1338, 10.1016/j.apenergy.2013.08.046