Modelling of Tool Life in Turning Process Using Experimental Method
Tóm tắt
This study presents an attempt to investigation of Tool life in turning process using design of experiments (DOE) method. The wear data were collected in turning operations of SPK alloyed steel under different cutting conditions. By applying a full factorial design, effect of factors was investigated. Analysis of variance for tha main factors of design and their interactions were studied for their significance. Finally, a model using multiple regression analysis between cutting speed, feed rate and depth of cut with the tool life was established.
Tài liệu tham khảo
N. Tosun and L. Ozler, ‘A study of tool life in hot machining using artificial neural networks and regression analysis methods’, Journal of Materials Processing Technology, 124, (2002) 99–104
T. I. E. Wardany and M. A. Elbestawi, ‘Prediction of Tool Failure Rate in Turning Hardened Steels’, Int. J. Adv. Manuf. Technol., 13, (1997) 1–16
Y. Yao, C. Liu, Z. Yuan and Y. Lu, ‘Robustness improvement of tool life estimation assisted by a virtual manufacturing cell’, Journal of Materials Processing Technology, 172, (2006) 445–450
L. Przybylski and B. Slodki, ‘The Influence of Local Operating Features on the Cutting Parameters in Turning’, Int. J. Adv. Manuf. Technol., 13, (1997) 233–236
D. Kerr, J. Pengilley and R. Garwood, ‘Assessment and visualisation of machine tool wear using computer vision’, Int. J. Adv. Manuf. Technol., 28, (2006) 781–791
D. K. Ojha and U. S. Dixit, ‘An economic and reliable tool life estimation procedure for turning’, Int. J. Adv. Manuf. Technol., 26, (2005) 726–732
J. A. Arsecularatne, ‘Prediction of tool life for restricted contact an grooved tools based on equivalent feed’, International Journal of Machine Tools & Manufacture, 44, (2004) 1271–1282
Ghader Rezazadeh, Shahriar Kouravand and Mehdi Mehrban, ‘MEMS Capacitive Thermal Sensor Sensitivity Investigation Using Full Factorial Design Method’, Sensors & Transducers Journal, 72, (2006) 754–760
J. R. Luna, J. F. Ovalles, A. Leon and M. Buchheister, ‘A factorial design for optimizing a flow injection analysis system’, Fresenius J Anal Chem, 167, (2000) 201–203
Eyup Bagci and Birhan Isik, ‘Investigation of surface roughness in turning unidirectional GFRP composites by using RS methodology and ANN’, Int J Adv Manuf Technol, Original Paper (2005)
Eyup Bagci and Birhan Isik, ‘Analysis of temperature changes onf the twist drill under differenct drilling conditions based on Taguchi method during dry drilling of AI 7075-T651’, Int J Adv Manuf Technol, Original Paper (2005)
N. H. Kim and J. S. Chun, ‘A study of the tool life of TiC and TiC plus AI203 chemical vapour deposited tungsten carbide tools’, Journal of materials science, 20, (1985) 1285–1290