Microstructural packing- and rheology-based binder selection and characterization for Ultra-high Performance Concrete (UHPC)

Yoo, 2016, Mechanical properties of ultra-high-performance fiber-reinforced concrete: a review, Cem. Concr. Compos., 73, 267, 10.1016/j.cemconcomp.2016.08.001 Graybeal, 2011 Gesoglu, 2016, Strain hardening ultra-high performance fiber reinforced cementitious composites: effect of fiber type and concentration, Compos. Part B Eng., 103, 74, 10.1016/j.compositesb.2016.08.004 Saleem, 2011, Ultra-high-performance concrete bridge deck reinforced with high-strength steel, ACI Struct. J., 108, 601 Graybeal, 2011, Fatigue response in bridge deck connection composed of field-cast ultra-high-performance concrete, Transp. Res. Rec., 93, 10.3141/2251-10 Yi, 2012, Blast-resistant characteristics of ultra-high strength concrete and reactive powder concrete, Constr. Build. Mater., 28, 694, 10.1016/j.conbuildmat.2011.09.014 Wang, 2012, Preparation of ultra-high performance concrete with common technology and materials, Cem. Concr. Compos., 34, 538, 10.1016/j.cemconcomp.2011.11.005 Wille, 2011, Ultra-high performance concrete with compressive strength exceeding 150MPa (22ksi): a simpler way, Mater. J., 108, 46 Wille, 2015, Material efficiency in the design of ultra-high performance concrete, Constr. Build. Mater., 86, 33, 10.1016/j.conbuildmat.2015.03.087 Bakhshi, 2014, Comparative evaluation of early age toughness parameters in fiber reinforced concrete, Mater. Struct., 47, 853, 10.1617/s11527-013-0098-1 Yang, 2009, Influence of aggregate and curing regime on the mechanical properties of ultra-high performance fibre reinforced concrete (UHPFRC), Constr. Build. Mater., 23, 2291, 10.1016/j.conbuildmat.2008.11.012 Yoo, 2015, Structural performance of ultra-high-performance concrete beams with different steel fibers, Eng. Struct., 102, 409, 10.1016/j.engstruct.2015.08.029 Randl, 2014, Development of UHPC mixtures from an ecological point of view, Constr. Build. Mater., 67, 373, 10.1016/j.conbuildmat.2013.12.102 Aldahdooh, 2013, Evaluation of ultra-high-performance-fiber reinforced concrete binder content using the response surface method, Mater. Des., 52, 957, 10.1016/j.matdes.2013.06.034 Yu, 2014, Mix design and properties assessment of Ultra-High Performance Fibre Reinforced Concrete (UHPFRC), Cem. Concr. Res., 56, 29, 10.1016/j.cemconres.2013.11.002 Yu, 2015, Development of an eco-friendly Ultra-High Performance Concrete (UHPC) with efficient cement and mineral admixtures uses, Cem. Concr. Compos., 55, 383, 10.1016/j.cemconcomp.2014.09.024 Sobuz, 2016, Manufacturing ultra-high performance concrete utilising conventional materials and production methods, Constr. Build. Mater., 111, 251, 10.1016/j.conbuildmat.2016.02.102 Alsalman, 2017, Development of ultra-high performance concrete with locally available materials, Constr. Build. Mater., 133, 135, 10.1016/j.conbuildmat.2016.12.040 Tafraoui, 2016, Durability of the ultrahigh performances concrete containing metakaolin, Constr. Build. Mater., 112, 980, 10.1016/j.conbuildmat.2016.02.169 Huang, 2017, Effect of replacement of silica fume with calcined clay on the hydration and microstructural development of eco-UHPFRC, Mater. Des., 121, 36, 10.1016/j.matdes.2017.02.052 Schachinger, 2002, Early-age Cracking Risk and Relaxation by Restrained Autogenous Deformation of Ultrahigh Performance Concrete, 16 Huang, 2017, Effect of cement substitution by limestone on the hydration and microstructural development of ultra-high performance concrete (UHPC), Cem. Concr. Compos., 77, 86, 10.1016/j.cemconcomp.2016.12.009 Li, 2015, Effects of nano-silica and nano-limestone on flowability and mechanical properties of ultra-high-performance concrete matrix, Constr. Build. Mater., 95, 366, 10.1016/j.conbuildmat.2015.05.137 Yu, 2014, Effect of nano-silica on the hydration and microstructure development of Ultra-high Performance Concrete (UHPC) with a low binder amount, Constr. Build. Mater., 65, 140, 10.1016/j.conbuildmat.2014.04.063 Muhd Norhasri, 2016, Inclusion of nanometakaolin as additive in ultrahigh performance concrete (UHPC), Constr. Build. Mater., 127, 167, 10.1016/j.conbuildmat.2016.09.127 Van Tuan, 2011, Hydration and microstructure of ultrahigh performance concrete incorporating rice husk ash, Cem. Concr. Res., 41, 1104, 10.1016/j.cemconres.2011.06.009 Soliman, 2016, Development of ultra-high-performance concrete using glass powder – towards ecofriendly concrete, Constr. Build. Mater., 125, 600, 10.1016/j.conbuildmat.2016.08.073 Meng, 2016, Mechanical properties of ultra-high-performance concrete enhanced with graphite nanoplatelets and carbon nanofibers, Compos. Part B Eng., 107, 113, 10.1016/j.compositesb.2016.09.069 de Larrard, 1994, Optimization of ultra-high-performance concrete by the use of a packing model, Cem. Concr. Res., 24, 997, 10.1016/0008-8846(94)90022-1 Vance, 2015, The rheology of cementitious suspensions: a closer look at experimental parameters and property determination using common rheological models, Cem. Concr. Compos., 59, 38, 10.1016/j.cemconcomp.2015.03.001 Choi, 2016, Estimation of rheological properties of UHPC using mini slump test, Constr. Build. Mater., 106, 632, 10.1016/j.conbuildmat.2015.12.106 Roussel, 2005, From mini-cone test to Abrams cone test: measurement of cement-based materials yield stress using slump tests, Cem. Concr. Res., 35, 817, 10.1016/j.cemconres.2004.07.032 Pane, 2005, Investigation of blended cement hydration by isothermal calorimetry and thermal analysis, Cem. Concr. Res., 35, 1155, 10.1016/j.cemconres.2004.10.027 Vance, 2014 Washburn, 1921, Note on a method of determining the distribution of pore sizes in a porous material, Proc. Natl. Acad. Sci. U. S. A., 7, 115, 10.1073/pnas.7.4.115 Shi, 1985, Contact angle and damage during mercury intrusion into cement paste, Cem. Concr. Res., 15, 645, 10.1016/0008-8846(85)90064-X Liabastre, 1978, An evaluation of pore structure by mercury penetration, J. Colloid Interface Sci., 64, 1, 10.1016/0021-9797(78)90329-6 Arora, 2016, Ternary blends containing slag and interground/blended limestone: hydration, strength, and pore structure, Constr. Build. Mater., 102, 113, 10.1016/j.conbuildmat.2015.10.179 Vance, 2015, Rheological evaluations of interground and blended cement–limestone suspensions, Constr. Build. Mater., 79, 65, 10.1016/j.conbuildmat.2014.12.054 Lange, 1997, Dense packing of cement pastes and resulting consequences on mortar properties, Cem. Concr. Res., 27, 1481, 10.1016/S0008-8846(97)00189-0 Flatt, 2006, Yodel: a yield stress model for suspensions, J. Am. Ceram. Soc., 89, 1244, 10.1111/j.1551-2916.2005.00888.x Flatt, 2007, Yield stress of multimodal powder suspensions: an extension of the YODEL (yield stress mODEL), J. Am. Ceram. Soc., 90, 1038, 10.1111/j.1551-2916.2007.01595.x Olhero, 2004, Influence of particle size distribution on rheology and particle packing of silica-based suspensions, Powder Technol., 139, 69, 10.1016/j.powtec.2003.10.004 Vikan, 2007, Rheology of cementitious paste with silica fume or limestone, Cem. Concr. Res., 37, 1512, 10.1016/j.cemconres.2007.08.012 Vance, 2013, Hydration and strength development in ternary portland cement blends containing limestone and fly ash or metakaolin, Cem. Concr. Compos., 39, 93, 10.1016/j.cemconcomp.2013.03.028 Wallevik, 2009, Rheological properties of cement paste: thixotropic behavior and structural breakdown, Cem. Concr. Res., 39, 14, 10.1016/j.cemconres.2008.10.001 Menéndez, 2003, Strength development of ternary blended cement with limestone filler and blast-furnace slag, Cem. Concr. Compos., 25, 61, 10.1016/S0958-9465(01)00056-7 Molina, 1992 Puerta-Falla, 2015, Elucidating the role of the aluminous source on limestone reactivity in cementitious materials, J. Am. Ceram. Soc., 98, 4076, 10.1111/jace.13806 Bonavetti, 2001, Studies on the carboaluminate formation in limestone filler-blended cements, Cem. Concr. Res., 31, 853, 10.1016/S0008-8846(01)00491-4