Tensile behaviour and durability aspects of sustainable ultra-high performance concrete incorporated with GGBS as cementitious material

Benchmark report, 2017. India, World travel and tourism council, Retrieved 11 April 2018, https://www.wttc.org/-/media/files/reports/benchmark-reports/country-reports-2017/india.pdf. Monteiro, 2017, Towards sustainable concrete, Nat. Mater., 16, 698, 10.1038/nmat4930 Yang, 2014, Effect of supplementary cementitious materials on reduction of CO2 emissions from concrete, J. Clean. Prod. Miller, 2018, Supplementary cementitious materials to mitigate greenhouse gas emissions from concrete: can there be too much of a good thing?, J. Clean. Prod., 10.1016/j.jclepro.2018.01.008 Halit, 2008, Utilization of fly ash and ground granulated blast furnace slag as an alternative silica source in reactive powder concrete, Fuel, 87, 2401, 10.1016/j.fuel.2008.03.005 Megat, 2011, Influence of supplementary cementitious materials on engineering properties of high strength concrete, Constr. Build. Mater., 25, 2639, 10.1016/j.conbuildmat.2010.12.013 Zhao, 2015, The properties of the self-compacting concrete with fly ash and ground granulated blast furnace slag mineral admixture, J. Clean. Prod., 95, 66, 10.1016/j.jclepro.2015.02.050 Yu, 2015, Development of an eco-friendly ultra-high performance concrete (UHPC) with efficient cement and mineral admixtures uses, Cem. Concr. Compos., 55, 383, 10.1016/j.cemconcomp.2014.09.024 Aliakbar, 2017, Performance of sustainable concretes containing very high volume class-F fly ash and ground granulated blast furnace slag, J. Clean. Prod. Khatib, 2005, Selected engineering properties of concrete incorporating slag and metakaolin, Constr. Build. Mater., 19, 460, 10.1016/j.conbuildmat.2004.07.017 Siddique, 2014, Utilization (recycling) of iron and steel industry by-product (GGBS) in concrete: strength and durability properties, J. Mater. Cycles Waste., 16, 460, 10.1007/s10163-013-0206-x Erdogan, 2016, Utilization and efficiency of ground granulated blast furnace slag on concrete properties – a review, Constr. Build. Mater., 105, 423, 10.1016/j.conbuildmat.2015.12.153 Crossin, 2015, The greenhouse gas implications of using ground granulated blast furnace slag as a cement substitute, J. Clean. Prod., 95, 101, 10.1016/j.jclepro.2015.02.082 Pal, 2003, Investigation of hydraulic activity of ground granulated blast furnace slag in concrete, Cem. Concr. Res., 33, 1481, 10.1016/S0008-8846(03)00062-0 Yeau, 2005, An experimental study on corrosion resistance of concrete with ground granulate blast-furnace slag, Cem. Concr. Res., 35, 1391, 10.1016/j.cemconres.2004.11.010 Teng, 2013, Durability and mechanical properties of high strength concrete incorporating ultra fine ground granulated blast-furnace slag, Constr. Build. Mater., 40, 875, 10.1016/j.conbuildmat.2012.11.052 Anil, 2016, Ground granulated blast furnace slag amended fly ash as an expansive soil stabilizer, Soils Found., 56, 205, 10.1016/j.sandf.2016.02.004 Richard, 1994, Reactive powder concretes with high ductility and 200–800 MPa compressive strength, ACI SP144-24, 144, 507 Richard, 1995, Composition of reactive powder concretes, Cem. Concr. Res., 25, 1501, 10.1016/0008-8846(95)00144-2 Halit, 2010, Mechanical properties of reactive powder concrete containing high volumes of ground granulated blast furnace slag Cem, Concr. Compos., 32, 639, 10.1016/j.cemconcomp.2010.07.005 Halit, 2009, Mechanical properties of reactive powder concrete containing mineral admixtures under different curing regimes, Constr. Build. Mater., 23, 1223, 10.1016/j.conbuildmat.2008.08.003 Elchalakani, 2014, Sustainable concrete with high volume GGBS to build Masdar city in the UAE, Case Stud. Constr. Mater., 1, 10 Neville, 1996 Hassan, 2012, Experimental test methods to determine the uniaxial tensile and compressive behaviour of ultra high performance fibre reinforced concrete (UHPFRC), Constr. Build. Mater., 37, 874, 10.1016/j.conbuildmat.2012.04.030 IS 12269, 2013 ASTM C1437, 2015 ASTM C230, 2014 IS 4031-1988, 1988 ASTM C496, 2001 ASTM C 78, 2001 Brameshuber, 2016, Recommendation of RILEM TC 232-TDT: uniaxial tensile test: test method to determine the load-bearing behavior of tensile specimens made of textile reinforced concrete, Mater. Struct., 49, 4923, 10.1617/s11527-016-0839-z RILEM TCM-85, 1985, Determination of the fracture energy of mortar and concrete by means of three-point bend tests on notched beams, Mater. Struct., 18, 287, 10.1007/BF02472918 Karihaloo, 2003, A simple method for determining the true specific fracture energy of concrete, Mag. Concrete Res., 55, 471, 10.1680/macr.2003.55.5.471 Murthy, 2013, Determination of Size-independent specific fracture energy of concrete mixes by two methods, Cem. Concr. Res., 50, 19, 10.1016/j.cemconres.2013.03.015 Murthy, 2015, Fracture energy and tension softening relation for nano-modified concrete, Struct. Eng. Mech., 54, 1201, 10.12989/sem.2015.54.6.1201 ASTM C1202, 2001 ASTM C1585, 2001 Karihaloo, 1995 Elices, 1992, Measurement of the fracture energy using three-point bend tests: part 3-Influence of cutting the P – δ tail, Mater. Struct., 25, 137, 10.1007/BF02472591 Guinea, 1992, Measurement of the fracture energy using three-point bend tests: part 1-Influence of experimental procedures, Mater. Struct., 25, 212, 10.1007/BF02473065 Planas, 1992, Measurement of the fracture energy using three-point bend tests: part 2-Influence of bulk energy dissipation, Mater. Struct., 25, 305, 10.1007/BF02472671 Hu, 2000, Size effect on toughness induced by crack close to free surface, Eng. Fract Mech., 65, 209, 10.1016/S0013-7944(99)00123-X Hu, 1992, Fracture energy and fracture process zone, Mater. Struct., 25, 319, 10.1007/BF02472590 Vydra, 2016, Size independent fracture energy of concrete, Constr. Build. Mater., 26, 357, 10.1016/j.conbuildmat.2011.06.034