Development of 500 W PEM fuel cell stack for portable power generators

Babir, 1996, Efficiency and economics of proton exchange membrane (PEM) fuel cells, Int J Hydrogen Energy, 21, 891, 10.1016/0360-3199(96)00030-4 Fuel cell handbook [electronic resource], EG & G Technical Services, Inc. EG & G Services, National Energy Technology Laboratory (U.S), 2004. Mehta, 2003, Review and analysis of PEM fuel cell design and manufacturing, J Power Sources, 114, 32, 10.1016/S0378-7753(02)00542-6 Rodatz, 2004, J Power Sources, 128, 208, 10.1016/j.jpowsour.2003.09.060 Buxbaum, 2003, Power output and load following in a fuel cell fueled by membrane reactor, J Power Sources, 123, 43, 10.1016/S0378-7753(03)00359-8 Yan, 2006, Steady state and dynamic performance of proton exchange membrane fuel cells (PEMFCs) under various operating conditions and load changes, J Power Sources, 161, 492, 10.1016/j.jpowsour.2006.03.077 Miller, 2011, A review of polymer electrolyte membrane fuel cell stack testing, J Power Sources, 196, 601, 10.1016/j.jpowsour.2010.07.072 Yousfi-Steiner, 2008, A review on PEM voltage degradation associated with water management: impacts, influent factors and characterization, J Power Sources, 183, 260, 10.1016/j.jpowsour.2008.04.037 Weng, 2007, Design, fabrication and performance analysis of a 200W PEM fuel cell short stack, J Power Sources, 171, 179, 10.1016/j.jpowsour.2006.12.061 Lee, 1999, The effects of compression and gas diffusion layers on the performance of a PEM fuel cell, J Power Sources, 84, 45, 10.1016/S0378-7753(99)00298-0 Karimaki, 2011, The use of on-line hydrogen sensor for studying inert gas effects and nitrogen crossover in PEMFC system, Int J Hydrogen Energy, 36, 10179, 10.1016/j.ijhydene.2011.04.230 Jeong, 2006, Effects of cathode open area and relative humidity on the performance of air-breathing polymer electrolyte membrane fuel cells, J Power Sources, 158, 348, 10.1016/j.jpowsour.2005.09.044 Babcock, 2010, Optimization of passive air breathing fuel cell cathodes, J Fuel Cell Sci Technol, 02107 Fabian, 2010, Passive water management at the cathode of a planar air-breathing proton exchange membrane fuel cell, J Power Sources, 195, 3201, 10.1016/j.jpowsour.2009.12.030 Zhang, 2012, A critical review of cooling techniques in proton exchange membrane fuel cell stacks, Int J Hydrogen Energy, 37, 2412, 10.1016/j.ijhydene.2011.11.010 Maggio, 1996, Modeling of temperature distribution in a solid polymer electrolyte fuel cell stack, J Power Sources, 62, 167, 10.1016/S0378-7753(96)02433-0 Park, 2008, Development of a PEM stack and performance analysis including the effects of water content in the membrane and cooling method, J Power Sources, 179, 584, 10.1016/j.jpowsour.2008.01.050 Dhathathreyan, 1999, Development of polymer electrolyte membrane fuel cell stack, Int J Hydrogen Energy, 24, 1107, 10.1016/S0360-3199(98)00172-4 Alaefour, 2012, Measurement of current distribution in a proton exchange membrane fuel cell with various flow arrangements-a parametric study, Appl Energy, 93, 80, 10.1016/j.apenergy.2011.05.033 Antunesa, 2011, Carbon materials in composite bipolar plates for polymer electrolyte membrane fuel cells: a review of the main challenges to improve electrical performance, J Power Sources, 196, 2945, 10.1016/j.jpowsour.2010.12.041 Devrim, 2012, Improvement of PEMFC performance with Nafion/inorganic nanocomposite membrane electrode assembly prepared by ultrasonic coating technique, Int J Hydrogen Energy, 37, 16748, 10.1016/j.ijhydene.2012.02.148 Devrim, 2009, Preparation and characterization of sulfonated polysulfone/titanium dioxide composite membranes for proton exchange membrane fuel cells, Int J Hydrogen Energy, 34, 3467, 10.1016/j.ijhydene.2009.02.019 López-Sabirón, 2012, Design and development of the cooling system of a 2 kW nominal power open-cathode polymer electrolyte fuel cell stack, Int J Hydrogen Energy, 37, 7289, 10.1016/j.ijhydene.2011.11.073 Bates, 2013, Simulation of an innovative polymer electrolyte membrane fuel cell design for self-control thermal management, Int J Hydrogen Energy, 38, 8422, 10.1016/j.ijhydene.2013.04.114 Nguyen, 1993, A water and heat management model for proton exchange-membrane fuel cells, J Electrochem Soc, 140, 2178, 10.1149/1.2220792 Shahsavari, 2012, Thermal analysis of air-cooled PEM fuel cells, Int J Hydrogen Energy, 37, 18261, 10.1016/j.ijhydene.2012.09.075 Hwang, 2013, Thermal control and performance assessment of a proton exchanger membrane fuel cell generator, Appl Energy, 108, 184, 10.1016/j.apenergy.2013.03.025 Zhang, 2007, PEM fuel cells operated at 0% relative humidity in the temperature range of 23–120 °C, Electrochim. Acta, 52, 5095, 10.1016/j.electacta.2007.02.002 Perez-Page, 2011, Effect of the operation and humidification temperatures on the performance of a PEM fuel cell stack on dead-end mode, Int J Electrochem Sci, 6, 492, 10.1016/S1452-3981(23)15011-5 Wahdame, 2006, Study of gas pressure and flow rate influences on a 500 W PEM fuel cell, thanks to the experimental design methodology, J Power Sources, 156, 92, 10.1016/j.jpowsour.2005.08.036 Guvelioglu, 2007, Flow rate and humidification effects on a PEM fuel cell performance and operation, J Power Sources, 163, 882, 10.1016/j.jpowsour.2006.09.052 Hu, 2006, A 10 kW class PEM fuel cell stack based on the catalyst coated membrane (CCM) method, Int J Hydrogen Energy, 31, 1010, 10.1016/j.ijhydene.2006.02.018 Eckl, 2004, Experimental analysis of water management in a self-humidifying polymer electrolyte fuel cell stack, J Power Sources, 138, 137, 10.1016/j.jpowsour.2004.06.042 Neto, 2013, Thermal and electrical experimental characterization of a 1 kW PEM fuel cell stack, Int J Hydrogen Energy, 38, 5348, 10.1016/j.ijhydene.2013.02.025 Bujlo, 2013, Validation of an externally oil-cooled 1 kWel HT-PEMFC stack operating at various experimental conditions, Int J Hydrogen Energy, 38, 9847, 10.1016/j.ijhydene.2013.05.174 Hamaz, 2014, Diagnosis of PEM fuel cell stack based on magnetic fields measurements Li, 2012, The development and performance analysis of all-China-made PEM fuel cell unit and 1 kW level fuel cell stack, Int J Hydrogen Energy, 37, 1106, 10.1016/j.ijhydene.2011.02.080 Himanen, 2007, Operation of a planar free-breathing PEMFC in a dead-end mode, Electrochem Commun, 9, 891, 10.1016/j.elecom.2006.12.002 Zeng, 2013, Stack performance of phosphotungstic acid functionalized mesoporous silica (HPW-mesosilica) nanocomposite high temperature proton exchange membrane fuel cells, Int J Hydrogen Energy, 38, 1283, 10.1016/j.ijhydene.2013.07.108 Wang, 2011, A review of polymer electrolyte membrane fuel cells: technology, applications, and needs on fundamental research, Appl Energy, 88, 981, 10.1016/j.apenergy.2010.09.030 Cheng, 2007, A review of PEM hydrogen fuel cell contamination: impacts, mechanisms, and mitigation, J Power Sources, 165, 739, 10.1016/j.jpowsour.2006.12.012 Ahn, 2002, Performance and lifetime analysis of the kW-class PEMFC stack, J Power Sources, 106, 295, 10.1016/S0378-7753(01)01032-1 Collier, 2006, Degradation of polymer electrolyte membranes, Int J Hydrogen Energy, 31, 1838, 10.1016/j.ijhydene.2006.05.006