Restrained shrinkage behavior of internally-cured UHPC using calcined bauxite aggregate in the ring test and UHPC-concrete composite slab
Tóm tắt
Từ khóa
Tài liệu tham khảo
Du, 2021, New development of ultra-high-performance concrete (UHPC), Compos. B Eng., 224, 10.1016/j.compositesb.2021.109220
Li, 2019, Mitigation techniques for autogenous shrinkage of ultra-high-performance concrete–A review, Compos. B Eng., 178
Meng, 2017, Effects of saturated lightweight sand content on key characteristics of ultra-high-performance concrete, Cement Concr. Res., 101, 46, 10.1016/j.cemconres.2017.08.018
Liu, 2021, Microstructural and micromechanical characteristics of ultra-high performance concrete with superabsorbent polymer (SAP), Cement Concr. Res., 149, 10.1016/j.cemconres.2021.106560
Xie, 2018, Characterizations of autogenous and drying shrinkage of ultra-high performance concrete (UHPC): an experimental study, Cem. Concr. Compos., 91, 156, 10.1016/j.cemconcomp.2018.05.009
Shen, 2020, Investigation on expansion effect of the expansive agents in ultra-high performance concrete, Cem. Concr. Compos., 105, 10.1016/j.cemconcomp.2019.103425
Justs, 2015, Internal curing by superabsorbent polymers in ultra-high performance concrete, Cement Concr. Res., 76, 82, 10.1016/j.cemconres.2015.05.005
Liu, 2021, Effect of calcined bauxite powder or aggregate on the shrinkage properties of UHPC, Cem. Concr. Compos., 118, 10.1016/j.cemconcomp.2021.103967
Liu, 2021, Internal curing efficiency and key properties of UHPC influenced by dry or prewetted calcined bauxite aggregate with different particle size, Construct. Build. Mater., 312, 10.1016/j.conbuildmat.2021.125406
Liu, 2021, Internal curing by porous calcined bauxite aggregate in ultrahigh performance concrete, J. Mater. Civ. Eng., 33, 10.1061/(ASCE)MT.1943-5533.0003616
Wilson, 2016
Yu, 2019, Laboratory evaluation of critical properties and attributes of calcined bauxite and steel slag aggregates for pavement friction surfacing, J. Mater. Civ. Eng., 31, 10.1061/(ASCE)MT.1943-5533.0002806
Zhang, 2021, Effect of bauxite aggregate in cement composites on mechanical properties and resistance against high-velocity projectile impact, Cem. Concr. Compos., 118, 10.1016/j.cemconcomp.2020.103915
Bjøntegaard, 2011
Liu, 2018, Finite-element modeling and analysis of early-age cracking risk of cast-in-place concrete culverts, Transport. Res. Rec., 2672, 24, 10.1177/0361198118774157
Yoo, 2014, Influence of ring size on the restrained shrinkage behavior of ultra high performance fiber reinforced concrete, Mater. Struct., 47, 1161, 10.1617/s11527-013-0119-0
Wang, 2019, Restrained shrinkage mechanism of ultra high performance concrete, KSCE J. Civ. Eng., 23, 4481, 10.1007/s12205-019-0387-5
Chilwesa, 2019, Shrinkage induced edge curling and debonding in slab elements reinforced with bonded overlays: influence of fibers and SRA, Cem. Concr. Compos., 102, 105, 10.1016/j.cemconcomp.2019.04.017
Bao, 2017, Distributed fiber optic sensor-enhanced detection and prediction of shrinkage-induced delamination of ultra-high-performance concrete overlay, Smart Mater. Struct., 26, 10.1088/1361-665X/aa71f4
Teng, 2021, Design and performance of low shrinkage UHPC for thin bonded bridge deck overlay, Cem. Concr. Compos., 118, 10.1016/j.cemconcomp.2021.103953
Kheir, 2021, Early age autogenous shrinkage cracking risk of an ultra-high performance concrete (UHPC) wall: modelling and experimental results, Eng. Fract. Mech., 257, 10.1016/j.engfracmech.2021.108024
Zhu, 2020, Experimental study and theoretical prediction on shrinkage-induced restrained stresses in UHPC-RC composites under normal curing and steam curing, Cem. Concr. Compos., 110, 10.1016/j.cemconcomp.2020.103602
Haber, 2017
Wibowo, 2018
2008
GB/T 50080-2016, 2016
GB/T 50081-2002, 2002
Hisseine, 2020, Nano-engineered ultra-high performance concrete for controlled autogenous shrinkage using nanocellulose, Cement Concr. Res., 137, 10.1016/j.cemconres.2020.106217
2019
2018
Soliman, 2012, Early-age shrinkage of ultra-high performance concrete under drying/wetting cycles and submerged conditions, ACI Mater. J., 109, 131
Shi, 2015, A review on ultra high performance concrete: Part I. Raw materials and mixture design, Construct. Build. Mater., 101, 741, 10.1016/j.conbuildmat.2015.10.088
Watanabe, 2019, An experimental study on the mechanical and durability properties of UHPFRC for cast-in-place method, vol. 2
Habel, 2004
Denarié, 2006
Lukovi, 2012, Reliable concrete repair – a critical review
Lange, 2001, Early age stresses and debonding in bonded concrete overlays, Transport. Res. Rec., 1778, 174, 10.3141/1778-21
Granger, 2007, Experimental characterization of the self-healing of cracks in an ultra high performance cementitious material: mechanical tests and acoustic emission analysis, Cement Concr. Res., 37, 519, 10.1016/j.cemconres.2006.12.005
Beglarigale, 2021, Evaluation of enhanced autogenous self-healing ability of UHPC mixtures, Construct. Build. Mater., 280, 10.1016/j.conbuildmat.2021.122524
Craig, 2018
Haber, 2018, Bond characterization of UHPC overlays for concrete bridge decks: laboratory and field testing, Construct. Build. Mater., 190, 1056, 10.1016/j.conbuildmat.2018.09.167
Carbonell Muñoz, 2014, Bond performance between ultrahigh-performance concrete and normal-strength concrete, J. Mater. Civ. Eng., 26, 10.1061/(ASCE)MT.1943-5533.0000890
Zhang, 2019, Flexural behaviors and capacity prediction on damaged reinforcement concrete (RC) bridge deck strengthened by ultra-high performance concrete (UHPC) layer, Construct. Build. Mater., 215, 347, 10.1016/j.conbuildmat.2019.04.229