De-stressed mining of multi-seams: Surrounding rock control during the mining of a roadway in the overlying protected seam

Mining Science and Technology (China) - Tập 21 - Trang 159-164 - 2011
Wang Cheng1, Zhang Nong1, Li Guichen1, Zhang Nianchao1
1School of Mines, State Key Laboratory of Coal Resources and Safe Mining, China University of Mining & Technology, Xuzhou 221008, China

Tài liệu tham khảo

Ye, 1999, Coal reservoir permeability and its controlled factors in China, Journal of China Coal Society, 24, 118 Cheng, 2003, Application of safe and high-efficient exploitation system of coal and gas in coal seams, Journal of China University of Mining and Technology, 32, 471 Yuan, 2007, Study on critical, modern technology for mining in gassy deep mines, Journal of China University of Mining and Technology, 17, 226, 10.1016/S1006-1266(07)60077-7 Yuan, 2009, Theory of pressure-relieved gas extraction and technique system of integrated coal production and gas extraction, Journal of China Coal Society, 34, 1 Yuan, 2009, Technique of coal mining and gas extraction without coal pillar in multi-seam with low permeability, Journal of Coal Science & Engineering, 25, 120, 10.1007/s12404-009-0202-x Liu, 2009, Pressure relief, gas drainage and deformation effects on an overlying coal seam induced by drilling an extra-thin protective coal seam, Mining Science and Technology, 19, 724 Liu, 2010, Fissure evolution and evaluation of pressure-relief gas drainage in the exploitation of super-remote protected seams, Mining Science and Technology, 20, 178 Hu, 2009, Numerical simulation of protection range in exploiting the upper protective layer with a bow pseudo-incline technique, Mining Science and Technology, 19, 58 Qian, 2003 Jiang, 2004, Study and practice of bottom slicing relieving mining in condition of trouble coal seams with high ground stress under deep coal mine, Journal of China Coal Society, 29, 1 Tu, 2006, Deformation rule of protected coal seam exploited by using the long-distance-lower protective seam method, Journal of Mining and Safety Engineering, 23, 253 Ma, 2008, Rock mass deformation characteristics for coal mining at remote lower protective seam, Journal of Mining and Safety Engineering, 25, 253 Ma, 2008, Study of ascending mining of short-range-seams in Ping Dingshan Coal Mine No. 4, Journal of Mining and Safety Engineering, 25, 357 Shi, 2008, Numerical simulation of the upper coal and rock deformation characteristic caused by mining protecting stratum, Journal of China Coal Society, 33, 17 Wang, 2009, Similar material simulation experiment on destressing effects of the deep thick coal seam with high burst liability after mining upper and lower protective seams, Chinese Journal of Geotechnical Engineering, 31, 442 Chen, 1994 Peng, 2002, Study on over rock moving and roadway deformation within the curve subsidence zone, Journal of China Coal Society, 27, 21 Xie, 2004, Stability analysis of surrounding rock masses of roadway under overhead mining, Chinese Journal of Rock Mechanics and Engineering, 23, 1986 Li, 2006, Simulation analysis of surrounding rock de-formation law of main entry with the below seams mined, Journal of China Coal Society, 31, 1 Li, 2008, Numerical simulation of stability of surrounding rock in high horizontal stress roadway under overhead mining, Journal of Mining and Safety Engineering, 25, 420 Fang, 2009, Research on reinforced technology for deep soft rock and dynamic pressurized roadway under high stress, Rock and Soil Mechanics, 30, 1693 Wang, 2006, Numerical simulation of bolt-grouting support in soft roadway affected by mining, Journal of Mining and Safety Engineering, 23, 39 Zhang, 2006, Control principle of separating and broken roof rock strata in roadway, Journal of Mining and Safety Engineering, 23, 234 Zhang, 2009, Rapid development of coalmine bolting in China, Procedia Earth and Planetary Science, 1, 41, 10.1016/j.proeps.2009.09.009