Dynamic wind loads and wake characteristics of a wind turbine model in an atmospheric boundary layer wind
Tóm tắt
An experimental study was conducted to characterize the dynamic wind loads and evolution of the unsteady vortex and turbulent flow structures in the near wake of a horizontal axis wind turbine model placed in an atmospheric boundary layer wind tunnel. In addition to measuring dynamic wind loads (i.e., aerodynamic forces and bending moments) acting on the wind turbine model by using a high-sensitive force-moment sensor unit, a high-resolution digital particle image velocimetry (PIV) system was used to achieve flow field measurements to quantify the characteristics of the turbulent vortex flow in the near wake of the wind turbine model. Besides conducting “free-run” PIV measurements to determine the ensemble-averaged statistics of the flow quantities such as mean velocity, Reynolds stress, and turbulence kinetic energy (TKE) distributions in the wake flow, “phase-locked” PIV measurements were also performed to elucidate further details about evolution of the unsteady vortex structures in the wake flow in relation to the position of the rotating turbine blades. The effects of the tip-speed-ratio of the wind turbine model on the dynamic wind loads and wake flow characteristics were quantified in the terms of the variations of the aerodynamic thrust and bending moment coefficients of the wind turbine model, the evolution of the helical tip vortices and the unsteady vortices shedding from the blade roots and turbine nacelle, the deceleration of the incoming airflows after passing the rotation disk of the turbine blades, the TKE and Reynolds stress distributions in the near wake of the wind turbine model. The detailed flow field measurements were correlated with the dynamic wind load measurements to elucidate underlying physics in order to gain further insight into the characteristics of the dynamic wind loads and turbulent vortex flows in the wakes of wind turbines for the optimal design of the wind turbines operating in atmospheric boundary layer winds.
Tài liệu tham khảo
Alfredsson PH, Dahlberg JA (1979) A preliminary wind tunnel study of windmill wake dispersion in various flow conditions. Technical note AU-1499, part 7, FFA, Stockholm
Alfredsson PH, Dahlberg JA, Vermeulen PEJ (1982) A comparison between predicted and measured data from wind turbine wakes. Wind Eng 6(3):149–155
American Society of Civil Engineering (2005) ASCE 7-05 minimum design loads for building and other structures, ASCE
Anderson MB, Milborrow DJ, Ross NJ (1982) Performance and wake measurements on a 3 m diameter horizontal axis wind turbine: comparison of theory, wind tunnel and field test data. Technical report, Department of Physics, University of Cambridge
Architecture Institute of Japan (1996) AIJ recommendations for loads on buildings, AIJ
Bingol F, Larsen GC, Mann J (2007) Wake meandering—an analysis of instantaneous 2D laser measurements. J Phys Conf Ser 75:012059
Boeing (1982) Mod-2 wind turbine system development final report, vol II detailed report, nASACR-168007, DOE/NASA/0002-82/2. NASA Lewis Research Center, Cleveland
Cal R, Lebron J, Castillo L, Kang H, Meneveau C (2010) Experimental study of the horizontally averaged flow structure in a model wind-turbine array boundary layer. J Renew Sustain Energy 2:013106
Chamorro LP, Porte-Agel F (2009) A wind-tunnel investigation of wind-turbine wakes: boundary layer turbulence effects. Bound Layer Meteorol 132:129–149
Ebert PR, Wood DH (1997) The near wake of a model horizontal-axis wind turbine: part 1: experimental arrangements and initial results. Renew Energy 2:225–243
Grant I, Parkin PA (2000) DPIV study of the trailing vortex elements from the blades of a horizontal axis wind turbine in yaw. Exp Fluids 28:368–376
Hand MM, Simms DA, Fingersh LJ, Jager DW, Cotrell JR, Schreck S, Larwood SM (2001) Unsteady Aerodynamics Experiment Phase VI: wind tunnel test configurations and available data campaigns. National Renewable Energy Laboratory, Golden, CO, NREL/TP-500-29955
Jain P (2007) Wind energy engineering. McGraw Hill. ISBN:978-0-07-171477-8
Larsen GC, Madsen HA, Thomsen K, Larsen TJ (2008) Wake meandering: a pragmatic approach. Wind Energy 11:377–395
Massouh H, Dobrev I (2007) Exploration of the vortex behind of wind turbine rotor. J Phys Conf Ser 75:012036
Medici D, Alfredsson PH (2006) Measurements on a wind turbine wake: 3D Effects and bluff body vortex shedding. Wing Energy 9:219–236
Schreck S, Lundquist J, Shaw W (2008) U. S. Department of Energy workshop report: research needs for wind resource characterization. National Renewable Energy Laboratory technical report, NREL/TP-500-43521
Spera AD (1994) Wind turbine technology. ASME Press, New York, pp 219–220
Tsustui Y, Matsumya H (1987) LDV measurements of flow field around a wind turbine. Wind Power 381–386
Vermeer LJ (2001) A review of wind turbine wake research at TU-Delft. A collection of the 2001 ASME wind energy symposium technical papers. ASME, New York, pp 103–113
Vermeer LJ, Sorensen JN, Crespo A (2003) Wind turbine wake aerodynamics. Prog Aerosp Sci 39:467–510
Whale J, Anderson CG, Bareiss R, Wagner S (2000) An experimental and numerical study of the vortex structure in the wake of a wind turbine. J Wind Eng Ind Aerodyn 84:1–21