The effect of the macroscopic surface morphology caused by the uneven wear on friction induced vibration

Akay, 2002, Acoustics of friction, J Acoust Soc Am, 114, 1525, 10.1121/1.1456514 Ibrahim, 1994, Friction-induced vibration, chatter, squeal, and chaos–Part II: dynamics and modelling, Appl Mech Rev, 47, 227, 10.1115/1.3111080 Lyu, 2015, On the relationships among wheel–rail surface topography, interface noise and tribological transitions, Wear, 338–339, 36, 10.1016/j.wear.2015.05.014 Lorang, 2006, TGV disc brake squeal, J Sound Vib, 293, 735, 10.1016/j.jsv.2005.12.006 Vaishya, 2001, Sliding friction-induced non-linearity and parametric effects in gear dynamics, J Sound Vib, 248, 671, 10.1006/jsvi.2001.3818 Yang, 2013, Analyzing the mechanisms of fatigue crack initiation and propagation in CRH EMU brake discs, Eng Fail Anal, 34, 121, 10.1016/j.engfailanal.2013.07.004 Lu, 2018, Improvement of dynamical and tribological properties of friction systems by introducing parallel-grooved structures in elastic damping components, Compos Struct, 192, 8, 10.1016/j.compstruct.2018.02.055 Massi, 2008, Contact surface topography and system dynamics of brake squeal, Wear, 265, 1784, 10.1016/j.wear.2008.04.049 Papinniemi, 2002, Brake squeal: a literature review, Appl Acoust, 63, 391, 10.1016/S0003-682X(01)00043-3 Kinkaid, 2003, Automotive disc brake squeal, J Sound Vib, 267, 105, 10.1016/S0022-460X(02)01573-0 Ouyang, 2005, Numerical analysis of automotive disc brake squeal: a review, Int J Veh Noise Vib, 1, 207, 10.1504/IJVNV.2005.007524 Yoon, 2012, Effect of surface contact conditions on the stick–slip behaviour of brake friction material, Wear, 294, 305, 10.1016/j.wear.2012.07.011 Mills, 1938, Brake squeak Fosberry, 1959 Spurr, 1961, A theory of brake squeal, 1, 33 Hoffmann, 2002, A minimal model for studying properties of the mode-coupling type instability in friction induced oscillations mode-coupling type instability in friction induced oscillations, Mech Res Commun, 29, 197, 10.1016/S0093-6413(02)00254-9 Giannini, 2006, Experimental analysis of brake squeal noise on a laboratory brake setup, J Sound Vib, 292, 1, 10.1016/j.jsv.2005.05.032 Duffour, 2004, Instability of systems with a frictional point contact. Part 2: model extensions, J Sound Vib, 271, 391, 10.1016/j.jsv.2003.02.004 Butlin, 2009, Sensitivity of friction-induced vibration in idealised systems, J Sound Vib, 319, 182, 10.1016/j.jsv.2008.05.034 Bergma, 1999, Influence of disc topography on generation of brake squeal, Wear, 621, 225 Eriksson, 2001, Friction behaviour and squeal generation of disc brakes at low speeds, Proc Inst Mech Eng - Part D J Automob Eng, 215, 1245, 10.1243/0954407011528789 Eriksson, 1999, Surface characterisation of brake pads after running under silent and squealing conditions, Wear, 232, 163, 10.1016/S0043-1648(99)00141-6 Massi, 2008, Contact surface topography and system dynamics of brake squeal, Wear, 265, 1784, 10.1016/j.wear.2008.04.049 Wang, 2018, Effect of surface roughness on friction-induced noise: exploring the generation of squeal at sliding friction interface, Wear, 402–403, 80, 10.1016/j.wear.2018.02.005 Rusli, 2007, Effect of surface topography on mode-coupling model of dry contact sliding systems, J Sound Vib, 308, 721, 10.1016/j.jsv.2007.03.046 Sherif, 2004, Investigation on effect of surface topography of pad/disc assembly on squeal generation, Wear, 257, 687, 10.1016/j.wear.2004.03.015 Lyu, 2017, Analysis of friction-induced vibration leading to brake squeal using a three degree-of-freedom model, Tribol Lett, 65, 1, 10.1007/s11249-017-0887-8 Eadie, 2002, The role of high positive friction (HPF) modifier in the control of short pitch corrugations and related phenomena, Wear, 253, 185, 10.1016/S0043-1648(02)00098-4 Lacerra, 2018, Validation of a new frictional law for simulating friction-induced vibrations of rough surfaces, Tribol Int, 121, 468, 10.1016/j.triboint.2018.01.052 Bonnay, 2015, Influence of geometry imperfections on squeal noise linked to mode lock-in, Int J Solid Struct, 75–76, 99, 10.1016/j.ijsolstr.2015.08.004 Suh, 2010, Effect of geometrical parameters in micro-grooved crosshatch pattern under lubricated sliding friction, Tribol Int, 43, 1508, 10.1016/j.triboint.2010.02.012 Lazim, 2016, Squealing characteristics of worn brake pads due to silica sand embedment into their friction layers, Wear, 358–359, 123, 10.1016/j.wear.2016.04.006 Diao, 2014, Mechanism study on time-varying characteristics of frictional squeal in pin-on-disc system, SAE Technical Paper Series, 01, 1 Wang, 2016, Noise performance improvements and tribological consequences of a pad-on-disc system through groove-textured disc surface, Tribol Int, 102, 222, 10.1016/j.triboint.2016.05.030 Wang, 2014, Experimental and numerical studies of friction-induced vibration and noise and the effects of groove-textured surfaces, Mech Syst Signal Process, 46, 191, 10.1016/j.ymssp.2014.02.007 Oberst, 2008, A critical review of brake squeal and its treatment in practice Li, 2018, Effect of textured surface on the frictional noise under line contact and sliding-rolling conditions, Proc Inst Mech Eng C J Mech Eng Sci, 232, 1679, 10.1177/0954406217706721 Olshevskiy, 2012, Finite element analysis of railway disc brake considering structural, thermal, and wear phenomena, Proc Inst Mech Eng C J Mech Eng Sci, 226, 1845, 10.1177/0954406211428705 Bakar, 2008, Finite element analysis of wear and its effect on squeal generation, Proc Inst Mech Eng - Part D J Automob Eng, 222, 1153, 10.1243/09544070JAUTO536 Bakar, 2008, Wear prediction of friction material and brake squeal using the finite element method, Wear, 264, 1069, 10.1016/j.wear.2007.08.015 Xie, 2014, Brake pad taper wear on brake moan noise, Int J Automot Technol, 15, 565, 10.1007/s12239-014-0059-x Butlin, 2010, Friction-induced vibration: quantifying sensitivity and uncertainty, J Sound Vib, 329, 509, 10.1016/j.jsv.2009.09.026 Ouyang, 2003, Vibration and squeal of a disc brake: modelling and experimental results, Proc Inst Mech Eng - Part D J Automob Eng, 217, 867, 10.1243/095440703769683270 Tonazzi, 2014, Experimental and numerical analysis of frictional contact scenarios: from macro stick–slip to continuous sliding, Meccanica, 50, 649, 10.1007/s11012-014-0010-2 Tonazzi, 2013, Instability scenarios between elastic media under frictional contact, Mech Syst Signal Process, 40, 754, 10.1016/j.ymssp.2013.05.022 Massi, 2007, Brake squeal: linear and nonlinear numerical approaches, Mech Syst Signal Process, 21, 2374, 10.1016/j.ymssp.2006.12.008 Gui, 2016, A simulation method of thermo-mechanical and tribological coupled analysis in dry sliding systems, Tribol Int, 103, 121, 10.1016/j.triboint.2016.06.021 Archard, 1953, Contact and rubbing of flat surfaces, J Appl Phys, 24, 981, 10.1063/1.1721448 Lee, 2018, Effect of plateau distribution on friction instability of brake friction materials, Wear, 400–401, 1, 10.1016/j.wear.2017.12.015 Neisa, 2017, Towards a better understanding of the structures existing on the surface of brake pads, Tribol Int, 105, 135, 10.1016/j.triboint.2016.09.033 Bajer, 2003, Combining a nonlinear static analysis and complex eigenvalue extraction in brake squeal simulation, SAE Paper, 10.4271/2003-01-3349 Wang, 2013, Numerical study of friction-induced vibration and noise on groove-textured surface, Tribol Int, 64, 1, 10.1016/j.triboint.2013.02.031 Oura, 2009, Influence of dynamic stiffness in contact region on disc brake Squeal, J Environ Eng, 4, 234, 10.1299/jee.4.234