Durability studies on eco-friendly concrete mixes incorporating steel slag as coarse aggregates

Adam, 2009 Alexander, 2014 Alexander, 2013 Alizadeh, 1996 Allahverdi, 2000, Acidic corrosion of hydrated cement based materials Part 1. – mechanism of the phenomenon, Ceram. – Silik., 44, 114 Ameri, 2012 Blaakmeer, 1994, An alkali activated slag fly ash binder for acid resistant concrete, 1, 347 Bonen, 1992, Composition and appearance of magnesium silicate hydrate and its relation to deterioration of cement based materials, J. Am. Cer. Soc., 75, 2904, 10.1111/j.1151-2916.1992.tb05530.x Bonen, 1992, Magnesium sulphate attack on Portland cement paste – I. Microstructural analysis, Cem. Concr. Res., 22, 169, 10.1016/0008-8846(92)90147-N Carlo, 2013, Properties of concretes with black/oxidizing electric arc furnace slag aggregate, Cem. Concr. Compos, 37, 232, 10.1016/j.cemconcomp.2012.09.001 Duxson, 2007, Geopolymer technology: the current state of art, J Mater. Sci., 42, 2917, 10.1007/s10853-006-0637-z Eloneva, 2010, Co-utilisation of CO2 and steelmaking slags for production of pure CaCO3 -legislative issues, J. Clean. Prod., 18, 1833, 10.1016/j.jclepro.2010.07.026 FHWA, 2012, 97 Forster, 2006 Fruehan, 1985, The making shaping and treating of steel, Assoc. Iron Steel Eng. Gambhir, 2004 Gebhardt, 1988 Habert, 2011, An environmental evaluation of geopolymer based concrete production: reviewing current research trends, J. Clean. Prod., 19, 1229, 10.1016/j.jclepro.2011.03.012 Ismail, 2013, Influence of fly ash on the water and chloride permeability of alkali-activated slag mortars and concretes, Const. Build. Mater., 48, 1187, 10.1016/j.conbuildmat.2013.07.106 Ivanka, 2011, Utilisation of steel slag as an aggregate in concrete, Mater. Struct., 44, 1565, 10.1617/s11527-011-9719-8 Kandhal, 1997, Evaluation of steel slag fine aggregate in hot-mix asphalt mixtures, Trans. Res. Rec., 1583, 28, 10.3141/1583-04 Kawamura, 1983, Applicability of basic oxygen furnace slag as a concrete aggregate, Am. Concr. Insti., 79, 1123 Lu, 1992, The research and the reactive products and mineral phase for FKJ cementitious material, III, 319 Manso, 2004, Electric furnace arc slag in concrete, J. Mater. Civ. Eng. ASCE, 16, 639, 10.1061/(ASCE)0899-1561(2004)16:6(639) Maslehuddin, 2003, Comparison of properties of steel slag and crushed limestone aggregate concretes, Const. Build. Mater., 17, 105, 10.1016/S0950-0618(02)00095-8 Mathur, 1999, Utilization of industrial wastes in low-volume roads, Trans. Res. Rec., 1652, 246, 10.3141/1652-31 McLellan, 2011, Costs and carbon emissions for geopolymer pastes in comparison to ordinary portland cement, J. Clean. Prod., 19, 1080, 10.1016/j.jclepro.2011.02.010 Mehta, 1974, A new test for sulfate resistance of cements, J. Test Eva., 2, 510, 10.1520/JTE11684J Mithun, 2015, Performance of alkali activated slag concrete mixes incorporating copper slag as fine aggregates, J. Clean. Prod., 1 Mithun, 2015, Flexural fatigue performance of alkali activated slag concrete mixes incorporating copper slag as fine aggregate, SSP – J. Civ. Eng., 10, 7 Motz, 2001, Products of steel slags: an opportunity to save natural resources, Waste Manag., 21, 285, 10.1016/S0956-053X(00)00102-1 Nuaklong, 2015, Influence of recycled aggregate on fly ash geopolymer concrete properties, J. Clean. Prod., 1 Palankar, 2014, Experimental investigation on air-cured alkali activated ggbfs-fly ash concrete mixes, Int. J. Adv. Struct. Geotech. Eng., 3, 326 Palankar, 2015, Studies on eco-friendly concrete incorporating industrial waste as aggregates, Int. J. Sust. Built. Env., 10.1016/j.ijsbe.2015.05.002 Palankar, 2015, Air-cured alkali activated binders for concrete pavements, Int. J. Pave. Res. Tech., 8, 289 Pavlik, 1994, Corrosion of hardened cement paste by acetic and nitric acids. Part I: calculation of corrosion depth, Cem. Concr. Res., 24, 551, 10.1016/0008-8846(94)90144-9 Perna, 2015, The setting time of a clay-slag geopolymer matrix: the influence of blast-furnace-slag addition and the mixing method, J. Clean. Prod., 1 Provis, 2013, 185 Rajamane, 2013 Rashad, 2013, A comprehensive overview about the influence of different additives on the properties of alkali-activated slag – a guide for civil engineer, Const. Build. Mater., 47, 29, 10.1016/j.conbuildmat.2013.04.011 Rashad, 2015, An investigation on blast-furnace stag as fine aggregate in alkali activated slag mortars subjected to elevated temperatures, J. Clean. Prod., 1 Shi, 1996, Strength, pore structure and permeability of alkali-activated slag mortars, Cem. Concr. Res., 26, 1789, 10.1016/S0008-8846(96)00174-3 Shi, 2006 Thomas, 2013, Mechanical properties and durability characteristics of concrete containing solid waste materials, J. Clean. Prod., 10.1016/j.jclepro.2013.11.019 van Der Laan, 2008, Chemical reduction of CO2 to carbon at ambient conditions during artificial weathering of converter steel slag while improving environmental properties Wang, 1995, Hydration products of alkali-activated slag cement, Cem. Concr. Res., 25, 561, 10.1016/0008-8846(95)00045-E Yang, 2013, Assessment of CO2 reduction of alkali-activated concrete, J. Clean. Prod., 39, 265, 10.1016/j.jclepro.2012.08.001 Yang, 2014, Properties and sustainability of alkali-activated slag foamed concrete, J. Clean. Prod., 68, 226, 10.1016/j.jclepro.2013.12.068