MEMS-enabled thermal management of high-heat-flux devices EDIFICE: embedded droplet impingement for integrated cooling of electronics

Nakayama, 1990, Cooling electronic equipment past present and future, 3 Park, 1998, Boiling heat transfer characteristics of simulated microelectronic chips with detechable heat sinks, vol. 4, 2099 Park, 1988, Effects of size of simulated microelectronic chips on boiling and critical heat flux, Journal of Heat Transfer, 110, 728, 10.1115/1.3250552 Bergles, 1988, A method to reduce temperature overshoots in immersion cooling of electronic devices, 100 Carvalho, 1990, The influence of subcooling on the pool nucleate boiling and critical heat flux of simulated electronic chips, 289 Park, 1990, Boiling heat transfer characteristics of simulated microelectronic chips with fluorinert liquids, 573 Bergles, 1990, Direct liquid cooling of microelectronic components, vol. 2, 233 Ma, 1983, Boiling jet impingement cooling of simulated microelectrnic chips, Heat Transfer in Electronic Equipment HTD, 28, 5 Golobic, 1992, Effects of thermal properties and thickness of horizontal vertically oriented ribbon heaters on the pool boiling critical heat flux, 213 Zitz, 1993, Immersion cooling of a multichip module by pool boiling of FC-86, Advances in Electronic Packaging ASME, 2, 917 Incropera, 1990, Liquid immersion cooling of electronic components, 407 Bar-Cohen, 1993, Thermal management of electronic components with dielectric liquids, International Journal of JSME, 36, 1, 10.1299/jsmeb.36.1 Nonn, 1989, Jet impingement flow boiling of a mixture of FC-72 and FC-87 liquids on a simulated electronic chip, ASME HTD – Heat Transfer in Electronics, 111, 121 Nakayama, 1994, Heat transfer from chips to dielectric coolant: enhanced pool boiling versus jet impingement cooling, Enhanced Heat Transfer, 1, 231, 10.1615/JEnhHeatTransf.v1.i3.50 Copeland, 1998, Single-phase and boiling cooling of a small heat source by multiple nozzle jet impingement, International Journal of Heat and Mass Transfer, 39, 1395 Ma, 1993, Liquid jet impingement heat transfer with or without boiling, Journal of Thermal Science, 2, 32, 10.1007/BF02650835 Incropera, 1996, Local jet impingement boiling heat transfer, International Journal of Heat and Mass Transfer, 39, 1395, 10.1016/0017-9310(95)00216-2 Wang, 1999, A computational study of two-phase jet impingement cooling of an electronic chip, 10 Peterson, 1994 Palm, 1996, Cooling of electronics by heat pipes and thermosyphons – a review of methods and possibilities, vols. 7&329, 97 Stevens, 1989, Local heat transfer coefficients under an axisymmetric single-phase liquid jet, ASME HTD – Heat Transfer in Electronics, 111, 113 Womac, 1990, Single-phase liquid jet impingement cooling of small heat sources, 149 Womac, 1993, Correlating equations for impingement cooling of small heat sources with single circular liquid jets, ASME Journal of Heat Transfer, 115, 106, 10.1115/1.2910635 Womac, 1994, Correlating equations for impingement cooling of small heat sources with multiple circular liquid jets, ASME Journal of Heat Transfer, 116, 482, 10.1115/1.2911423 Maddox, 1994, Thermofluid design of single-phase submerged-jet impingement cooling for electronic components, Journal of Electronic Packaging, 116, 237, 10.1115/1.2905692 Martin, 1977, Heat and mass transfer between impinging gas jets and solid surfaces, Advances in Heat Transfer, 13, 1, 10.1016/S0065-2717(08)70221-1 Wadsworth, 1990, Cooling of a multichip electronic module by means of confined two-dimensional jets of dielectric liquid, ASME Journal of Heat Transfer, 112, 891, 10.1115/1.2910496 Zumbrunnen, 1993, Convective heat transfer enhancement due to intermittency in an impinging jet, ASME Journal of Heat Transfer, 115, 91, 10.1115/1.2910675 Liu, 1989, Liquid jet impingement heat transfer on a uniform flux surface, Heat Transfer Phenomena in Radiation, Combustion and Fires ASME HTD, 106, 523 Liu, 1991, Convective heat transfer by impingement of circular liquid jets, ASME Journal of Heat Transfer, 113, 571, 10.1115/1.2910604 Liu, 1992, Stagnation point heat transfer during impingement of laminar liquid jets: analysis with surface tension effects, General Papers in Heat Transfer, ASME HTD, 204, 173 Schafer, 1992, Numerical simulation of laminar convection heat transfer from an in-line array of discrete sources to a confined rectangular jet, Numerical Heat Transfer, 22, 121, 10.1080/10407789208944762 Rahman, 1998, Numerical modeling of conjugate heat transfer during free liquid jet impingement, vol. 38, 475 Wang, 1989, Conjugate heat transfer between a laminar impinging liquid jet and a solid disk, International Journal of Heat and Mass Transfer, 32, 2189, 10.1016/0017-9310(89)90125-7 Ravigururajan, 1994, Visualization of flow phenomena near enhanced surfaces, Journal of Heat Transfer, 116, 54, 10.1115/1.2910883 Reid, 1991, A comparison of augmentation techniques during in-tube evaporation of R-113, Journal of Heat Transfer, 113, 451, 10.1115/1.2910582 Thome, 1990 Webb, 1994 Nakayama, 1980, Dynamic model of enhancement boiling heat transfer on porous surfaces, Part I: experimental investigation, ASME Journal of Heat Transfer, 102, 445, 10.1115/1.3244320 W. Nakayama, T. Nakajima, S. Hirasawa, Heat Sink Studs Having Enhanced Boiling Surfaces for Cooling Microelectronic Components, ASME 84-WA/HT-89, 1984 W.J. Miller, Boiling and visualization from microconfigured surfaces, M.S. Thesis, University of Pennsylvania, Philadelphia, PA, 1991 Bhavnani, 1993, An integral heat sink for cooling microelectronic components, ASME Journal of Electronic Packaging, 115, 284, 10.1115/1.2909330 Sullivan, 1992, Use of smooth and roughened spreader plates to enhance impingement cooling of small heat sources with single circular jets, ASME HTD – Topics in Heat Transfer, 206, 103 Teuscher, 1993, Jet impingement cooling of an array of discrete heat sources with extended surfaces, ASME HTD – Enhanced Cooling Techniques for Electronic Applications, 263, 1 Wadsworth, 1992, Enhancement of single-phase heat transfer and critical heat flux from an ultra-high-flux simulated microelectronic heat source to a rectangular impinging jet of dielectric liquid, ASME Journal of Heat Transfer, 114, 764, 10.1115/1.2911348 Yao, 1989, Impact spray boiling for thermal control of electronic systems, ASME HTD – Heat Transfer in Electronics, 111, 129 Mudawar, 1995, Comparison of two-phase electronic cooling using free jets and sprays, Advances in electronic packaging, vol. 2, 975 Fedder, 1997, Laminated high-aspect-ratio microstructures in a conventional CMOS process, Sensors & Actuators A, A57, 103, 10.1016/S0924-4247(97)80100-8 J. Murthy, C.H. Amon et al., Mems-based thermal management of electronics using spray impingement, InterPACK 2001, in: The Pacific Rim/ASME International Electronic Packaging Technical Conference and Exhibition, Kauai, Hawaii, IPACK 2001-15567, 2001, pp. 1–12 Amon, 2000, Thermal management of high-heat-flux devices EDIFICE: embedded droplet impingement for integrated cooling of electronics, vol. 1, 47 Wu, 2001, Break-up of liquid jets from irregular shaped silicon micro nozzles Wu, 2001, Fabrication of silicon sidewall profiles for fluidic applications using modified advanced silicon etching Leoni, 1997, Transient thermal design of wearable computers with embedded electronics using phase change materials, ASME HTD, 343, 49 Vesligaj, 1999, Transient thermal management of temperature fluctuations during time varying workloads on portable electronics, IEEE Transactions Comps. Pack. Technology, 22, 541, 10.1109/6144.814970 Alawadhi, 2000, Performance analysis of an enhanced PCM thermal control unit, ITherm, 1, 283 Leoni, 2000, Bayesian surrogates for integrating numerical, analytical and experimental data: application to inverse heat transfer in wearable computers, IEEE Transactions Comps. Pack. Technology, 23 Patera, 1984, A spectral element method for fluid dynamics: Laminar flow in a channel expansion, Journal of Computational Physics, 54, 468, 10.1016/0021-9991(84)90128-1 Amon, 1993, Spectral element – Fourier method for transitional flows in complex geometries, AIAA Journal, 31, 42, 10.2514/3.49002 Amon, 1995, Spectral element – Fourier method for unsteady conjugate heat transfer in complex geometry flows, AIAA Journal of Thermophysics and Heat Transfer, 9, 247, 10.2514/3.653 Narumanchi, 2000, Dielec-tric jet impingement cooling of electronic chips Nigen, 1995, Effect of material composition and localized heat generation on time-dependent conjugate heat transport, International Journal of Heat and Mass Transfer, 38, 1565, 10.1016/0017-9310(94)00292-4