Analysis of steel fibers pull-out. Experimental study

Giaccio, 1986, Concrete reinforced with collated steel fibers: influence of separation, ACI J., 83, 232 Banthia, 1991, Deformed steel fiber cementitious matrix bond under impact, Cem. Concr. Res., 21, 158, 10.1016/0008-8846(91)90042-G Lee, 2010, Pullout behavior of inclined steel fiber in an ultra-high strength cementitious matrix, Constr. Build. Mater., 24, 2030, 10.1016/j.conbuildmat.2010.03.009 Alwan, 1999, Effect of mechanical clamping on the pull-out response of hooked steel fibers embedded in cementitious matrices, Concr. Sci. Eng., 1, 15 Guerrero, 2000, Effect of mortar fineness and adhesive agents on pullout response of steel fibers, ACI Mater. J., 97, 12 Shannag, 1997, Pullout behavior of steel fibers from cement-based composites, Cem. Concr. Res., 27, 925, 10.1016/S0008-8846(97)00061-6 Markovich, 2001, Single fiber pullout from hybrid fiber reinforced concrete, HERON, 46, 191 V.M. Cunha, Steel fibre reinforced self-compacting concrete (Ph.D. thesis), University of Minho, Minho, 2010. Tuyan, 2012, Pull-out behavior of single steel fiber from SIFCON matrix, Constr. Build. Mater., 35, 571, 10.1016/j.conbuildmat.2012.04.110 Soetens, 2013, A semi-analytical model to predict the pull-out behaviour of inclined hooked-end steel fibres, Constr. Build. Mater., 43, 253, 10.1016/j.conbuildmat.2013.01.034 Leung, 1995, Effect of lateral stresses on fiber debonding/pull-out, Compos. Eng., 5, 1331, 10.1016/0961-9526(95)00064-T Robins, 2002, Pull-out behaviour of hooked steel fibres, Mater. Struct., 35, 434, 10.1007/BF02483148 Naaman, 1989 Bentur, 1996, Fiber-matrix interfaces, 149 Zile, 2013, Effect of the fiber geometry on the pullout response of mechanically deformed steel fibers, Cem. Concr. Res., 44, 18, 10.1016/j.cemconres.2012.10.014 Banthia, 1994, Concrete reinforced with deformed steel fibers, part I: bond-slip mechanisms, ACI Mater. J., 91, 435 Leung, 1999, Optimal steel fiber strength for reinforcement of cementitious Materials, J. Mater. Civ. Eng., 11, 116, 10.1061/(ASCE)0899-1561(1999)11:2(116) Naaman, 1991, Fiber pullout and bond slip II: experimental validation, ASCE – J. Struct. Eng., 117, 2791, 10.1061/(ASCE)0733-9445(1991)117:9(2791) Laranjeira, 2010, Predicting the pullout response of inclined hooked steel fibers, Cem. Concr. Res., 40, 1471, 10.1016/j.cemconres.2010.05.005 Kim, 2008, Loading rate effect on pullout behavior of deformed steel fibers, ACI Mater. J., 105, 576 Georgiadi-Stefanidi, 2010, Numerical modelling of the pull-out of hooked steel fibres from high-strength cementitious matrix, supplemented by experimental results, Constr. Build. Mater., 24, 2489, 10.1016/j.conbuildmat.2010.06.007 S. Sandbakk, Fibre Reinforced Concrete. Evaluation of test methods and materials development (Ph.D. thesis), Norwegian University of Science and Technology, Norwegian, Trondheim, 2011. Krishnadev, 1992, Deformed steel fiber pull-out mechanics: influence of steel properties, 390 Pinchin, 1978, Interfacial contact pressure and frictional stress transfer in steel fiber, 337